Epson R2000 Service Manual

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Disassembling the Printer Mechanism 101
Confidential
12. Remove the CR Drive Belt from the CR Motor Pinion Gear.
Figure 4-75. Removing the CR Drive Belt
13. Remove the four C.B.S. (P4) M3 x 6 screws that secure the CR Guide Plate, and 
remove it from the Main Frame.
Figure 4-76. Removing the CR Guide Plate14. Loosen the C.B.S. (P4) M3 x 8 screw that secures the Left Parallelism Adjust 
Bushing, and rotate the Bushing toward the front...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Disassembling the Printer Mechanism 102
Confidential
16. Lift the Carriage Shaft upwards, and remove the Carriage Shaft Spacer from the 
Carriage Shaft with tweezers.
Figure 4-79. Removing the Carriage Shaft Spacer
17. Rotate the Left CR Shaft Mounting Plate toward you to remove the Bushing on the 
Left CR Shaft Mounting Plate from the Carriage Shaft.
Figure 4-80. Removing the Left CR Shaft Mounting Plate18. Lift the Carriage Shaft...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Disassembling the Printer Mechanism 103
Confidential
20. Pull the Right CR Shaft Mounting Plate away from the tab on the Main Frame and 
rotate toward you.
Figure 4-84. Rotating the Right CR Shaft Mounting Plate21. Slide the Carriage Unit to the left side to prevent the CR Scale Cover from 
interfering with the rear of the Carriage Unit, slide the Carriage Shaft to the left 
side and pull out its right end from the Main Frame, and...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Disassembling the Printer Mechanism 104
Confidential
22. Turn the Belt Holder Mounting Plate in the direction of the arrow, and remove it 
from the Carriage Unit.
Figure 4-87. Removing the Belt Holder Mounting Plate23. Remove the Belt Holder from the Carriage unit.
Figure 4-88. Removing the Belt Holder
24. Release the CR Encoder Board Holder from the three Tabs to remove it from the 
Carriage Unit.
Figure 4-89. Removing the Belt...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Disassembling the Printer Mechanism 105
Confidential
25. Disconnect the Sensor FFC from the connector on the CR Encoder Board, pull out 
the Sensor FFC from the Carriage Unit, and remove the Carriage Unit.
Figure 4-90. Removing the Carriage Unit
When the Carriage Unit is removed from the Printer 
Mechanism, the CR Pad may drop off. In such case, correctly 
install it referring to the figure below.
Figure 4-91. Reinstalling the CR...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Disassembling the Printer Mechanism 106
Confidential
4.4.6  ASF Assy1. Remove the Printer Mechanism. (Refer to 4.4.4 Lower Housing / Printer 
Mechanism (p.96))
2. Remove the C.B.S. M3 x 8 screw that secures the Earth cables on the right rear 
side of the printer, and remove the Earth cables.
3. Disconnect the ASF Motor connector from the Relay connector.
4. Disconnect the Relay connector cable from the ASF Assy.
Figure 4-92. Releasing...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Disassembling the Printer Mechanism 107
Confidential
9. Remove the two C.B.S. M3 x 6 screws that secure the two Guide Roller LDs.
10. Gently pull the LD Roller Shaft to the rear of the printer, and remove the Guide 
Roller LDs.
Figure 4-95. Removing the Guide Roller LD11. Remove the three C.B.S. (P4) M3 x 8 screws that secure the ASF Assy, and 
remove the ASF Assy from the Printer Mechanism.
Figure 4-96. Removing the ASF Assy...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Disassembling the Printer Mechanism 108
Confidential
Align the guide pin and four Tabs on the ASF Assy with the 
positioning holes on the Main Frame so that there is no gap 
between the ASF Assy and the Main Frame.
Figure 4-97. Reinstalling the ASF Assy
Tighten the screws in the order shown in Figure 4-96.
Tab
Tab
Guide pins
Tab
Tab







After replacing or removing the ASF Assy, always make the required 
adjustments...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Disassembling the Printer Mechanism 109
Confidential
4.4.7  Front Paper Guide Pad1. Remove the Printer Mechanism. (Refer to 4.4.4 Lower Housing / Printer 
Mechanism (p.96))
2. Remove the Front Paper Guide Pads and Front Paper Guide Pad Protection from 
the Front Paper Guide with tweezers.
Figure 4-98. Removing the Front Paper Guide Pads and
the Front Paper Guide Pad Protection
Take care to prevent the grease contained on the...

EPSON Stylus Photo R1900/R2880/R2000Revision EDisassembly And Assembly Disassembling the Printer Mechanism 110
Confidential
4.4.8  Waste Ink Pad / Waste Ink Tube Left/Right1. Remove the Printer Mechanism. (Refer to 4.4.4 Lower Housing / Printer 
Mechanism (p.96))
2. Remove the C.B.P. M3 x 8 screw that secures the Ink Tube Holder, and remove 
the Ink Tube Holder.
3. Remove the 12 Waste Ink Pads from the Lower Housing.
4. Remove the Waste Ink Tube Left/Right from the Lower Housing.
Figure 4-101. Removing...