Digital Projection Titan Sx+-500 User Manual

Rev B          02/2007         page 7.5
Digital Projection TITAN sx+-500 User Manual 7. Appendix
Electrical
InputsRGB1, RGB2, DVI, SDI, Composite Video, S-Video, Component
Pixel clockup to 165MHz
Control inputs1 x LAN
1 x wifi LAN
1 x RS232 serial: 19200 baud, 8 bits, 1 stop bit, no parity
1 x remote control
Mains voltage100-230 VAC ±10%, 48-62Hz (single phase)
Power consumption750 W
International RegulationsMeets FCC Class B  requirements
Meets EMC Directives (EN 50081-1, EN 50082-1, EN 55022)
MeetsLow...

Rev B          02/2007         page 7.6
7. Appendix Digital Projection TITAN sx+-500 User Manual
Lens Data
105-607 105-608 105-609 105-610
throw ratio0.73 : 1 fixed 1.2 : 1 fixed 1.2 : 1 fixed 1.5 - 2.02 : 1 zoom
full DMD image width1.5m - 4.4m 2.5 - 12.4m 1 - 1.7m 2 - 16m
(4.9 - 13.4ft) (8.1 - 40.6ft) (3.3 - 5.4ft) (6.6 - 52.5ft)
throw distance1.1m - 3.2m 3 - 15m 1.2 - 2m 4 - 24m
(3.6 - 10.5ft) (9.8 - 49ft) (3.9 - 6.6ft) (13 - 79ft)
lens shift vertical*± 120 ± 525 ± 525 ± 525
(vs DMD height)± 0.11H ±...

Rev B          02/2007         page 7.7
Digital Projection TITAN sx+-500 User Manual 7. Appendix
105-611 105-612 105-613
throw ratio2.02 - 2.77 : 1 zoom 2.77 - 4.51 : 1 zoom 4.51 - 7.53 : 1 zoom
full DMD image width1.4 - 11.9m 2 - 16.3m 1.7 - 17.7m
(4.7 - 39ft) (6.6 - 53.3ft) (5.6 - 58.2ft)
throw distance4 - 24m 9.1m - 45m 12 - 80m
(13 - 79ft) (30 - 148ft) (39 - 263ft)
lens shift vertical*± 525 ± 525 ± 525
(vs DMD height)± 0.5H ± 0.5H ± 0.5H
lens shift horizontal*± 450 ± 450 ± 450
(vs DMD width)± 0.32W ±...

Rev B          02/2007         page 7.8
7. Appendix Digital Projection TITAN sx+-500 User Manual
Dimensions
All dimensions in mm
unless otherwise stated 

Rev B          02/2007         page 7.9
Digital Projection TITAN sx+-500 User Manual 7. Appendix
Input modes suppor ted
Signal Resolution Refresh Total Horizontal
Rate number of Frequency
( Hz ) lines (KHz)
SDTV 480i 720 x 480 60 525 15.73999 9
576i 720 x 576 50 625 15.63999 9
HDTV 480p 720 x 480 60 525 31.5199
576p 720 x 576 50 625 31.2599
720p50 1280 x 720 50 750 37.51999
720p60 1280 x 720 60 750 45.00999
1080psf24 1920 x 1080 48 1125 27.0099
1080p24 1920 x 1080 24 1125 27.0099
1080i50 1920 x 1080 50...

Rev B          02/2007         page 7.10
7. Appendix Digital Projection TITAN sx+-500 User Manual
NotesInput connections
1. RGB1 input
5 x 75 ohm BNC
Used for computer, progressive video and analog HD video.
RGsB RGBS RGBHV YCrCb
R R R Pr/Cr
G + Sync G G Y
B B B Pb/Cb
Sync H Sync
V Sync
2. RGB2 input
15 way D-type connector
All RGsB RGBS RGBHV YCrCb
1 R R R Pr/Cr
2 G + Sync G G Y
3 B B B Pb/Cb
4 ID2
5 Digital Ground
6 R Ground
7 B Ground
8 G Ground
9 N/C
10 Digital Ground
11 ID0
12 ID1
13 Sync H Sync
14...

Rev B          02/2007         page 7.11
Digital Projection TITAN sx+-500 User Manual 7. Appendix
3. DVI-D input
24 way D-type connector
1 TMDS Data 2-
2 TMDS Data 2+
3 TMDS Data 2 Shield
4 unused
5 unused
6 DDC Clock
7 DDC Data
8 unused
9 TMDS Data 1-
10 TMDS Data 1+
11 TMDS Data 1 Shield
12 unused
13 unused
14 +5 V Power
15 Ground
16 Hot Plug Detect*
17 TMDS Data 0-
18 TMDS Data 0+
19 TMDS Data 0+
20 TMDS Data 0 Shield
21 unused
22 unused
23 TMDS Clock Shield
24 TMDS Clock+
* Hot plug detect (HPD) is...

Rev B          02/2007         page 7.12
7. Appendix Digital Projection TITAN sx+-500 User Manual
4. SDI input
1 x 75 ohm BNC
SMPTE 292 / HD-SDI signals are very high speed digital signals which require
better quality coaxial cable than conventional analogue video. The data rate is 1.5
Gigabits per second.
In choosing cable length and connectors for any installation the frequency response
loss in decibels should be proportional to 1√f, from 1MHz, to 1.5GHz. The following
or similar cable specification...

Rev B          02/2007         page 7.13
Digital Projection TITAN sx+-500 User Manual 7. Appendix
Control connections
LAN connections
TCP Port number
10001
Wireless
802.11b/g
10BaseT Unshielded Twisted Pair cable
The standard wire colours as as follows:
1 White / Orange stripe
2 Orange
3 White / Green stripe
4 Blue
5 White / Blue stripe
6 Green
7 White / Brown stripe
8 Brown
Crossed cable
(used to connect directly to a computer with no hub or network.)
(Note that only the green and orange pairs are...

Rev B          02/2007         page 7.14
7. Appendix Digital Projection TITAN sx+-500 User Manual
Serial control input
1 unused
2 Received Data (RX)
3 Transmitted Data (TX)
4 unused
5 Signal Ground
6 unused
7 unused
8 unused
9 unused
Null-modem cable
(used to connect the projector to a computer)
RX 2 --- 3 TX
TX 3 --- 2 RX
GND 5 --- 5 GND
Serial port settings
•Baud rate 19,200 bps
•Data length 8 bits
•Stop bits one
•Parity none
•Flow control none
Notes
The projector is a DTE, so use:
•a straight cable to...