Mitel SX-200 DIGITAL Pabx General Description Manual

MITEL STANDARD PRACTICE SECTION MITL9108-093-l OO-NA 
Issue 2, September 1986 
SX-200” DIGITAL 
PRIVATE AUTOMATIC BRANCH EXCHANGE (PABX) 
GENERAL DESCRIPTION 
Copyright of MITEL Corporation 1986 
TM - Trademark of MITEL Corporation 
@Registered Trademark of MITEL Corporation  

General Description 
CONTENTS 
PAGE 
‘l.lNTRODUCTlON.. ................................. l-l 
General ......................................... 1-l 
ReasonforReissue ............................... 
l-l 
Section Overview 
................................. l-l 
System Configurations .............. :. ............. l-l 
Peripheral Devices 
................................ l-l 
CustomerDataEntry(CDE) ......................... 
l-2 
2. PHYSICAL DESCRIPTION 
. . . . . . . . . . . . s . . . . . . . 0.. . . . ....

General Description 
CONTENTS (CONT’D) PAGE 
RS-232 Terminal .................................. 8-l 
Diagnostic Log Piles ............................... 8-1 
Types of Diagnostics .............................. 8-l 
TABLE 
3-l 
3-2 
PlGlJRE 
2-l 
2-2 
2-3 
2-4 
2-6 
4-l 
4-2 
6-l 
6-2 LlST OF TABLES 
TITLE PAGE 
SX-200@ Environmental Requirements B D e . . D . n s 0 e D 3-l 
SX-200@ Electrical Requirements m D . D . m n 0 s a . 0 e s . a 3-l 
LIST OF ILLUSTRATIONS 
TITLE PAGE 
SX-200’ Attendant Console ....

General Description 
1. INTRODUCTION 
General 
1.01 This Section contains an overall description of the SX-200’ 
DIGITAL PABX using Generic 1000 or Generic 1001 software. 
Reason for Reissue 
1.02 This Section is reissued to provide a general description of the 
SX--ZOO@ DIGITAL PABX, with Generic 1000 or Generic 1001 
software, in either a 336-port or a 480-port configuration. 
Section Overview 
This Section is divided into seven parts as described below: 
Physical Description: The appearance and...

General Description 
- Trunks (Analog) 
- Electronic Telephone Sets (Refer to Section MITL9108-093- 
lO&NA, SUPERSET 3TM Set and to Section MITL9108-093- 
107-NA, SUPERSET qTM Set.) 
- SX-200@ LCD Attendant Console (Refer to Section MITL9108- 
093-34 5-NA, Attendant Console.) 
Customer Data Entry (CDE) 
1.06 Customer Data Entry is accomplished from the Maintenance 
Terminal, or alternatively, from the Attendant Console. The con- 
sole LCD guides the attendant through the .data entry procedure by...

General Description 
2. PHYSICAL DESCRIPTION 
General 
2.01 The SX-200@ DIGITAL PABX is available in two configurations, 
in a range of sizes from 144 ports to 480 ports, and supports a 
range of equipment, as described following. 
Attendant Console 
2.02 
The Attendant Console is illustrated in Figure 2-1 and measures 
39.4 cm (15.5 inches) long, 10.2 cm (4.0 inches) high, and 22.9 
cm (9.0 inches) deep. The Attendant Console consists of a handset, 44 
nonlocking pushbutton keys, seven LEDs and a Liquid...

General Description 
adding a 120-port shelf (Bay 3) above the Control shelf. 
Bay 1 contains: 1 Bay Power Supply and 8 Digital Peripheral cards. 
Bay 2 contains: 1 Main Control Card, 1 Bay Power Supply, 1 Floppy 
Disk Drive and 4 Digital Peripheral Cards. 
Bay 3 contains: 1 Peripheral Control Card, 1 Scanner card, 1 Digital 
Interface Card and 15 Peripheral cards. 
Universal Cabinet 
2.04 The Universal cabinet is similar to the existing Control cabinet. 
The major differences are: its maintenance panel...

General Description 
MAINTENANCE PANEL 
-PERIPHERAL SHELF 
CONTROL SHELF 
SHELF 
II III1 “iFI I 
REAR DooR POWER SUPPLY 
Figure 2-2 SX-200” DIGITAL PABX Control Cabinet 
Page 2-3  

General Description 
BAV 3 POWER SWITCH 
,1’ 
I , ,PERIPHERAL SHELF 
IIIllIII !I ,MAINTENANCE PANEL 
BAY 1 
BAY 2 
1 CONTROL SHELF 
POWEd SUPPLY 
KAOllZROE 
> 
Figure 2-3 SX-2QO@ DIGITAL PABX Universal Control Cabinet 
Page 2-4  

General Description 
Figure 2-4 SX-200@ DIGITAL PABX Universal Control Cabinet with Digital Peripheral Shelf 
Page 2-5