Lucent Technologies DEFINITY Enterprise Communication Server Release 8.2 Installation For Adjuncts And Peripherals Manual

ISDN Converters and Adapters 
129 Converters for Single-Carrier Cabinets 
10
DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals  555-233-116  Issue 1
April 2000
10
ISDN Converters and Adapters
This c hapter p rovid es information on c onverters and ad ap ters sometimes 
nec essary when c onnec ting  to c oaxial fac ilities in either a multic arrier c abinet or 
a sing le c arrier c ab inet. Connec tions inc lud e 
n
Integ ated  Servic es Data Network Primary Rate Interfac e (ISDN-PRI) to...

DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals  555-233-116  Issue 1
April 2000
ISDN Converters and Adapters 
130 Converters for Single-Carrier Cabinets 
10
Figure 39. Typical DASS or DPNSS converter Cabling
1. Plug  the DEFINITY ad ministration PC into the RS-232 c onnec tor on the 
front of the PRI c onverter c irc uit p ac k. 
2. Connec t the c oaxial Y-c ab le from the TN464F to the PRI c onverter c irc uit 
pack. 
3. Connec t the op p osite end  of the Y-c ab le to the 888B c...

DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals  555-233-116  Issue 1
April 2000
ISDN Converters and Adapters 
131 Converters for Multicarrier Cabinets 
10
Figure 40. Typical PRI to BRI Converter Cabling
NOTE:
The inset shows d etails of the c ab le c onnec tions b etween the c irc uit p ac ks. 
Connec t the DEFINITY ad ministration PC to the RS-232 c onnec tor on the 
front of the PRI c onverter c irc uit p ac k.
Converters for Multicarrier Cabinets
PRI to DASS and PRI to DPNSS...

DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals  555-233-116  Issue 1
April 2000
ISDN Converters and Adapters 
132 Converters for Multicarrier Cabinets 
10
Figure 41. Typical DASS or DPNSS Converter Cabling
PRI-to-BRI Converter
Fi g u re  4 2 shows typ ic al c onnec tions from the PRI-to-BRI c onverter to the c oaxial 
fac ility. The DEFINITY ad ministration PC is c onnec ted  to the RS-232 c onnec tor on 
the front of the PRI c onverter c irc uit p ac k.1. To TN464F DS1 c irc uit p ac...

DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals  555-233-116  Issue 1
April 2000
ISDN Converters and Adapters 
133 Converters for Multicarrier Cabinets 
10
Figure 42. Typical PRI to BRI Converter Cabling
NOTE:
The inset shows d etails of the c ab le c onnec tions b etween the c irc uit p ac ks. 1. TN464F DS1 c irc uit p ac k and  PR-to-BRI 
c onverter c irc uit p ac k
2. DEFINITY ad ministration PC
3. RS-232 c ab le to front of c onverter c irc uit 
pack
4. 888B 75-ohm c oaxial c...

DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals  555-233-116  Issue 1
April 2000
ISDN Converters and Adapters 
134 Converters for Multicarrier Cabinets 
10 

Stratum 3 Clock 
135 Set Clock Options 
11
DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals  555-233-116  Issue 1
April 2000
11
Stratum 3 Clock 
The Stratum 3 c loc k is an op tional feature for dig ital frame timing  that c oup les the 
c loc k outp ut to loc al c loc ks. This c hap ter p rovid e information on setting  the 
op tion switc hes on the c loc k. For installation information refer to the ap p rop riate 
installation or up g rad e b ook for your system.
Set Clock Options...

DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals  555-233-116  Issue 1
April 2000
Stratum 3 Clock 
136 Set Clock Options 
11
NOTE:
Only SW 1 and  SW2 are used . SW1 c ontrols the outp ut of alarm sig nals 
from the Stratum 3 Cloc k b oard .
3. Set the options on the Comp osite Cloc k Timing  Outp ut Board  (TOCA) p er 
Tab le 19
.
4. Set the Stratum 2/Stratum 3 switc h to the STRATUM 3 p osition.
NOTE:
Set switc hes 1 and 2 ac c ord ing  to the d istanc e from the Stratum 3 c loc k to...

DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals  555-233-116  Issue 1
April 2000
Stratum 3 Clock 
137 Set Clock Options 
11
Cloc k. A resistor b uilt into the c ab le to p rovid es the nec essary isolation b etween 
the system and  the c loc k. The Y-c ab le p lug s d irec tly into the CSU and  c onnec ts 
to stand ard  c ab les for interfac e to the system and the yellow field on the MDF.
The H600-307 c ab le c onnec ts the system end of the Y-c ab le to a DS1 c irc uit 
p ac k (shown...

DEFINITY ECS Release 8.2
Installation for Adjuncts and Peripherals  555-233-116  Issue 1
April 2000
Stratum 3 Clock 
138 Set Clock Options 
11
The H600-307 c ab le c onnec ts the system end of the Y-c ab le to a DS1 c irc uit 
p ac k (shown as TN464 or TN767E). The B25A c ab le c onnec ts the c loc k end  of 
the Y-c ab le to the yellow field  c ross-c onnec t.
Stratum 3 Clock Wiring Installation Procedure
1. Connec t the B25A c ab les from the TN780 c onnec tor panel slot on the 
system c ab inet and...