Inter-Tel Encore Installation, Programming And Maintenance Version 4 Manual

Page 2-21
Installation
ENCORE MANUAL, Issue 4.0 – July 2002
Expansion Card Connections — Cable B
INSTALLATION
2
FIGURE 4.Expansion Card Connections — Cable B
Table 2-3: Expansion Card Connections - Cable B
CABLE PAIRCONNECTIONDEVICE
W-BL VOICE-A
Ext 26
BL-W VOICE-B
W-O DATA-C
O-W DATA-D
W-G VOICE-A
Ext 27
G-W VOICE-B
W-BR DATA-C
BR-W DATA-D
W-S VOICE-A
Ext 28
S-W VOICE-B
R-BL DATA-C
BL-R DATA-D
R-O VOICE-A
Ext 29
O-R VOICE-B
R-G DATA-C
G-R DATA-D
R-BR VOICE-A
Ext 30
BR-R VOICE-B
R-S DATA-C
S-R DATA-D...

Page 2-22
Installation
ENCORE MANUAL, Issue 4.0 – July 2002
Expansion Card Connections — Cable B CO Line Connections
5.29The first A and B pair on each Line Card is used to terminate one line and the second C
and D pair is used to terminate a second line. Refer to the chart on page 2-20 for wiring con-
nections.
5.30CO lines 1 to 4 are terminated in the CPU connectors, as shown below. The cables for
these connections are routed into the KSU through the breakout panel at the bottom.
5.31CO lines 5 to 8...

Page 2-23
Installation
ENCORE MANUAL, Issue 4.0 – July 2002
Expansion Card Connections — Cable B
INSTALLATION
2
Extension Connections
5.32Extensions 20 to 25 are terminated on the CPU, as shown below. Note that extensions
are numbered from the bottom up. Refer to the charts on pages 20 and 21 for wiring connec-
tions. The cables for these connections are routed into the KSU through the breakout panel at
the bottom.
5.33Extensions 26 to 37 are terminated on the Extension Cards, as shown below. The cables...

Page 2-24
Installation
ENCORE MANUAL, Issue 4.0 – July 2002
Keysets
6. KEYSETS
6.1The system has capacity for up to 18 extensions. Extensions can be equipped with
Encore Keysets or industry-standard single-line sets. 
A. KEYSET DESIGN FEATURES
Integrated Speakerphone
6.2A built-in, integrated speakerphone is standard in the Keysets. It allows users to place
and receive internal calls without lifting the handset. Once a call is connected, the Keyset user
may speak handsfree over the speakerphone or lift...

Page 2-25
Installation
ENCORE MANUAL, Issue 4.0 – July 2002
Attaching the Keyset Baseplate
INSTALLATION
2
C. ATTACHING THE KEYSET BASEPLATE
6.7There are retaining clips on the baseplate that allow it to be attached to the keyset at two
different angles. When the correct viewing angle has been selected, clip the baseplate onto
either the lower or upper slot on the underside of the Keyset.
D. WALL-MOUNTING A KEYSET 
6.8Locate, drill and plug the two screw locations as shown below. The holes should be
deep...

Page 2-26
Installation
ENCORE MANUAL, Issue 4.0 – July 2002
Single-Line Sets
7. SINGLE-LINE SETS
7.1Industry-standard, AC-ringing, single-line DTMF sets may be installed on an Encore
System.
7.2Single-line set users access features simply by lifting the handset and entering a feature
code or by using a combination of a hookflash and a feature code. Refer to the Features section
of this manual (page 3-1) for details.
7.3To install a single-line set:
1.Mount the modular jack assembly on the wall.
2.Plug...

Page 2-27
Installation
ENCORE MANUAL, Issue 4.0 – July 2002
Doorphone
INSTALLATION
2
A. DOORPHONE
9.2An external Doorphone is available that can be installed on the Encore System. (See
PARTS for part numbers.) When a person presses a button on the Doorphone, the unit gener-
ates ringing on the extensions programmed to receive Doorphone calls. After answering the
ringing call, a system user can talk with the person at the door. 
9.3In database programming, make sure that the desired keysets have access to...

Page 2-28
Installation
ENCORE MANUAL, Issue 4.0 – July 2002
Doorstrike
B. DOORSTRIKE 
9.5The doorstrike two-way connector provides a closed relay contact when in the operated
condition. The relay contact is suited only for use with low voltage DC equipment. (Rating:
24VDC, 2 Amps).
9.6If the door is equipped with an electric strike plate, a system user may open the door by
dialing a code or pressing a feature button. 
NOTE: You must purchase the doorstrike mechanism and arrange for a qualified...

Page 2-29
Installation
ENCORE MANUAL, Issue 4.0 – July 2002
External Music-On-Hold
INSTALLATION
2
C. EXTERNAL MUSIC-ON-HOLD
9.8If a customer-provided music source is not installed, the internal music-on-hold cir-
cuitry provides music for CO lines on hold. However, an external source (such as a radio, tape
player, etc.) can be installed and programmed to provide music-on-hold. 
9.9The music source is connected to the CPU using a fixed-screw terminal.
9.10The music-on-hold circuitry automatically holds...

Page 2-30
Installation
ENCORE MANUAL, Issue 4.0 – July 2002
Paging Equipment
D. PAGING EQUIPMENT
9.13The Encore can be configured to operate with external paging equipment (speaker and
amplifier). The paging equipment can be connected to any extension position.
9.14To install the external paging equipment:
1.Cut a length of shielded speaker cable (or coaxial cable) to run from the paging ampli-
fier to the KSU.
2.Connect one end of the cable to the amplifier high-impedance input according the man-...