HP Officejet J5780 User Manual

Media sizeTray 1DuplexerADF
Borderless A4 (210 x 297 mm; 8.3 x 11.7
inches)*  
Borderless A5 (148 x 210 mm; 5.8 x 8.3
inches)*  
Borderless B5 (182 x 257 mm; 7.17 x
10.12 inches)*  
Envelopes
U.S. #10 Envelope (105 x 241 mm; 4.12
x 9.5 inches)*
  
A2 Envelope (111 x 146 mm; 4.37 x 5.75
inches)*  
DL Envelope (110 x 220 mm; 4.3 x 8.7
inches)*  
C6 Envelope (114 x 162 mm; 4.5 x 6.4
inches)*  
Japanese Envelope Chou #2 (119 x 277
mm; 4.7 x 10.9 inches)*  
Japanese Envelope Chou #3 (120 x 235
mm; 4.7 x 9.3...

Media sizeTray 1DuplexerADF
Photo media (8 x 10 inches)*  
Photo media (10 x 20 cm)*  
Photo media (4 x 8 inches)*  
Photo media HV*  
Photo media cabinet (165 x 120 mm; 6.5
x 4.7 inches)*  
Photo media 2L (178 x 127 mm; 7 x 5
inches)*  
Photo media (13 x 18 cm)*  
Photo media B7 (88 x 125 mm; 3.5 x 4.9
inches)*  
Photo L (89 x 127 mm; 3.5 x 5 inches)*  
Borderless photo media (102 x 152 mm;
4 x 6 inches)*  
Borderless photo media (10 x 20 cm)*  
Borderless photo media (4 x 8inches)*  
Borderless HV*...

Media sizeTray 1DuplexerADF
(3 to 8.5 inches wide and 5 to 23 inches
long) *
Custom-sized media (ADF) between
127 to 216 mm wide and 241 to 305 mm
long (5 to 8.5 inches wide and 9.5 to 12
inches long)  
Panorama (4 x 10 inches, 4 x 11 inches,
4 x 12 inches, and double A4) *  
Borderless panorama (4 x 10 inches, 4 x
11 inches, 4 x 12 inches, and double A4)
*  
* Not compatible for use with the ADF for single- or double-sided printing
** The device is compatible with plain and inkjet hagaki from Japan Post...

Set minimum margins
The document margins must match (or exceed) these margin settings in portrait
orientation.
Media(1) Left
margin(2) Right
margin(3) Top
margin(4) Bottom
margin*
U.S. Letter
U.S. Legal
A4
Photo media2 mm (0.12
inch)2 mm (0.12
inch)1.8 mm (0.07
inch)2 mm (0.12
inch)
U.S. Executive
B5
A5
Cards2 mm (0.12
inch)2 mm (0.12
inch)1.8 mm (0.07
inch)6 mm (0.24
inch)
Envelopes3.3 mm (0.13
inch)3.3 mm (0.13
inch)16.5 mm (0.65
inch)16.5 mm
(0.65 inch)
* To achieve this margin setting on a computer...

•Highly textured stock, such as linen. It might not print evenly, and the ink can bleed
into these papers.
•Extremely smooth, shiny, or coated papers not specifically designed for the HP All-
in-One. They can jam the HP All-in-One or repel the ink.
•Multi-part forms, such as duplicate and triplicate forms. They can wrinkle or get stuck,
and the ink is more likely to smear.
•Envelopes with clasps or windows. They can get stuck in the rollers and cause paper
jams.
•Banner paper.
Additional papers to avoid...

To load full-size paper
1.Remove the output tray.
2.Slide the paper-width guide to its outermost position.
3.Tap a stack of paper on a flat surface to align the edges, and then check the paper
for the following:
• Make sure it is free of rips, dust, wrinkles, and curled or bent edges.
• Make sure all the paper in the stack is the same size and type.
Chapter 6
64 Load originals and load paper
 

4.Insert the stack of paper into the input tray with the short edge forward and the print
side down. Slide the stack of paper forward until it stops.
CAUTION:Make sure that the HP All-in-One is idle and silent when you load
paper into the input tray. If the HP All-in-One is servicing the print cartridges or
otherwise engaged in a task, the paper stop inside the device might not be in
place. You could push the paper too far forward, causing the HP All-in-One to
eject blank pages.
TIP:If you are using...

7.Flip the tray extender up toward you.
NOTE:When you use legal-size paper, leave the tray extender closed.
Load 10 x 15 cm (4 x 6 inch) photo paper
You can load 10 x 15 cm (4 x 6 inch) photo paper into the input tray of the HP All-in-One.
For the best results, use 10 x 15 cm (4 x 6 inch) HP Premium Plus Photo Paper or HP
Premium Photo Paper.
TIP:To help prevent rips, wrinkles, and curled or bent edges, store all paper flat in
a resealable bag. If the paper is not stored properly, extreme changes in...

4.Slide the paper-width guide inward against the photo paper until it stops.
Do not overload the input tray; make sure the stack of paper fits within the input tray
and is no higher than the top of the paper-width guide.
5.Replace the output tray.
Related topics
•
Understand specifications for supported media
•
Set the copy paper type
Load index cards
You can load index cards into the input tray of the HP All-in-One to print notes, recipes,
and other text.
For best results, set the paper type and paper...

Related topics
•
Load 10 x 15 cm (4 x 6 inch) photo paper
•
Set the copy paper type
Load envelopes
You can load one or more envelopes into the input tray of the HP All-in-One. Do not use
shiny or embossed envelopes or envelopes that have clasps or windows.
NOTE:For specific details on how to format text for printing on envelopes, consult
the help files in your word processing software. For best results, consider using a label
for the return address on envelopes.
To load envelopes
1.Remove the output...