Digital Projection Titan Sx+-500 User Manual

Rev B          02/2007         page 7.15
Digital Projection TITAN sx+-500 User Manual 7. Appendix
Remote communications protocol
Version: Revision C 02/01/07
Introduction
This protocol document covers all projectors in the Titan series and also the
Lightning 30/40isx+.
Only one remote connection (RS232, LAN or Wireless LAN) should be used at any
one time.
Following the transmission of a command, the control system must wait to receive
the complete reply before sending a new command.
It should be noted...

Rev B          02/2007         page 7.16
7. Appendix Digital Projection TITAN sx+-500 User Manual
Operation Messages
Operation messages are constructed using the following format:
Header is always EFBEh  (byte 1  = BEh and byte 2 = EFh)
Type is always 03h for Operation Messages
Size is always 0019h (byte 4 = 19h  and byte 5 = 00h)   i.e. 25 bytes after CRC
CRC can be set to 5858h if you want the CRC to be ignored. However, the CRC
should ideally be calculated, as described in the Titan Projector Series...

Rev B          02/2007         page 7.17
Digital Projection TITAN sx+-500 User Manual 7. Appendix
Enhanced Messages
Enhanced messages are constructed using the following format:
Header is always EFBEh  (byte 0  = BEh and byte 1 = EFh)
Type is always 10h for Enhanced Messages
CRC can be set to 5858h if you want the CRC to be ignored. However, the CRC
should ideally be calculated, as described in the Titan Projector Series External
Control Protocol.
Size is always Data Length + 4 (4 bytes after CRC and...

Rev B          02/2007         page 7.18
7. Appendix Digital Projection TITAN sx+-500 User Manual
Operation Command examples
All operation commands are located at bytes 9 &10.
All values are located at bytes 17 & 18 unless otherwise indicated
Power  (0102)
Projector On or Standby
Value
On00h
Standby04h
Examples
Set Projector (On)
BEEF  03   1900  5858  01  0102  0000  00000000  00000000  00000000  00000000  00000000
Response
1E  BEEF  03  1900  5858  01  0102  0000  00000000  00000000  00000000  00000000...

Rev B          02/2007         page 7.19
Digital Projection TITAN sx+-500 User Manual 7. Appendix
Source  (3702)
Projector source select
Value
RGB100h
RGB201h
DVI02h
SDI03h
Composite04h
SVideo05h
Component06h
Examples
Set Source  (DVI)
BEEF  03  1900  5858  01  3702  0000  00000000  02000000  00000000  00000000  00000000
Response
1E  BEEF  03  1900  5858  01  3702  0000  00000000  02000000  00000000  00000000  00000000
Set Source  (SVideo)
BEEF  03  1900  5858  01  3702  0000  00000000  05000000...

Rev B          02/2007         page 7.20
7. Appendix Digital Projection TITAN sx+-500 User Manual
Brightness (E502)
Adjusts Brightness
Range: -128 — +127 (00h - FFh)
Centre (0): 128 (80h)
Examples
Set Brightness  97    (128 + 97 = 225  =  
E1h)
BEEF  03  1900  5858  01  E502  0000  00000000  E1000000  00000000  00000000  00000000
Response
1E  BEEF  03  1900  5858  01  E502  0000  00000000  E1000000  00000000  00000000  00000000
Get Brightness
BEEF  03  1900  5858  02  E502  0000  00000000  00000000...

Rev B          02/2007         page 7.21
Digital Projection TITAN sx+-500 User Manual 7. Appendix
Contrast (E602)
Adjusts Contrast
Range: -128 — +127 (00h - FFh)
Centre (0): 128 (80h)
Examples
Set Contrast  97    (128 + 97 = 225  =  
E1h)
BEEF  03  1900  5858  01  E602  0000  00000000  E1000000  00000000  00000000  00000000
Response
1E  BEEF  03  1900  5858  01  E602  0000  00000000  E1000000  00000000  00000000  00000000
Get Contrast
BEEF  03  1900  5858  02  E602  0000  00000000  00000000  00000000...

Rev B          02/2007         page 7.22
7. Appendix Digital Projection TITAN sx+-500 User Manual
Shutter  (CF02)
Closes and opens shutter
Target Value
(Set) (Get)
Shutter Close00h01h
Shutter Open01h00h
Examples
Set Shutter  (Close)
BEEF  03  1900  5858  01  CF02  0000  00000000  00000000  00000000  00000000  00000000
Response
1E  BEEF  03  1900  5858  01  CF02  0000  00000000  00000000  00000000  00000000  00000000
Set Shutter  (Open)
BEEF  03  1900  5858  01  CF02  0000  01000000  00000000  00000000...

Rev B          02/2007         page 7.23
Digital Projection TITAN sx+-500 User Manual 7. Appendix
COMMAND HEX DATA    (MESSAGE LENGTH = 32 BYTES)COMMENTSSwitch Projector On
BE EF 03 19 00 58 58 
01 01 02
 00 00 00 00 00 00 
00 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Switch Projector to Standby
BE EF 03 19 00 58 58 
01 01 02
 00 00 00 00 00 00 
04 00 00 00 00 00 00 00 00 00 00 00 00 00 00 00
Select RGB1 input
BE EF 03 19 00 58 58 
01 37 02
 00 00 00 00 00 00 
00 00 00 00 00 00 00 00 00 00 00 00 00 00...

Rev B          02/2007         page 7.24
7. Appendix Digital Projection TITAN sx+-500 User Manual