Epson R2000 Service Manual

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Removing the Housings 81
Confidential
4.2.7  Upper Housing / Printer Cover1.Remove the Decoration Plate Left/Right. (p.80)
2.Remove the Panel Unit. (p.78)
3. Open the Front Cover and CDR Tray Base. (Refer to 4.1.6 Locking/Unlocking the 
Carriage and Opening/Closing the CDR Tray Base (p.73))
4. Remove the seven C.B.P. M3 x 10 screws that secure the Upper Housing.
5. Remove the Upper Housing while pulling out the CDR Sensor cable and...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Removing the Housings 82
Confidential
REMOVING THE PRINTER COVER
1.Remove the Upper Housing / Printer Cover. (p.81)
2. Remove the two C.B.P. M3 x 10 screws that secure Printer Cover Holder Left/
Right.
Figure 4-20. Removing the Printer Cover Holder Left/Right3. Remove the Printer Cover Holder Right following the steps below.
3-1. Open the Printer Cover and place the Upper Housing with its backside 
down.
3-2. Pull the Printer Cover in...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Removing the Housings 83
Confidential
3-3. Slide the Printer Cover Holder Right in the direction of the arrow while 
pushing the part A, and pull out the Printer Cover Holder Right from the 
bearing of the Printer Cover.
Figure 4-22. Removing the Printer Cover (2)
4. In the same way, remove the Printer Cover Holder Left and remove the Printer 
Cover from the Upper Housing.
4.2.8  Upper Housing Support Assy1.Remove the Upper Housing /...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Removing the Boards 84
Confidential
4.3  Removing the Boards4.3.1  Board Assy (Main Board/Power Supply Board)1.Remove the Upper Housing / Printer Cover. (p.81)
2. Remove the seven screws (four C.B.S. M3 x 6, two C.B.S. (P2) M3 x 10, and one 
C.B.S. M3 x 10) that secure the Board Assy.
Figure 4-25. Removing the Board Assy (1)3. Disconnect all the cables and FFCs connected on the Main Board from the near 
side one by one.
Figure 4-26....

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Removing the Boards 85
Confidential
4. Pull out the Board Assy from the Printer.
Figure 4-27. Removing the Board Assy (2)
REMOVING THE MAIN BOARD
1.Remove the Board Assy (Main Board/Power Supply Board). (p.84)
2. Disconnect the Power Board cable from connector CN60 on the Main Board.
3. Remove the four C.B.S. M3 x 6 screws and two C.B.P. M2.6 x 5 screws that 
secure the Main Board and remove the Main Board from the Board Assy.
Figure...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Removing the Boards 86
Confidential
REMOVING THE POWER BOARD
1.Remove the Board Assy (Main Board/Power Supply Board). (p.84)2. Disconnect the Power Board cable from connector CN60 on the Main Board. (p.85)3. Remove the four C.B.S. M3 x 6 screws that secure the Power Board and remove 
the Power Board from the Board Assy.
Figure 4-32. Removing the Power Board
4.3.2  LED Board1.Remove the Upper Housing / Printer Cover. (p.81)
2. Peel off...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Removing the Boards 87
Confidential
5. Remove the C.B.S. (P4) M3 x 8 screw that secures the LED Board, and remove 
the LED Board.
Figure 4-35. Removing the LED Board (3)
-
4.3.3  High Voltage Module1.Remove the Upper Housing / Printer Cover. (p.81)
2. Remove the C.B.P. M3 x 8 screw and remove the High Voltage Module Cover.
Figure 4-37. Removing the High Voltage Module Board (1)
Align the two tabs on the Upper Housing with the...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Removing the Boards 88
Confidential
3. Pull off the connector of the electrode cable from its terminal on the High Voltage 
Module Board with long-nose pliers or the like.
4. Disconnect the High Voltage Module cable from connector CN1 on the High 
Voltage Module Board.
5. Remove the C.B.P. M3 x 8 screw and remove the High Voltage Module Board.
Figure 4-38. Removing the High Voltage Module Board (2)
Wind the High Voltage Module cable...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Disassembling the Printer Mechanism 89
Confidential
4.4  Disassembling the Printer Mechanism4.4.1  APG Assy1.
Remove the Upper Housing / Printer Cover. (p.81)
2. Disconnect the APG Motor connector cable from connector CN18 (red) on the 
Main Board, and Remove the cable from the ASF Assy.
3. Disconnect the cables from the two APG Sensor connectors.
Figure 4-40. Disconnecting the Cables4. Remove the three C.B.S. M3 x 6 screws that...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Disassembling the Printer Mechanism 90
Confidential
4.4.2  CR Scale1.Remove the Upper Housing / Printer Cover. (p.81)
2. Release the Carriage Lock, and move the Carriage Unit to the center. 
(Refer to 4.1.6 Locking/Unlocking the Carriage and Opening/Closing the CDR 
Tray Base (p.73))
3. Pull the right end of the CR Scale in the direction of the arrow, and remove the CR 
Scale from the tab on the Right CR Shaft Mounting Plate.
4. Pull...