Inter-Tel Imx/Gmx 416/832 Installation Manual

INTER-TELPRACTICES REPLACEMENT PARTS 
IMX/GMX 416/832 INSJXLLATION % MAINTENANCE Issue 1, November 1994 
FIGURE 7-2. 
RECOMMENDED SPARE PARTS (CONT’D) 
Digital Keyset PC Data Port Module ...................... 2 
........ 550.3014 
Digital Keyset Modem Data Port Module 
.................. 
2 ........ 550.3015 
Digital Keyset LCD Kit (for non-display Standard Keysets) 
.... 5 ........ 828.1211 
AC Transformer (for PCDPMs, MDPMs, & DSS/BLF Units) 
... 3 ........ 806.1045 
IMK 24-Line Standard Keyset I...

lNTER-TELPBACTIcES 
APPENDIX A - GX S’MI’ION INSTRUMENTS 
IMX/GMX 416/832 INSEALLATION & MAINTENANCE Issue 1, November 1994 
APPENDIX A- GX STATION INSTRUMENTS 
CONTENTS PAGE 
1. Overview ............................................................ 
A-l 
2. Specifications 
......................................................... A-l 
. Keysets .......................................................... A-l 
B. Direct Station Selection/Busy Lamp Field @SS/BLF) Units .............. A-2 
C. Single-Line...

APPENJMX A- GX STATION INSTRUMENTS INTER-TELPRACTICES 
Issue 1, November 1994 IMX/GMX 416/832 INSTILLATION & MAINTENANCE 
NOTE: Do not connect an external signaling device 
directly to the keyset without using an LEA. 
Optional Speakerphone Module or External Desk 
Speaker 
2.5 GX keysets have a built-in speaker and micro- 
phone that allow the user to answer intercom calls 
“handsfiee,” dial while on hook, monitor calls, and lis- 
ten to background music. For handsfree conversation on 
outside calls, GX...

INTER-TELPRACTICES 
IMX/GMX 416/832  INSTALLATION  % MAINTENANCE APPENDIX A -  GX  STATION  INSTRUMENTS Issue 1, November  1994 
FIGURE A-l. 
GX 24-LINE  KEYSET 
HEARING  AID-COMPATIBLE OPTIONAL 
(HAC)  HANDSET 
4 CALL  KEYS 
SP-CHARACTER  LCD 
INTERNAL  SPEAKER 
 
8  STATION 
PRO- 
GRAMMABLE  KEYS  (5-12) 
/ 
/ 
12  UNDEFINED 
KEYS  (13-24) 
1 
mm 
mm 
10 SPEED-DIAL 
KEYS 
/  
 
RING  AND VOICE 
VOLUME 
CONTROLS 
(underneath  edge) 
/ 
HANDSFREE  18 
FEATURE  12-KEY PUSHBUTTON 
KEYS  KEYPAD 
MICROPHONE...

APPENDIX A - GX STATION INSTR- 
INTER-TELPRACTICES 
Issue 1, November 1994 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE 
3. INSTALIATION 
3.1 The installation instructions in this appendix con- 
tain 
information that differs from or is not covered in the 
rest of the manual. For complete installation informa- 
tion, use this appendix in conjunction with the INSTAL- 
LATION section of the manual. 
3.2 When performing the loop resistance test (see 
page 3-30), use the following loop limit values for GX...

INTER-TELPRACTICES 
JMX/GMX 416b332 INSTALLATION % MAINTENANCE APPENDIX A-GX STATION INSTRUMENTS 
Issue 1, November 1994 
FIGURE A-2. GX KEYSET BOTTOM 
 I 
RING PITCH 
- SELECTION 
DIP SWITCHES 
_ SPEAKERPHONE 
ENABLE STRAP 
MICROPHONE 
- GAIN 
ADJUSTMENT 
THUMBWHEEL 
__ 
._ 
._ 
_- 
pv v v WV v v 
0.0 0.1 
0.0 
0.2 
._ 
-_ 
NOTE: There are two possible types of strap arrangements. Depending on the pin configuration of the keyset, 
use one of the strap settings shown above. 
Page A-S  

APPENDIX A- GX STATION INSTRUMENTS INTER-TELPRACTICES 
Issue 1, November 1994 IMX/GMX 416/?332 INSTALLATION & MAINTENANCE 
Liquid Crystal Display (LCD) Installation 
3.6 
To convert a standard GX keyset to a display key- 
set, install an LCD Kit (Part no. 828.1052) as follows: 
(1) 
(2) 
(3) 
(4) 
(5) 
(6) 
(7) 
(8) 
(9) Unpack the LCD Kit. There should be a clear 
plastic display window, an LCD unit, a ribbon 
cable, and two small Phillips-head screws. 
Remove the keyset baseplate by pressing on the...

INTER-TELPRACTICES 
APPENDIX A- GX STATION INSTRUMENTS 
IMX/GMX 416/832 INSTALLATION % MAINTENANCE Issue 1, November 1994 
External Desk Speaker Installation 
3.8 
To attach an external &ohm desk speaker to a GX 
keyset for handsfiee operation on outside calls, perform 
these steps: 
(1) 
(2) 
(3) 
(4 
Remove the baseplate and disconnect the keyset 
line cord. 
Remove the modular shorting plug from the 
SPKR jack on the base of the keyset. 
Connect the modular plug on the end of the ex- 
ternal speaker...

APPENDIX A - GX STATION INSTBUMENTS INTEB-TELPRACTICES 
Issue 1, November 1994 
IMX/GMX 416/832 INSTALLATION & MAINTENANCE 
3.10 
To connect two GX DSS/BLF Units together to 
create one tandem unit, perform these steps: 
(1) With the baseplate removed, locate the four DIP 
switches on the bottom of each unit (see Figure 
A-3 on the next page). 
NOTE: Most DSS/BLF Units have a cutout in 
the bottom cover so that the DIP switches can be 
reached without having to take the unit apart. 
With other units, the...

INTER-TELPRACTICES APPENDIXA-GX STATION INSTRIJMENT# lMX/GMX 416/832 INSTALLATION & MAINTENANCE Issue 1, November 1994 
FIGURE A-3. GX DSS/BLF UNIT BO’ITOM 
.:.:,::::::::::: 
cl ~;gJ~,:~$; .:.L:.~.:.:. 
::::::.:.:.:.:.: 
:.:.~.:.:.:.:.:. 
DSS CONFIGURATION 
SWITCH 
$ y,:; 
i.3 w 
.:m.. 
%__, 
 
8 
NOTE: On most DSS/BLF Units, the DIP switches can be reached through the cutout in the bottom cover 
(as shown above). With other units, the four screws on the bottom must be removed and the bottom cover 
must...