HP Designjet T7100 User Manual

							Connectivity menu
Gigabit EthernetView information  
View configuration  
Modify configuration  
Restore factory settings  
USB View information 
Jetdirect EIO View information 
View configuration  
Modify configuration  
Restore factory settings  
Advanced Select I/O timeout 
Allow SNMP  
Embedded Web Server Allow EWS
Reset EWS access control
Web Services Printer Utility software
Color and paper management
Restore factory settings  
View information shows whether the interface is installed,  whether the IP address is enabled and
whether printing is enabled through this in terface. It also displays the MAC address.
View configuration  shows the following information: Link st ate, IP address, Configuration mode,
Subnet mask, Default ga teway, mDNS service na me and the MAC address.
Modify configuration allows you to change the IP address , subnet mask, default gateway and idle
timeout. You can also view the ho st name string and choose an IP address configuration method from
BOOTP, DHCP, Auto IP and Manual.
Printer utility software  allows you to enable or disable the use of the HP Utility.
ENWW Connectivity menu
193
Front-panel menus
 
						

							Internal prints menu
Demo printsPrint drawing demo  
Print rendering demo  
Print GIS map  
User information prints Print menu map  
Print configuration  
Print usage report  
Print HP-GL/2 palette  
Print PS font list [P]  
Service information prints Print current information 
Print usage information  
Print event logs  
Print calibration status  
Print connectivity configuration  
Print all pages  
194 Appendix A   Front-panel menus ENWW
Front-panel menus
 
						

							Information menu
View printer information  
Product certifications   
Printer logs System errors  
System warnings  
Printheads  
Ink cartridges  
View printer information displays general printer informat ion including Product name, Product
number, Serial number, Service ID, Language, Memory, Disk capacity and Firmware version.
ENWW Information menu
195
Front-panel menus
 
						

							B Front-panel error messages
Under certain circumstances, a front-panel error message appears. Follow the advice in the
Recommendation column to resolve the error.
If an error message appears  on the front panel that is not included in this list, and you are in doubt
over the correct response, contact HP Support. See 
HP Customer Care on page 180 .
Table B-1   Text messages
Message Recommendation
[Color] cartridge has expired Replace the cartridge. See 
Remove an ink cartridge
on page 48 and Insert an ink cartridge on page 50.
[Color] cartridge is missing Insert a cartridge of the correct color. See 
Insert an ink
cartridge on page 50 .
[Color] cartridge is out of ink Replace the cartridge. See 
Remove an ink cartridge
on page 48 and Insert an ink cartridge on page 50.
[Color] printhead #[n] error: not pres ent Insert the correct printhead. See 
Insert a printhead
on page 54.
[Color] printhead #[n] error: please remove Remove th e incorrect printhead and insert a new printhead of
the correct type (color and number). See 
Remove a printhead
on page 51 and Insert a printhead on page 54.
[Color] printhead #[n] error:  replace Remove the non-functional printhead and insert a new
printhead. See 
Remove a printhead on page 51 and Insert a
printhead on page 54.
[Color] printhead #[n] error: reseat Remove and re insert the same printhead, or try cleaning the
electrical connections. If necessary, insert a new printhead.
See 
Front panel recommends re seating or replacing a
printhead on page 165.
[Color] printhead #[n] out of wa rranty The printheads warranty has ended, because of the length of
time it has been in operation or because of the volume of ink
used. See the  Legal Information.
[Color] printhead #[n] warranty warning The printheads warranty may be invalidated by the use of the
wrong kind of ink. See the Legal Information.
[Warning] internal failure: Unable to create print The internal print files are not available in the printer. Load the
internal print files throug h the Embedded Web Server.
IO error Restart the printer. If the problem persists, contact HP Support.
See 
HP Customer Care on page 180.
IO warning Try again; if the problem persists, contact HP Support. See 
HP
Customer Care on page 180.
PDL Error: Ink system not ready Clean the printheads. See 
Clean (recover) the printheads
on page 56.
196 Appendix B   Front-panel error messages ENWW
Error messages
 
						

