Honda Bmw 5 Service Manual

Sunroof, normalization 
During normalization  the mechanical end positions  of sunroof 
movement  are detected  and stored by  the General Module 
(GM 
Ill). 
,:..I:,* *:3F$&-T , a,.,-. . 2 *i;.I . :i_(,*,,_ _* Press  and hold  sunroof switch  in lift direction. 
Afler  reaching end position 
(A), keep switch pressed  for 
approximately 
20 seconds longer. 
- Normalization  is complete when sunroof  in lifl position (A) 
moves briefly in direction  of (6). 
E39 models up to 311 998 
- The characteristic...

-. 
Sunroof 
Sunroof panel, emergency closing 
4 Using a plastic  tool carefully  pry interior light out  of headliner. 
4 Remove access  panel from below sunroof  motor by inserting 
fingers through  light opening and pressing  down. 
4 Disconnect electrical connections (arrow) and lay switch 
panel  aside. 
4 Insert  hex ltey into drive  in sunroof  motor (arrow), and turn 
hex  ltey to manually close sunroof. 
NOTE- 
The  hex ley for manually  (emergency)  closing the sunroof 
can  be found  in the...

Sunroof, adjusting 
The sunroof  is controlled  by a set  of cables that  move the sun- 
roof  panel along guide rails  when the motor is operated.  The 
sunroof can be adjusted  without removing it from  the car. 
NOTE- 
Be sure  to check drains  in front corners  of sunroof carrier  if 
water  is entering  car through  headliner. 
- The sunroof  panel should be adjusted under the following  cir- 
cumstances: 
Sunroof  misaligned  with roof. 
Sunroof  does not  close squarely. 
* Wind noise at high...

l Sunroof 
4 Adjusting rear roof height: 
Remove  fasteners 
(A) and (6) 
Slide in left and right side adjusting  wedges (C) until ideal 
setting is  reached. 
Press  sunroof  panel forward and  tighten wedge nuts 
(6). 
* Tighten center nut (A). 
4 Adjusting  front roof height. 
Loosen  lefl and right  fasteners 
(A) 
Set front  of sunroof  to ideal height  by moving  panel up  or 
down. 
Tighten  fasteners 
(A). 
Insert hex key in drive motor  and turn 90 clockwise. 
Pull headliner panel  forward...

Sunroof 
Sunroof with glass roof panel, adjusting - - 
< Slide  sunroof  liner back into roof cavity  until approx. 70 mm 
(2.75 in) is  exposed. 
Raise  glass sunroof  panel to vent  position  to expose rubber 
gaiter  (arrow). 
- Working from center section  of gaiter  (arrow),  carefully  pull 
gaiter  off slotted mounting  on sunroof glass  panel. 
CA UTIOW- 
The  gaiters tear easik 
* Do not  attempt  to remove gaiters  from lower  edge of 
sliding  mechanism. 
- With gaiters  removed, three...

1 Sunroof 
Sunroof assembly removal  and installation  involves headliner 
removal, and is  not covered in this manual. After sunroof re- 
pairs,  be sure  to follow initialization  and adjustment proce- 
dures given earlier. 
I Sunroof comDonents 
1. Left rubber  boot suppori 
2. Left upper  control rail 
3. Left side  water  channel repair ltit 
4. Left lower  control rail 
5. Left cover 
6. Left side slider 
7. Cross  member 
8. Sunroof frame 
9. Trim panel 
10. Gasket 
11. Glass  roof cover 
m5sm.7...

Sunroof 
4 Remove three Torx screws  (arrows)  on each  side, and  lift 
panel  out. 
- Installation is  reverse of removal. Adjust sunroof  height  and 
gap  as described  earlier. See Sunroof,  adjusting. 
Tightening torques 
Wind  blocker  to roof  (Torx) 
1 Nm (9 in-lb) 
Sunroof  panel to  roof (Torx) 
6 Nm (4.4 ft-lb) 
Sunroof panel gasket, replacing 
(steel 
or glass) 
- Remove sunroof  panei. See Sunroof  panei, removing  and 
installing  (steel or glass). 
Pull old seal  from panel. 
Coat  new...

.- 
Sunroof 
Sunroof motor, replacing 
Remove interior light from below sunroof motor  by gently  pry- 
ing  with  a plastic  tool. 
4 Remove access panel from  below sunroof  motor by inserting 
fingers through light opening  and pressing  down. 
4 Remove sunroof  motor mounting screws (arrows). 
- Installation  is the  reverse  of removal.  Perform  initialization 
procedure as described  earlier. See Sunroof electronic 
controls, initializing. 
Tightening 
torque 
Sunroof motor  to sunroof carrier...

........... General ........................... .72 0.2 Rear Seat Belt Assembly 720-8 
......... Troubleshooting ..................... .72 0.2  Rear seat belt  assembly  (sedan) 720-8 
................ Rear seat belts  (sedan)  720-9 
... .......... Front Seat Assembly 720-4 Rear seat belt assembly (Sport Wagon)  720-9 
Front seat belt tensioner, 
......... Rear seat belts  (Sport Wagon)  720-10 
removing  and installing ................ .72 0.4 
Front seat belt  assembly 
.............. .72 0.6 
Front...

I Seat Belts 
This section covers  repairs to the  following  seat belts  sys- 
tems.  See the table  below. 
IMultIple Restraint Systems I 
Years 
311 996 - 811 997 
Multiple  Restraint  System electronics  integrate seat belt op- 
erations  and 
airbag deployment. Airbag repair information  is 
covered 
in 721 Airbag System (SRS). 
Troubleshooting 
The  seat belt  reel should lock  when driving quicltly through 
curves, 
during severe braking  or in case of a collision.  The au- 
tomatic reel  does...