Land Rover Range Rover 2002my On Workshop Procedures Lm 6th Edition Nas Rover Manual

ENGINE - V8
12-2-118 OVERHAUL 

EMISSION CONTROL - V8
ADJUSTMENTS 17-2-1
EMISS ION CONTROL - V8 ADJUST ME NTS
Evaporative loss control system 
(EVAPS) - leak test - NAS
$% 17.90.02.01 
The following procedure allows a fuel leak, indicated 
by the Malfunction Indicator Lamp (MIL), to be 
accurately located. It must only be carried out once it 
has been established that there are no obvious faults 
with any of the system components. 
Check
1.Check components in fuel and EVAP system 
for obvious damage. Ensure all connections 
are...

EMISSION CONTROL - V8
17-2-2 ADJUSTMENTS 

EMISSION CONTROL - V8
REPAIRS 17-2-3
REPAIRS
Solenoid - canister purge 
$% 17.15.06 
Before disconnecting the battery, ensure all text and 
cautions in the battery disconnection section are 
observed. 
 
 +  GENERAL INFORMATION, Electrical 
Precautions.
Remove
1.Disconnect battery earth lead.
2.Disconnect multiplug from charcoal canister 
purge solenoid valve.
3.Disconnect 2 pipes from charcoal canister 
purge solenoid valve.
4.Remove charcoal canister purge solenoid valve 
from securing bracket.Refit...

EMISSION CONTROL - V8
17-2-4 REPAIRS
Charcoal canister 
$% 17.15.13 
Before disconnecting the battery, ensure all text and 
cautions in the battery disconnection section are 
observed. 
 
 +  GENERAL INFORMATION, Electrical 
Precautions.
Remove
1.Position vehicle on lift.
2.Disconnect battery earth lead.
3.Remove rear propeller shaft.
 
 +  DRIVESHAFTS, REPAIRS, Propeller 
shaft - rear.
4.Remove 8 bolts and 2 nuts securing RH fuel 
tank shield.
5.Disconnect 3 pipes from charcoal canister, 
remove 2 Torx...

EMISSION CONTROL - V8
REPAIRS 17-2-5
Valve - vacuum activation - secondary air 
injection (SAI)
$% 17.25.02 
This procedure is also applicable to the gasket.
Before disconnecting the battery, ensure all text and 
cautions in the battery disconnection section are 
observed. 
 
 +  GENERAL INFORMATION, Electrical 
Precautions.
Remove
1.Position vehicle on lift.
2.Disconnect battery earth lead.
3.Remove air intake hose.
 
 +  ENGINE MANAGEMENT SYSTEM - 
V8, REPAIRS, Hose - air flow meter to 
throttle body....

EMISSION CONTROL - V8
17-2-6 REPAIRS
Relay - secondary air injection pump 
(SAI)
$% 17.25.06 
Before disconnecting the battery, ensure all text and 
cautions in the battery disconnection section are 
observed. 
 
 +  GENERAL INFORMATION, Electrical 
Precautions.
Remove
1.Disconnect battery earth lead.
2.Remove 10 Allen screws securing E box cover 
and remove cover.
3.Release SAI relay from E box and disconnect 
multiplug.
Refit
1.Position SAI relay, connect multiplug and fit 
relay to E box.
2.Fit E box...

EMISSION CONTROL - V8
REPAIRS 17-2-7
7.Remove screw securing RH front wheel arch 
liner to wing.
8.Release front valance panel from front bumper 
and position aside for access.
9.Disconnect multiplug from SAI pump, remove 
bolt securing SAI pump and remove SAI pump.Refit
1.Fit SAI pump and loosely fit lower securing bolt.
2.Fit SAI pump upper securing bolts and tighten 
to 22 Nm (16 lbf.ft).
3.Tighten SAI pump lower securing bolt to 5 Nm 
(4 lbf.ft).
4.Connect multiplug to SAI pump.
5.Align front valance...

EMISSION CONTROL - V8
17-2-8 REPAIRS
Module - Tank Leakage Diagnostic 
(DMTL) 
$% 17.45.41
Remove
1.Disconnect battery earth lead.
2.Remove RH rear wheel arch liner.
 
 +  EXTERIOR FITTINGS, REPAIRS, 
Liner - rear wheel arch - single.
3.Disconnect multiplug from DMTL.
4.Remove bolt securing DMTL to body and 
release from clips.
5.Position DMTL beneath fuel tank filler neck for 
access. Remove and discard clip securing vent 
pipe to DMTL.
CAUTION: Before disconnecting any part of 
the fuel system, it is...

EMISSION CONTROL - V8
REPAIRS 17-2-9
Catalytic converter 
$% 17.50.01 
Before disconnecting the battery, ensure all text and 
cautions in the battery disconnection section are 
observed. 
 
 +  GENERAL INFORMATION, Electrical 
Precautions.
Remove
1.Position vehicle on lift.
2.Disconnect battery earth lead.
3.Remove exhaust system.
 
 +  MANIFOLD AND EXHAUST SYSTEM 
- V8, REPAIRS, Exhaust system & 
mountings.
4.Remove HO2S sensors from exhaust 
assembly and discard sealing washers.
5.Using LRT-99-027, cut...