Inter-Tel Ivx 500 Installation Manual

SPECIFICATIONS & INSTALLATION 
INTER-TEL PRACTICES 
Issue 1, August 1994 
IYX500 INSTALLATION & MAINTENANCE 
G. OPTIONALPRINTER 
4.11 An 
optional, customer-provided parallel printer 
can be installed to print various reports. 
H. OPTIONAL MODEM 
4.12 An optional, customer-provided external modem 
can be installed for remote database programming and 
maintenance/diagnostics. (Refer to page 3-10 in 
PRO- 
GRAMMING 
for additional information on remote sys- 
tem access.) 
5. 
PROGRAMING PC 
SPECIFICATIONS...

INTER-TEL PRACTICES 
IVXSOO INSTALLATION 8z MAINTENANCE SPECIFICATIONS & INSTALLATION 
Issue 1, August 1994 
6. IVXSOO PC INSTALLATION 
6.1 This section describes the recommended proce- 
dures for installing the lVX500 System. 
NOTICE 
This 
Inter-Tel AZ500 Installation andFieldiUain- 
tenance Manual 
instructs certified field technicians 
on the proper installation practices for the Inter-Tel 
lVX500 System. This manual doesnot provide step 
by-step instructions for premises wiring practices as...

SPECIFICATIONS % lNSTA.LLATION 
Issue 1, August 1994 INTER-TEL PRACTICES 
IVXSOO INS’MLLATION & MAINTENANCE 
B. HARDWARE INSTALLATION 
b. 
NOTICE 
Personal computer (PC) technology is continually 
evolving. As it does, the Inter-Tel IVX500 PC will 
continue to incorporate important design enhance- 
ments. Thus, depending on the actual version of 
equipment that is shipped, the following installa- 
tion instructions could vary somewhat. If revised 
instructions are included with the equipment, refer 
to...

INTER-TELPRACTICES 
IVX500 INSTALLATION & MAINTENANCE SPECIFICATIONS & INSTALLATION Issue 1, August 1994 
1ST VPC 
2ND VPC sRD VPC 4TH WC 
(300f-Q 
(a HDQ 
(310 HDQ (318 HEXJ 
w2 w2 
w2 w2 
0m 
m 
m m 
1m 
lczl 
m m 
20 
m li m 
3m 0 
l a l l 
4m 
m l l l l 6_ 
n I33 a 
em 
EEI is3 n 
7D 
m mzl laa 
8 l l 
l l l l l l 
0 l l l l l l l l 
c. Insert the VPC in the appropriate slot and, if 
possible, attach it to the chassis using the 
screw removed 
in step 5a. Make sure the card 
is securely attached to...

SPECIFICATIONS & INSTWTION 
INTER-TEL PRACTICES 
Issue 1, August 1994 
IVXSOO INSTALLATION Br MAINTENANCE 
FIGURE l-l. 
IVX500 PC AND TELEPHONE SYSTEM INTERFACE 
-  
i 
TO TELEPHONE 
SYSTEM SINGLE- 
LINE CARD 
66hWW-TYPE 
BLOCK 
(PART OF MDF) 
- 
- 
- 
- 
- - 
MODULAR o/w RINQ JACK 
W~BL nt= I I ASSEMBLY 
TOPC 
PORTS 
l&2 
BL/w RING 
WDI-IQ 
I 
r’ 1.3 
om RING 
Jr 
WBL TlQ 
1 1.4 - 
I 
r 
TOPC 
PORTS 
384 
NOTE: Each modular jack assembly, as wired above, is connected to the IVX500 PC using a two- 
pair,...

INTER-TEL PRACTICES 
WX500 INSTALLATION & MAINTENANCE SPECIFICATIONS & INSTALLATION 
Issue 1, August 1994 
FIGURE l-2. 
BACK OF ASSEMBLED IVX500 PC (SAMPLE #l) 
ON/OFF POWER POWER CABLE SAMPLE CARD SLOT 
SWITCH 
CONNECTOR ARRANGEMENT 
 / 
NOTE: Depending on the model of PC being used, the sample card slot arrangement and connector loca- 
tions shown above could vary somewhat. See Figure l-3 on the next page for another sample. 
Page l-9  

SPECIFICATIONS & INSTALLATION INTER-TEL PRACTICES 
Issue 1, August 1994 IVX500 INSTALLATION & MAINTENANCE 
FIGURE l-3. BACK OF ASSEMBLED IVXSOO PC (SAMPLE #2) 
POWER CABLE 
CONNECTOR SAMPLE CARD SLOT 
ARRANGEMENT 
 
..:.::::::., 
cl .~~~~~~.>:::: ::::::::::::c. “$b” 
NOTE: Depending on the model of PC being used, the sample card slot arrangement and connector loca- 
tions shown above could vary somewhat. See Figure 1-2 on the previous page for another sample. 
Page l-10  

INTER-TEL PRACTICES 
IVX500 INSTALLATION & MAINTENANCE SPECIFICATIONS & INSTALLATION 
Issue 1. Awust 1994 
FIGURE l-4. 
PC MOTHERBOARD CARD SLOT ARRANGEMENT (SAMPLE #l) 
c 
_ 2-PIN CONNECTOR 
TO RESET CONNECTOR 
ON AIC 
AUDIO INTERFACE 
CARD (AIC) 
4TH VPC 
3RD VPC 
2ND VPC 
IST VOICE PROCESS- 
ING CARD (VPC) 
DISK CONTROLLER 
CARD 
SERIAUPARALLEL 
PnRT CNMRn CARD 
NOTE: Depending on the model of PC Motherboard being used, the sample card slot arrangement and 
the location of the reset connector shown...

SPECIFICATIONS & INSTALLATION INTER-TELPRACTICES 
Issue 1, August 1994 IVX500 INSTALLAnON & MAINTENANCE 
FIGURE 1-5. PC MOTHERBOAFtD CARD SLOT ARRANGEMENT (SAMPLE #2) * 
., 
1’ 
_ 2-PIN CONNECTOR 
TO RESET CONNECTOR 
ON AIC 
- DO NOT USE 
AUDIO INTERFACE 
CARD (AIC) 
4TH VPC 
3RD VPC 
2ND VPC 
1ST VOICE PROCESS- 
ING CARD o/PC) 
DISK CONTROLLER 
COMBO CARD 
NOTE: Depending on the model of PC Motherboard being used, the sample card slot arrangement and 
the location of the reset connector shown above...

INTER-TEL PRACTICES 
IVX500 INSTALLATION 8z MAINTENANCE SPECIFICATIONS & INSTALLATION 
Issue 1, August 1994 
FIGURE l-6. 
AUDIO INTERFACE CARD (AK) 
.- 2-PIN CONNECTOR 
TO RESET SWlTCH 
2-PIN CONNECTOR 
TO RESET CONNECTOR 
ON MOTHERBOARD 
+ PIN 1 - JUMPER STRAP 
- 40-PIN CONNECTOR 
NOT USED 
- JUMPER STRAPS 
DIP SWITCHES 
DB15 PCM CONNECTOR 
NOT USED 
DB15 PCM CONNECTOR 
NOT USED 
Page 1-13