							Table B-1  Text messages (continued)
Message Recommendation
PDL Error: Job clipped The image is too large for the paper or for the printer. Load
larger paper if possible,  or reduce the image size.
PDL Error: memory full Restart the printer and try resending the job; if necessary,
reduce the complexity of the job.
PDL Error: out of paper Load more paper.
PDL Error: parsing error The print job is unintelligible to the printer. Try to recreate and
resend it. Check your cable connections.
PDL Error: print mode error The paper type or print quality specified for the job are
incorrect. Change the loaded paper  type or the print settings.
PDL Error: printing error Try sending the job again.
PDL Error: virtual memory full Restart the printer and try resending the job; if necessary,
reduce the complexity of the job.
Replace [color] ink cartridge The cartridge is out of ink; replace it. See 
Remove an ink
cartridge on page 48 and Insert an ink cartridge on page 50 .
Replace faulty [color] ink cartridge The  cartridge is faulty; replace it. See 
Remove an ink cartridge
on page 48 and Insert an ink cartridge on page 50.
Reseat [color] cartridge Remove and reinsert the same cartridge. See 
Remove an ink
cartridge on page 48  and Insert an ink cartridge on page 50 .
Update: failed. Invalid file Make sure that  you have selected the correct firmware update
file. Then try again to perform the update.
Under certain circumstances, a front-panel numeri c error message appears. Follow the advice in the
Recommendation column to resolve the error.
If an error message appears  on the front panel that is not included in this list,  turn off the printer and
then turn it back on. If the problem persists, contact HP Support. See 
HP Customer Care on page 180 .
Table B-2   Numeric error messages
Error code Recommendation
26.n.01 (where n = the subject ink
cartridge number) Remove the subject ink cartridge and reinstall 
it in the printer. If the error persists,
replace the subject ink cartridge. If the  problem persists, contact HP Support. See
HP Customer Care on page 180.
29.01 The maintenance cartridge is not inserted correctly. Open the maintenance cartridge door on the right side of the printer, make sure that the maintenance
cartridge is correctly seated, and then close the door. If the problem persists,
replace the maintenance cartridge. If the  problem persists, contact HP Support. See
HP Customer Care on page 180.
ENWW 197
Error messages
 
						

							Table B-2  Numeric error me ssages (continued)
Error code Recommendation
61.01 The file format is incorrect and the printer cannot process the job. Try the following
remedies:
●Turn off the printer by using the Power button on the front 
panel and the power
switch at the back of the printer, an d then disconnect the power cord—then
reconnect the power cord and turn on the printer.
● Make sure that the graphic language setting is correct. See 
Change the
graphic language setting on page 24
.
● Resubmit the file to the printer.
● Check that your printer firmware is up to date. See 
Update the printer
firmware on page 144
.
If the problem persists, contact HP Support. See 
HP Customer Care on page 180 .
61.04 Install the latest firmware release. See 
Update the printer firmware on page 144.
61.08 The paper type has change d, please resubmit the job.
61.08.1 The job cannot be printed  because it is password-protected.
61.08.2 The job cannot be printed because it contains errors.
63.04 An input/output problem has occurred with the network card. Try the following remedies:
●Make sure that the network cable is correctly connected to the network card.
● Check that your printer firmware is up to date. See 
Update the printer
firmware on page 144
.
If the problem persists, contact HP Support. See 
HP Customer Care on page 180 .
71.08 Out of memory. Data lost. In the HP-GL/2 and HP RTL driver, select the  Advanced
tab, Document options , Printer features , then enable the Send job as
bitmap  option before resubmitting the job.
74.01 An error occurred when uploading the  firmware update file. Try the following
remedies:
● Turn off the printer by using the Power button on the front 
panel and the power
switch at the back of the printer, an d then disconnect the power cord—then
reconnect the power cord and turn on the printer.
● Try again to upload the firmware 
update file to the printer. See 
Update the
printer firmware on page 144.
If the problem persists, contact HP Support. See 
HP Customer Care on page 180 .
76.03 The Resource Area is full. Please use the Hard Disk Recovery utility.
198 Appendix B   Front-panel error messages ENWW
Error messages
 
						

							Table B-2  Numeric error me ssages (continued)
Error code Recommendation
77.04 An Embedded Web Server internal software error has occurred. Try the following
remedies:
● Turn off the printer by using the Power button on the front 
panel and the power
switch at the back of the printer, an d then disconnect the power cord—then
reconnect the power cord and turn on the printer.
● Check that your printer firmware is up to date. See 
Update the printer
firmware on page 144
.
If the problem persists, contact HP Support. See 
HP Customer Care on page 180 .
81.01, 81.03, 86.01 Open the printer window and make sure that there are no obstacles restricting the movement of the drive roller. If the paper has jammed and is restricting the
movement of the drive roller, lift the pape r load lever and clear the obstruction. If
the problem persists, contact HP Support. See 
HP Customer Care on page 180.
ENWW 199
Error messages
 
