Home > Inter-Tel > Communications System > Inter-Tel Ivx 500 Installation Manual

Inter-Tel Ivx 500 Installation Manual

Here you can view all the pages of manual Inter-Tel Ivx 500 Installation Manual. The Inter-Tel manuals for Communications System are available online for free. You can easily download all the documents as PDF.

Page 21

SPECIFICATIONS 2% INSTACLATION INTER-TEL PRACTICES 
Issue 1, August 1994 IVX500 INSTALLATION 81 MAINTENANCE 
FIGURE l-7. FOUR-PORT VOICE PROCESSING CARD (VPC) .‘-:>\, 
3 
/’ 
DB15 
CONNECTOR ADDRESS SELECTION 
JUMPER STRAPS 
MODULAR JACKS 
Page 
1-14  

Page 22

INTER-m PRACTICES 
II%500 INSTAUATION & MAINTENANCE SPECIFICATIONS & INSTALLATION 
Issue 1, August 1994 
FIGURE l-8. TWO-PORT VOICE PROCESSING CARD (WC) 
DB15 CONNECTOR ADDRESS SELECTION 
JUMPER STRAPS 
MODULAR JACK 
Page l-15  

Page 23

SPECIFICATIONS & INSTALLATION INTER-TEL PRACTICES 
Issue 1, August 1994 IVX500 INSTALLATION & MAINTENANCE 
FIGURE l-9. SERIAL/PARALLEL PORT COMBINATION CARD @PC) :i 
;.y 
‘ 
‘ 
. 
 
 
. 
,  
DB15 CONNECTOR 
NOT CURRENTLY USED 
DB25 CONNECTOR 
TO PARALLEL PRINTER FOR 
APPLICATIONS REPORTS 
CONNECTOR 
TO DIAGNOSTICS TERMINAL 
DB25 (COM2) CONNECTOR 
TO PROGRAMMING PC 
NOTE: Depending on the model of SPC being used, the location of the connectors and cables shown 
above could vary somewhat. Also, instead of...

Page 24

INTER-TEL PRACTICES 
IVX500 INSTALLATION & MAINTENANCE SPECIFICATIONS & INSTALLATION Issue 1. Aturnst 1994 
c. SOFTWARE INSTALLATION 
6.8 The IVX500 PC is shipped with the applications 
software already installed on the hard disk drive. As a 
back-up, 3J$-inch floppy disks containing the software 
are also included. If the software is upgraded at a later 
time, a new set of software disks will be provided. 
NOTE: To install the database programming software 
on the customer-provided programming PC, refer...

Page 25

SPECIFICATIONS & INSTALLATION 
INTER-TEL PRACTICES 
Issue 1, August 1994 
IVX500 INSTALLATION & MAINTENANCE 
(5) 
(6) 
(9 Insert Applications Software Disk 2 of 4 in the 
floppy disk drive and reboot the PC. (The termi- 
nal displays “Delaying for 5 seconds. press any 
key to abort.“) 
Before the five seconds expire, press ENTER (or 
any key on the keyboard) to abort. (The terminal 
displays the lVX500 applications directory 
prompt “C:\avdap>“.) (10) 
(II) 
Remove Applications Software Disk 2 of 4 and...

Page 26

INTER-TELPR4cTIcES 
IVX500 INSlXLLATION & MAINTENANCE SPECIFICATIONS % INSTALLATION 
Issue 1, August 1994 
7. IVXSOO PC HARD DISK DRIVE B. CHECKING THE PC MOTHERBOARD 
REPLACEMENT SETUP 
7.1 
If necessary, the hard disk drive in the IVX500 PC 
can be replaced with a new drive as outlined below. The 
instructions are divided into four sections. Follow the 
steps outlined in each section. 7.4 Check to see that the IVX500 PC motherboard is 
“set up” to work properly with the new hard disk drive, 
as...

Page 27

SPECIFICATIONS & INSTWTION 
Issue 1, August 1994 lNTER-TELPR4CTIcES 
IVX500 INSTALLATION & MAINTENANCE 
(9 
(10) 
(11) 
(12) 
ENTER twice. (The monitor displays the Stan- 
dard CMOS Setup screen, a portion of which is 
shown below.) 
Date @n/date/year)* xx/xx/xx 
Time (hour/min/sec): xx:xx:xx 
Hard Disk CI Type 
I xx Bard Disk D: Type : Not Installed 
Floppy Drive A: I 1.44nB, 3.5 
Floppy Drive BI I Not Installed 
Primary Display I Not Installed 
Keyboard 
: Not Installed 
& 
After setting the correct...

Page 28

INTER-TEL PRACTICES 
SPECIFICATIONS & INSTALLATION 
IVXSOO INSTALLATION & MAINTENANCE 
Issue 1, August 1994 
(13) 
(14) 
(15) 
(16) 
(17) 
Ensure that all of the fields are set similar to 
those shown in the preceding samples. 
If not, use 
the 
up or down arrow keys to highlight the de- 
sired field, then use the PG Up or PG DN keys to 
change the setting. 
press the ESC key to exit. (The monitor again 
displays the main menu of options.) 
Use the up or down arrow keys to highlight the 
ADVANCED CHIpSET...

Page 29

SPECIFICATIONS & INSTALIXITON 
INTER-TEL PRACTICES 
Issue 1, August 1994 
JYXSOO INSTALLATION & MAINTENANCE 
(6) 
8 
(8) 
If there are any other drives to format, repeat 
steps 3 through 5 using the appropriate “format 
drive:” command (e.g., “format d:“). 
At the AZ:\> prompt (and with the 
MS-DOS 6.2 
Setup Disk still in the floppy disk drive), press 
the CTRL,, ALT, and DEL keys all at the same 
time to restart the system. 
Follow the instructions displayed on the monitor 
to set up and install...

Page 30

INTER-TEL PRACTICES FEATURES 
IVX500 INS’IXLLATION % MAINTENANCE Issue 1, August 1994 
CONTENTS PAGE 
FEATURES 
1. 
2. 
3. 
4. 
5. Introduction 
........................................................ 2-2 
Automated Attendant ................................................ 2-3 
A. Automated Attendant Applications ............................. ../. 2-3 
B. Automated Attendant Recall Destination ............................ 2-4 
C. Automated Attendant Custom Recordings ........................... 2-4 
D....
Start reading Inter-Tel Ivx 500 Installation Manual

Related Manuals for Inter-Tel Ivx 500 Installation Manual

All Inter-Tel manuals