Konica Minolta bizhub C35P User Manual

							Media Types 6-12
Use special paper that is
„Approved for laser printers
DO NOT use special paper that is
„Not approved for use as plain paper
Downloaded From ManualsPrinter.com Manuals 
						

							Media Types6-13 Printable Area
The printable area on all media sizes is 
up to 4.2 mm (0.165) from the edges 
of the media.
Each media size has a specific image-
able area, the maximum area on which 
the printer can print clearly and without 
distortion. 
This area is subject to both hardware 
limits (the physical media size and the 
margins required by the printer) and 
software constraints (the amount of 
memory available for the full-page frame buffer). The guaranteed imageable 
(printable) area for all media sizes is the page size minus 4.2 mm (0.165) 
from all edges of the media.a
a
a
a
Printable
Area
a = 4.2 mm (0.165)
Downloaded From ManualsPrinter.com Manuals 
						

							Media Types 6-14
Envelopes
Envelopes can only be printed on their front sides (side where the recipient’s 
address is written). In addition, printing on the front side in the area overlap-
ping the back flap cannot be guaranteed. The location of this area differs 
depending on the envelope type.
The envelope print orientation is determined by your application.
Page Margins
Margins are set through your application. Some applications allow you to set 
custom page sizes and margins while others have only standard page sizes 
and margins from which to choose. If you choose a standard format, you may 
lose part of your image (due to imageable area constraints). If you can cus-
tom-size your page in your application, use those sizes given for the imagea-
ble area for optimum results.
a=4.2 mm (0.165)
Non-printable area
Non-guaranteed printable area
Guaranteed printable area
Front side
(can be printed)Back side
(cannot be printed) aa
a
a
Downloaded From ManualsPrinter.com Manuals 
						

							Loading Media6-15
Loading Media 
How do I load media?
Note
Do not mix media of different types and sizes, as this will cause media 
misfeeds or machine trouble
Note
Paper edges are sharp and may cause injuries.
When refilling media, first remove any media remaining in the tray. Stack it 
with the new media, even the edges, then reload it. 
Tray 1 (Manual Feed Tray)
For details on the types and sizes of media that can be printed from Tray 1, 
refer to “Media Specifications” on page 6-2.
Loading Plain Paper, Single Side Only and Special Paper
1Open Tray 1.
Downloaded From ManualsPrinter.com Manuals 
						

							Loading Media 6-16
2Slide the media guides to pro-
vide more space between them.
3Press down on the center of the 
paper-lifting plate until the left 
and right locking tabs (white) 
lock into place.
4Load the paper face down in the 
tray.
Downloaded From ManualsPrinter.com Manuals 
						

							Loading Media6-17
Do not load so much 
paper that the top of the 
stack is higher than the 
maximum limit guide. Up 
to 100 sheets (80 g/m
2 
[22 lb]) of plain paper can 
be loaded into the tray at 
one time.
5Slide the media guides against 
the edges of the paper.
6Select PAPER MENU/PAPER SOURCE/TRAY 1/PAPER SIZE and 
PAPER TYPE in the configuration menu, and then select the setting for 
the size and type of paper that are loaded. See also “PAPER MENU” on 
page 4-12.
Other Media
When loading media other than plain paper, set the media mode (Envelope, 
Label, Thick 1, Thick 2, Glossy 1, Glossy 2, or Postcards) in the driver for 
optimum print quality.
Downloaded From ManualsPrinter.com Manuals 
						

							Loading Media 6-18
Loading Envelopes
1Open Tray 1.
2Slide the media guides to pro-
vide more space between them.
3Press down on the center of the 
paper-lifting plate until the left 
and right locking tabs (white) 
lock into place.
Downloaded From ManualsPrinter.com Manuals 
						

							Loading Media6-19
4Load the envelopes flap side up 
in the tray. 
Before loading enve-
lopes, press them down 
to make sure that all air is 
removed, and make sure 
that the folds of the flaps 
are firmly pressed; other-
wise the envelopes may 
become wrinkled or a 
media misfeed may 
occur.
Up to 10 envelopes can be loaded into the tray at one time.
For envelopes with the 
flap along the long edge 
(Envelope C6, Envelope 
Monarch, and Envelope 
DL), load the envelopes 
with the flap side up.
5Slide the media guides against 
the edges of the envelopes.
Downloaded From ManualsPrinter.com Manuals 
						

							Loading Media 6-20
6Select PAPER MENU/PAPER SOURCE/TRAY 1/PAPER SIZE and 
PAPER TYPE in the configuration menu, and then select the setting for 
the size and type of media that is loaded. See also “PAPER MENU” on 
page 4-12.
Loading Label Sheets/Postcards/Thick Stock and Glossy 
Media
1Open Tray 1.
2Slide the media guides to pro-
vide more space between them.
Downloaded From ManualsPrinter.com Manuals 
						

							Loading Media6-21
3Press down on the center of the 
paper-lifting plate until the left 
and right locking tabs (white) 
lock into place.
4Load the media face down in the 
tray.
Up to 20 sheets can be 
loaded into the tray at 
one time.
5Slide the media guides against 
the edges of the media.
6Select PAPER MENU/PAPER SOURCE/TRAY 1/PAPER SIZE and 
PAPER TYPE in the configuration menu, and then select the setting for 
the size and type of media that is loaded. See also “PAPER MENU” on 
page 4-12.
Downloaded From ManualsPrinter.com Manuals