Honda Bmw 5 Service Manual

Seat Belts 
NOTE- 
The rear bench seat belt strap  may not retract fully  due to in- 
creased friction between strap  and seat  cover. 
A small  re- 
maining loop in belt strap  when fully retracted is acceptable. 
WARNING- 
* For maximum protection  from injury, seat bells should  be 
replaced  as a set  (including  all hardware),  if they are  sub- 
ject  to occupant loading  in a collision. 
Seat belts should not be modified  or repaired. The seat 
belt mounting points should not be changed  or modi-...

- - 
Seat Belts 
Front seat belt tensioner, removing and 
installing 
- Disconnect  battery  negative (-) cable  in trunk. 
The 
front seat  belt loclts are equipped  with pyrotechnic  (ex- 
plosive  charge)  automatic  tensioners.  These tensioners are 
designed  to automatically retract  and tension  the seat belt  by 
55 mm (approximately 2 inches) in the  event  of an  accident. 
CAUTION- 
Prior  to disconnecting  the battery,  read the battery discon- 
nection cautions  given in 
001 General...

Seat ~eltsl 
< Remove tensioner  cover: 
Cut wire  ties (A). 
Release wiring harness from tensioner  cover clip (B). 
- Release tensioner  cover locks (C) and slide  cover down to 
remove. 
- When  reinstalling: 
Replace  wire ties to relieve  tension on pyrotechnic belt 
ten- 
sioner harness  connector. 
Tightening torques . - 
Front seat to floor (M10) 42 Nm (31 it-lb) 
Seat belt  to seat  48 Nm (35 It-lb) 
Tensioner mounting bracitet 
to seat rail 24 Nm (18  it-lb) 
Tensioner to mounting bracket 48...

I Seat Belts 
a 
Front seat belt assembly 
1. Seat belt buckle 
2.  Seat  belt stop button 
3. Seat belt 
4. Seat belt height  adjuster 
5. 
6-pillar cross  brace 
6. Seat belt reel mounting bolt 
7. Seat  belt anchor  mounting  bolt 
8. Seat belt lock  with pyrotechnic 
tensioner 
9. Tensioner  mounting bolt 
Front seat belt reel, removing and installing 
(sedan and Sport  Wagon models) 
- Detach battery negative (-) cable in trunk. 
~~-~ 
Prior to disconnecting  the battery,  read the battery  discon-...

Seat Belts 
Remove lower B-pillar  (door pillar) plastic trim 
Pry carefully along  bottom of trim  to disengage 
pillar. 
Slide trim  down  (arrow) and out to remove.  clips 
from 
4 Carefully  pry bottom  of upper door post trim  away from post 
to  release clips. 
Slide  upper trim  panel down  (arrow) to  remove. 
Remove automatic  reel from  B-pillar: 
- Remove upper seat  belt anchor  bolt (A). 
Remove cross-brace  mounting bolts (B). 
Remove  sound insulation  at base  of 8-pillar. 
Then  remove...

720-8 
I Seat Belts 
When Installing  automatic reel  housing to 5-pillar, slide tab 
into locating  slot (arrow). 
Remainder  of installation  is reverse  of removal 
Tightening  torques 
- -. 
Front seat to floor (M10) 42  Nm  (31 ft-lb) 
Seat  belt to  seat  48 Nm  (35 ft-lb) 
Seat  belt to height  adjuster  31 Nm 
(23 it-lb) 
Seat belt  reel  to €3-pillar  bottom 31 Nm (23 ft-lb) 
Sliding height adjuster to €3-pillar 
24 Nm (18 ft-lb) 
Rear  seat belt assembly 
(sedan) 
1. Center  shoulder  belt...

-- - 
Seat Belts 
Rear seat belts  (sedan) 
- Remove rear  parcel shelf to  access shoulder belt  assembly 
mounting  bolts. See 513 Interior  Trim. 
- Remove rear seat cushion  to access rear seat belt  lock 
mounting  bolts.  See  520 Seats. 
- When installing  seat belt lock straps: 
Install right lock strap  (which  is shorter) underneath  middle 
lock strap. 
Install left  lock strap  underneath middle  lap belt  strap. 
Metal  strap ends must  rest  against stop on floor under- 
neath  seat. 
Rear...

720-1 0 
Seat Belts 
Rear seat belts (Sport Wagon) 
- Center shoulder  belt: 
Remove shoulder  belt guide  trim at top  of seat backrest. 
Feed belt  out through slot  in trim. Working  in cargo  com- 
partment,  partially remove backrest cover to access shoul- 
der  belt  reel. 
Remove shoulder  belt reel  mounting bolt inside backrest. 
- Outboard shoulder  belt: 
Remove roof-pillar (C-pillar)  trim. 
Remove center shoulder belt. 
- Lift  up rear seat cushion(s) to access  rear seat  belt loclc...

721 Airbag System (SRS) 
........................... General ............................ 721-2 Airbags 721-8 
..... E39Airbags ......................... 721-3 Driver airbag. removing and installing 721-8 
Two-stage airbag (MRS 111) ............ .72 1.4 Passenger airbag. removing  and installing . 721-9 
Airbag indicator light .................. .72 1.4 Door  mounted  side-impact airbag. 
............... Warninas .......................... .72 1.5 removina and installina 721-10 . 
..... Head protection...

721 -2 
l~irba~ System (SRS) 
This repair group covers airbag components and replace- 
ment. 
Airbag system  repairand  fault diagnosis is not covered. 
Diagnostics, component testing, and 
airbag system  repair 
should  be carried out by trained BMW service technicians. 
Individual 
airbag system components  can only  be tested elec- 
tronically when  installed in the car.  BMW service testers 
DIS 
or MoDiC or equivalent must  be used  for diagnostic work. 
WARNING- 
Special  test equipment  is...