Lucent Technologies TransTalk9000 Digital Wireless System MDW 9031/9031DCP Wireless Pocket Phone Installation And Use Manual

Battery Charger 3  Using the MDW 9031/9031DCP
Pocket Phone
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
 503-801-166 — Issue 3 — October 1999
94 

95MDW 9031/9031DCP Wireless Pocket Phone Installation and Use503-801-166 — Issue 3 — October 1999   
4 Maintaining the MDW 9031/9031DCP
Pocket Phone
Important Safety Instructions
Please see “Important Safety Instructions” at the beginning of Chapter 2.
Removing Radio Module from Carrier
•Slot 6 of a Model 117A3 control carrier must always contain a radio module to 
pass the synchronization signal to the next carrier.
•See “Key Components” in Chapter 2 for additional picture detail.
To remove a radio...

Removing Radio Module from Carrier 4  Maintaining the MDW
9031/9031DCP Pocket Phone
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
 503-801-166 — Issue 3 — October 1999
96
2  Unplug the telephone line cord from the bottom of the radio module.
3  Press up and hold the snap lock on the bottom rear of the radio module.
4  Slowly swing the radio module’s card edge out of the card edge connector on the 
back of the carrier, releasing the snap lock when clear. Unhook the radio module 
from the...

Removing Radio Module from Carrier 
97
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166— Issue 3 — October 1999  
4  Maintaining the MDW
9031/9031DCP Pocket Phone
5  If you removed a radio module from Slot 6 of an 117A3 control carrier, you must 
insert another radio module into this slot. Failure to do so will cause the carriers 
to be unsynchronized.
6  Repower the carrier. If you have multiple carriers, repower them in order from 
left to right, as shown below:
7  Wait a few...

Swapping Extensions 4  Maintaining the MDW
9031/9031DCP Pocket Phone
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
 503-801-166 — Issue 3 — October 1999
98
Swapping Extensions
If you want to change your phone’s extension number assignment, make sure the radio module or carrier(s) is 
unplugged before you unplug the telephone line cord from the communications system switch/control unit. 
Power down and then repower the carrier(s) after all extension changes are made.
To swap extensions:
1...

Swapping Extensions 
99
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166— Issue 3 — October 1999  
4  Maintaining the MDW
9031/9031DCP Pocket Phone
4  Repower the carrier. If you have multiple carriers, repower them in order from 
left to right, as shown below:
5  Wait a few seconds, then verify that the carrier’s OUT OF SYNC LED is not lit. 
If the LED is lit, power down, wait at least 15 seconds, and then repower the 
carrier. If the LED is still lit, follow the suggestions in...

Replacing Antenna 4  Maintaining the MDW
9031/9031DCP Pocket Phone
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
 503-801-166 — Issue 3 — October 1999
100
Replacing Antenna
If the antenna on your MDW 9031/9031DCP Pocket Phone handset becomes damaged, you can order a 
replacement antenna (see “Ordering Replacement and Optional Parts” later in this chapter), and replace it 
yourself.
To replace the antenna: 
1  Fully retract the antenna.
2  Grasping the base of the antenna, unscrew it by...

Ordering Replacement and Optional Parts 
101
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
503-801-166— Issue 3 — October 1999  
4  Maintaining the MDW
9031/9031DCP Pocket Phone
Outside the continental U.S., contact your Lucent Technologies Representative or local Authorized Dealer.Lanyard NA 407183417
MDW 9031 Pocket Phone 
Leather Carrying Case32043A 847877487
MDW 9031 Pocket Phone 
Leather Carrying Case 
customized for headset use32090A 848026092
Battery Charger; includes Power Cord/AC...

Ordering Replacement and Optional Parts 4  Maintaining the MDW
9031/9031DCP Pocket Phone
MDW 9031/9031DCP Wireless Pocket Phone Installation and Use
 503-801-166 — Issue 3 — October 1999
102 

103MDW 9031/9031DCP Wireless Pocket Phone Installation and Use503-801-166 — Issue 3 — October 1999   
5 Troubleshooting
Procedures
If you have a problem with your MDW 9031/9031DCP Pocket Phone, you may be able to solve it by following 
the procedures included in this chapter. If you cannot resolve the problem, call Customer Support as described in 
the Copyright and Legal Notices at the beginning of this book.
The problems in this chapter are organized as follows:
•Installation
•Handset
•Battery
•Voice...