Home
>
Lucent Technologies
>
Communications System
>
Lucent Technologies Definity Application Notes For Type Approval Manual
Lucent Technologies Definity Application Notes For Type Approval Manual
Have a look at the manual Lucent Technologies Definity Application Notes For Type Approval Manual online for free. It’s possible to download the document as PDF or print. UserManuals.tech offer 413 Lucent Technologies manuals and user’s guides for free. Share the user manual or guide on Facebook, Twitter or Google+.
DEFINITY® Enterprise Communications Server Application Notes
for Type Approval Issue 1
June 1999
Application Notes for Type Approval
63 Bolivia
Page 2 of 10
TRUNK FEATURES
ACA Assignment? n Measured: none
Maintenance Tests? y
Data Restriction? n
Abandoned Call Search? n
Suppress # Outpulsing? n
Page 3 of 10
TRUNK GROUP
ADMINISTRABLE TIMERS
Incoming Disconnect(msec): 500 Outgoing Disconnect(msec): 500
Outgoing Dial Guard(msec): 1600
Incoming Glare Guard(msec): 1500 Outgoing Glare Guard(msec): 1500
Ringing Monitor(msec): 5200 Incoming Seizure(msec): 500
Outgoing End of Dial(sec): 10 Outgoing Seizure Response(sec): 5
Programmed Dial Pause(msec): 1500
Flash Length(msec): 540
END TO END SIGNALING
Tone(msec): 350 Pause(msec): 150
OUTPULSING INFORMATION
PPS: 10 Make(msec): 40 Break(msec): 60 PPM? n
Page 4 of 10
TRUNK GROUP
Administered Members (min/max): 0/0
Total Administered Members: 0
GROUP MEMBER ASSIGNMENTS
Port Code Sfx Name Night Mode Type Ans Delay
1:
2:
3:
DEFINITY® Enterprise Communications Server Application Notes
for Type Approval Issue 1
June 1999
Application Notes for Type Approval
64 Bolivia
DIOD Trunk Group Administration
Page 1 of 10
TRUNK GROUP
Group Number: Group Type: diod CDR Reports: y
Group Name: OUTSIDE CALL COR: 1 TN: 1 TAC:GG
Direction: two-way Outgoing Display? n
Dial Access? n Busy Threshold: 99
Queue Length: 0 Country: 1
Auth Code? n Digit Absorption List:
Prefix-1? n Trunk Flash? n Toll Restricted? n
TRUNK PARAMETERS
Trunk Type: immed-start
Outgoing Dial Type: mf Incoming Dial Type: mf
Trunk Termination: rc
Digit Treatment: Digits:
Expected Digits: Sig Bit Inversion: none
Terminal Balanced? n RA Trunk Loss: 0db
Trunk Gain: high Drop Treatment: silence
Disconnect Supervision - In? y Out? n
Answer Supervision Timeout: 10 Receive Answer Supervision? n
Page 2 of 20
TRUNK FEATURES
ACA Assignment? n Measured: none
Maintenance Tests? y
Data Restriction? n
Suppress # Outpulsing? n
DEFINITY® Enterprise Communications Server Application Notes
for Type Approval Issue 1
June 1999
Application Notes for Type Approval
65 Bolivia
Page 3 of 10
TRUNK GROUP
ADMINISTRABLE TIMERS
Incoming Disconnect(msec): 500 Outgoing Disconnect(msec): 500
Incoming Dial Guard(msec): 70 Outgoing Dial Guard(msec): 1600
Incoming Glare Guard(msec): 1500 Outgoing Glare Guard(msec): 1500
Ringing Monitor(msec): 5200 Incoming Seizure(msec): 500
Outgoing End of Dial(sec): 10 Outgoing Seizure Response(sec): 5
Programmed Dial Pause(msec): 1500
Flash Length(msec): Incoming Incomplete Dial Alarm(sec): 255
END TO END SIGNALING
Tone(msec): 350 Pause(msec): 150
OUTPULSING INFORMATION
PPS: 10 Make(msec): 40 Break(msec): 60 PPM? n
Page 4 of 10
TRUNK GROUP
Administered Members (min/max): 0/0
GROUP MEMBER ASSIGNMENTS Total Administered Members: 0
Port Code Sfx Name Night Mode Type Ans Delay
1:
2:
3:
DEFINITY® Enterprise Communications Server Application Notes
for Type Approval Issue 1
June 1999
Application Notes for Type Approval
66 Bolivia
DID Trunk Group Administration
Page 1 of 10
TRUNK GROUP
Group Number: Group Type: did CDR Reports: y
Group Name: OUTSIDE CALL COR: 1 TN: 1 TAC:
Country: 1
Auth Code? n
TRUNK PARAMETERS
Trunk Type: immed-start Incoming Rotary Timeout(sec): 5
Incoming Dial Type: tone
Trunk Termination: rc Disconnect Timing(msec): 500
Digit Treatment: Digits:
Expected Digits: Sig Bit Inversion: none
Terminal Balanced? n RA Trunk Loss: 0db
Extended Loop Range? n Trunk Gain: high Drop Treatment: silence
Disconnect Supervision - In? y
Page 2 of 10
TRUNK FEATURES
ACA Assignment? n Measured: none
Maintenance Tests? y
Data Restriction? n
Suppress # Outpulsing? n
Page 3 of 10
TRUNK GROUP
ADMINISTRABLE TIMERS
Incoming Disconnect(msec): 500
