Honda Bmw 5 Service Manual

........................ General ........................... .52 0.2 Rear Seats .52 0.7 
SeatIMirrorlSteering Column Memory ..... .52 0.2  Rear seat cushion  and backrest, 
...... Seat  memory  position. setting ........... .52 0.2  removing and  installing (sedan only)  520-7 
......... Headrest.  removing 
and installing 520-8 Front Seats ........................ .52 0.4 
Seat switch and  memory module. 
removing  and installing 
................ .52 0.3 
Front seat.  removing and  installing 
..........

l Seats 
This repair group covers removal  and installation  of the  front 
and rear  seat. 
SeatIMirrorlSteering Column  Memory 
< The basic features  of seaffmirrorlsteering column operation, 
including memory positions  are integrated into the 
ZKE Ill 
system.  Driver  adjustment positions can  be memorized  and 
stored  for three  different 
users.The seat control module  is in- 
tegral with the  seat and mirror switches. The seat control 
module stores seat memory position  via the ripple counter...

ZKE seat/mirror/steering 
column memory 
operational diagram 
1. General module Ill 
2. Steering column adjustment 
switch 
3. Seat memory module  with 
adjustment switches 
4. Headrest motor 
5. Backrest motor 
6. Seat  base tilt angle  motor 
7. Seat base up - down  motor 
8. Seat forward - back motor 
9. Steering column length  motor 
10. Steering column tilt motor 
11. Drivers (left) door module 
12. Memory switch   

l Seats 
Seat repair and component  replacement  is possible  once the 
seat has been removed from  the vehicle. 
Before  servicing front seats  read safety  regulations on han- 
dling 
airbag modules  and pyrotechnic seatbelt tensioners. 
See 
720  Seat  belts and 721 Airbag system (SRS). 
WARNING- 
. The front seats  are equipped  with pyrotechnic seat belt 
tensioners.  These  tensioners  are powerful  devices and 
should be handled  with exfreme care. Incorrect handling 
can trigger  off the...

520-5 
Seats 
1 
4 Release mounting tabs (arrows) and remove  switch module. 
Front seat,  removing  and installing 
- Turn ignition  switch to OFF position. 
Remove  front and rear rail trim  panels: 
Raise center  of trim panel 
(A) to  release loclting pin. 
Unlock  and lift out  inner mounting  clips tabs 
(6). 
Slide trim panel  off rail  (arrow)  to remove. 
< Remove  seat belt mounting  fastener (arrow) from seat 
frame.   

--. . 
1 Seats 
4 Remove fasteners (arrows) from rear 
- Move seat as far back as possible.  of 
seat  rails 
4 Open seat  electrical  harness cover (A) to release  plug loclc 
(6) and disconnect  electrical connector (C).   

Seats 
< Remove front  seat  rail fasteners (arrows) 
- Remove front  seat from car. Headrest may  be removed to 
provide additional clearance. 
NOTE- 
Use  a blanket  to protect  the door  sill from  scuffing  by seat 
rails 
during seat  removal. 
- Installation is reverse  of removal. Use wire  ties or equivalent 
means  to keep seat  harness wiring from fraying. 
Tightening torques 
Front seat  to floor 
42 Nm (31 ft-lb) 
Seat belt  end to seat frame 
48 Nm  (35 ft-lb) 
E39 models are equipped with...

Seats 
Remove left and right side bacltrest mounting  fasteners (ar- 
row). 
Pull up on backrest  to detach  from top retainers.  Slide back- 
rest  to side  to clear seat belts  while removing. 
NOTE- 
If the  car is equipped  with heatedrearseats,  detach electrical 
harness 
connector(s) as  you  remove  the seat  components. 
4 When reinstalling, be sure  to pull seat belts  and buckles (ar- 
rows)  up through appropriate  slots in seat  cushion. 
Headrest, removing and installing 
- Slide headrest...

540 Sunroof 
General . . . . . . . . . . . . . . . . . . . . . . . . . . . ,540-2 
Sunroof Adjustments. . . . . . . . . . . . . . . .540-2 
Sunroof electronic  controls, initializing . . . . ,540-2 
Sunroof, normalization. . . . . . . . . . . . . . . . . ,540-3 
Sunroof, characteristic  curve . . . . . . . . . . . .540-3 
Sunroof panel, emergency  closing . . . . . . . ,540-4 
Sunroof, adiustino . . . . . . . . . . . . . . . . . . . . ,540-5 
~unroofwitil steel roof panel, adjusting . . . ,540-5...

540-2 
Sunroof 
This repair group covers the  slide-tilt sunroof assembly. 
There are two types  of sunroof panels available: steel 
01 
glass. Service procedures are different for each type. 
Component  locations, initialization, sunroof panel replace- 
ment,  and sunroof  height adjustment  are covered.  Replace- 
ment  of the  cable  assembly or frame  require that the 
headliner be  removed. Removal and repair  of the  sunroof as- 
sembly  and othercomponents inside the  roof cavity  is beyond 
the...