						

							C Printer specifications
●Functional specifications
●
Physical specifications
●
Memory specifications
●
Power specifications
●
Environmental specifications
●
Acoustic specifications
200 Appendix C   Printer specifications ENWWPrinter specifications
 
						

							Functional specifications
Table C-1  HP No. 762 ink supplies
 T7100 T7100 Mono
Printheads Yellow, magenta/cyan, gray/dar k gray, black/black Black/black, dark gray
Ink cartridges Black, yellow, magenta, cyan, gray, dark gray Black, dark gray
Maintenance cartridge Non-color -specific Non-color-specific
Table C-2  Paper sizes
Minimum Maximum
Width 280 mm (11 in) 1067 mm (42 in)
Length 420 mm (16.5 in)91 m (300 ft)
Roll diameter   180 mm (7.08 in)
NOTE:The printer can cope with paper rolls that vary from their nominal width by up to 3 mm in
either direction (wider or narrower).
Table C-3   Print resolution (using Windows HP-GL/2 driver)
Print quality Maximum
resolution for
photo paperRendering
resolution
Printing resolution
Best On 1200×1200 2400×1200 (HP Premium Instant-dry Photo
Gloss, HP Premium Instant-dry Photo Satin, HP
Universal Instant-dry Photo Gloss, HP Universal
Instant-dry Photo Semi-Gloss, Photo Gloss Paper,
Photo Semi-Gloss/Satin Paper, Photo Matte
Paper)
1200×1200 (other)
Best Off 600×600 600×1200 (HP Premium Instant-dry Photo Gloss,
HP Premium Instant-dry Photo Satin, HP Universal
Instant-dry Photo Gloss, HP Universal Instant-dry
Photo Semi-Gloss, Photo Gloss Paper, Photo
Semi-Gloss/Satin Paper, Photo Matte Paper)
1200×1200 (other)
ENWW Functional specifications
201
Printer specifications
 
						

							Table C-3  Print resolution (using Windows HP-GL/2 driver) (continued)
Print quality Maximum
resolution for
photo paperRendering
resolution
Printing resolution
Normal n/a 600×600 600×1200 (HP Premium Instant-dry Photo Gloss,
HP Premium Instant-dry Photo Satin, HP Universal
Instant-dry Photo Gloss, HP Universal Instant-dry
Photo Semi-Gloss, Photo Gloss Paper, Photo
Semi-Gloss/Satin Paper, Photo Matte Paper)
1200×1200 (other)
Fast n/a 300×300 600×1200 (plain paper, bright white bond
paper, HP Premium Instant-dry Photo Gloss, HP
Premium Instant-dry Photo Satin, HP Universal
Instant-dry Photo Gloss, HP Universal Instant-dry
Photo Semi-Gloss, Photo Gloss Paper, Photo
Semi-Gloss/Satin Paper, Photo Matte Paper)
1200×1200 (other)
Table C-4  Margins
Side margins 5 mm (0.197 in)
Top margin (leading edge) 5 mm (0.197 in); 11.5 mm (0.453 in) for glossy paper
Bottom margin (trailing edge) 5 mm (0.197 in)
Table C-5  Mechanical accuracy
±0.1% of the specified vector length or ±0.1 mm (whichever grea ter) at 23°C (73°F), 50-60% relative humidity, on A0 printing
material in  Best or Normal  mode with HP Matte Film.
Table C-6  Graphic languages supported
HP Designjet T7100 Printer HP-GL/2, RTL, CALS/G4
HP Designjet T7100ps Printer HP-GL/2, RTL, CALS/G4, Adobe PostScript level 3, Adobe PDF 1.7, TIFF, JPEG
Physical specifications
Table C-7  Printer physical specifications
Weight (including stand) 187 kg (412 lb)
Width 1970 mm (77.5 in)
Depth 690 mm (27.2 in)
Height 1370 mm (53.9 in)
202 Appendix C   Printer specifications ENWW
Printer specifications