Incoming Dial Guard(msec): 70
Flash Length(msec): 540 Incoming Incomplete Dial Alarm(sec): 255
END TO END SIGNALING
Tone(msec): 350 Pause(msec): 150
DEFINITY® Enterprise Communications Server Application Notes
for Type Approval Issue 1
June 1999
Application Notes for Type Approval
67 Bolivia
DS1 for CO, DID and DIOD Trunks to the PTT
Using Digital Trunks
Page 4 of 10
TRUNK GROUP
Administered Members (min/max): 0/0
GROUP MEMBER ASSIGNMENTS Total Administered Members: 0
Port Code Sfx Name
1:
2:
3:
Page 1 of 1
DS1 CIRCUIT PACK
Location: Name: E-1CO, DID, DIOD
Bit Rate: 2.048 Line Coding: hdb3
Signaling Mode: CAS
Interconnect: CO Country Protocol: 7
Interface Companding: alaw CRC? n
Idle Code: 11111111
MAINTENANCE PARAMETERS
Slip Detection? n Near-end CSU Type: other
DEFINITY® Enterprise Communications Server Application Notes for Type Approval Issue 1 June 1999 Application Notes for Type Approval 68 Brazil Brazil Ta b l e 1 9 shows the rec ommended c irc uit p ac ks. Table 19. Recommended and Available CPs in Brazil Equipment Equipment Type Cab inet Typ e & Power GAC-MCC AC-MCC DC-MCC AC-SCC DC-SCC AC-CSCC AC-CMC AC Power Voltag e & Freq 127V/60Hz 220V/60Hz Ring Generator 25Hz Tone Detec tor > TN2182B > TN744D TN748D Tone Cloc k > TN2182B TN780 R2MFC Circ uit > TN744D TN744B Sp eec h Synthesizer > TN725B Call Classifier > TN744D Announc ement > TN750C TN750B Analog DID Trunk > TN753 Analog CO Trunk (No PPM) Analog CO Trunk (w/PPM) > TN465C TN465B 4 Wire Tie Trunk > TN2140B 2 Wire Tie Trunk > TN439 Auxiliary Trunk > TN763D Dig ital CO/DID Trunk > TN464F TN464E TN464D TN464C Dig ital Tie Trunk > TN464F TN464E TN464D TN464C Dig ital PRI CO Trunk > TN464F TN464E TN464D TN464C Dig ital BRI Trunk Dig ital Converter PRI-DASS Dig ital Converter PRI-DPNSS Dig ital Converter PRI-BRI 8 Port Analog Line n/a 16 Port Analog Line > TN746B 24 Port Analog Line n/a Continued on next page
DEFINITY® Enterprise Communications Server Application Notes for Type Approval Issue 1 June 1999 Application Notes for Type Approval 69 Brazil Country-Specific Feature When not using the Bloc k Collec t Call feature, the Country field should b e 16 . NOTE: Bloc k Collec t Call req uires TN753 v22 or later for DID trunks, TN464F v9 or later for DS1 trunks, and TN465C (all vintag es) for analog CO trunks. NOTE: The 900 ohms feature requires TN465CV2 or later for analog CO c irc uit p ac ks, and either TN2155V3 or later or TN2183BV4 or later for analog line circuit packs. Feature Administration The sc reen d isp lays shown in this sec tion were effec tive the d ate the typ e ap p roval was award ed . The sc reens may have c hang ed sinc e that d ate. Only those feature-related p arameters that may have a Typ e Ap p roval or b asic c onnec tivity imp lic ation for a p artic ular c ountry are listed here. nARS/AAR Ad ministration To enab le ARS administration, on the System-Parameters Customer-Op tions sc reen, set the ARS field to y . You also should check all ARS/AAR d efaults. All d efault ARS analysis c odes are deleted b efore d ialed strings are ad d ed for routing when DEFINITY is installed outsid e of North Americ a. Be aware that the d efault for the 10 d ig its c ause dialing p rob lems. In p artic ular, the following c all typ es (ap pear as ARS/AAR d efaults) typ ic ally are not used in non-North Americ an ARS/AAR tab les: 4 Wire Digital Line > TN754B 2 Wire Digital Line #TN2224 > TN2181 Data Line > TN726B BRI-U Line TN2198 BRI-ST Line TN556B Ta b l e 1 9 .Recommended and Available CPs in Brazil — Continued Equipment Equipment Type Continued on next page
DEFINITY® Enterprise Communications Server Application Notes
for Type Approval Issue 1
June 1999
Application Notes for Type Approval
70 Brazil
Luc ent rec ommend s only the following c all typ es b e used outside North
Americ a:
System Parameter Administration
Feature-Related System Parameters
fnp a: North Americ an numb ers with an area c od e.
hnp a: North Americ an numb ers without an area c od e.
svc : North Americ an numb ers of the screen ‘‘x11’’.
int: For all international numbers.
natl: For all national PN numb ers.
pubu: For all other external (that is, not extensions) numbers.
Page 1 of 6
FEATURE-RELATED SYSTEM PARAMETERS
Trunk-to-Trunk Transfer: all
Coverage - Subsequent Redirection No Answer Interval: 2
Coverage - Caller Response Interval (seconds): 4
Keep Held SBA at Coverage Point? y
Automatic Callback - No Answer Timeout Interval (rings): 3
Call Park Timeout Interval (minutes): 10
Off-Premises Tone Detect Timeout Interval (seconds): 20
AAR/ARS Dial Tone Required? y
Music/Tone on Hold: none
Music (or Silence) on Transferred Trunk Calls? no
DID/Tie/ISDN Intercept Treatment: attd
Internal Automatic Answer for Attendant Extended Calls? n
Automatic Circuit Assurance (ACA) Enabled? n
DEFINITY® Enterprise Communications Server Application Notes
for Type Approval Issue 1
June 1999
Application Notes for Type Approval
71 Brazil
Page 2 of 6
FEATURE-RELATED SYSTEM PARAMETERS
LEAVE WORD CALLING PARAMETERS
Maximum Number of Messages Per Station (when MSA not in service):10
Stations with System-wide Retrieval Permission (enter extension)
1: 2: 3: 4: 5:
6: 7: 8: 9: 10:
WARNING! SEE USER DOCUMENTATION BEFORE CHANGING TTI STATE
Terminal Translation Initialization (TTI) Enabled? n
External Coverage Treatment for Transferred Incoming Calls? n
SECURITY VIOLATION NOTIFICATION (SVN) PARAMETERS HAVE MOVED TO
THE SYSTEM-PARAMETERS SECURITY SCREEN
Page 3 of 6
FEATURE-RELATED SYSTEM PARAMETERS
Reserved Slots for Attendant Priority Queue: 5
Time before Off-hook Alert: 10
Emergency Access Redirection Extension:
Service Observing Warning Tone? y
Number of Emergency Calls Allowed in Attendant Queue: 5
Call Pickup Alerting? n
Deluxe Paging and Call Park Timeout to Originator? n
Controlled Outward Restriction Intercept Treatment: tone
Controlled Termination Restriction (Do Not Disturb): tone
Controlled Station to Station Restriction: tone
AUTHORIZATION CODE PARAMETERS Authorization Codes Enabled?
Authorization Code Length:
Authorization Code Cancellation Symbol: #
Attendant Time Out Flag? n
Display Authorization Code? y
DEFINITY® Enterprise Communications Server Application Notes
for Type Approval Issue 1
June 1999
Application Notes for Type Approval
72 Brazil
Page 4 of 6
FEATURE-RELATED SYSTEM PARAMETERS
SYSTEM PRINTER PARAMETERS
System Printer Extension: Lines Per Page: 60
SYSTEM-WIDE PARAMETERS
Switch Name:
CALL CENTER SYSTEM PARAMETERS
Direct Agent Announcement Extension:
Direct Agent Announcement Delay:
Converse Delay Data1: 0 Data2: 2
Direct Agent Announcement Extension: Converse Pulse ON: 100 OFF: 70
Prompting Timeout (secs): 10
CALL MANAGEMENT SYSTEM PARAMETERS
BCMS/VuStats Measurement Interval: hour
BCMS/VuStats Abandon Call Timer (seconds): Validate Login IDs? n
ACD Login Identification Length: Adjunct CMS Release:
MALICIOUS CALL TRACE PARAMETERS
Apply MCT Warning Tone? n MCT Voice Recorder Trunk Group:
Page 5 of 6
FEATURE-RELATED SYSTEM PARAMETERS
Public Network Trunks on Conference Call: 5 Auto Start? n
Conference Parties with Public Network Trunks: 6 Auto Hold? n
Conference Parties without Public Network Trunks: 6 Attendant Tone? y
Night Service Disconnect Timer (seconds): 180 Bridging Tone? n
Short Interdigit Timer (seconds): 3 Conference Tone? n
Unanswered DID Call Timer (seconds): Intrusion Tone? n
Line Intercept Tone Timer (seconds): 30
DID Busy Treatment: tone
Allow AAR/ARS Access from DID/DIOD? n
DISTINCTIVE AUDIBLE ALERTING
Internal: 1 External: 2 Priority: 3
Attendant Originated Calls: external