Digital Projection Titan 1080p-600, Reference 1080p, Titan 1080p-700, 1080p Ultra Contrast User Manual

Rev C August 2009 Page 2.19
Digital Projection TITAN 1080p-600/700, Reference, Ultra Contrast User Manual   2. Installation

Notes
 For more information about pin 
connections and control codes 
see section 7. Appendix.
 For more information about 
using a browser to control the 
projector see section 4. Using 
the menus.
Computer
Null-modem  
cable
Control connection examples
LAN connection
All of the projector’s features can be controlled via a LAN connection, using a 
standard internet browser...

Page 2.20  Rev C August 2009
2. Installation  Digital Projection TITAN 1080p-600/700, Reference, Ultra Contrast User Manual
Notes
 Use only the power cable 
provided.
 Ensure that the power 
outlet includes a Ground 
connection, as this 
equipment MUST be earthed.
 Handle the power cable 
carefully and avoid sharp 
bends. Do not use a damaged 
power cable.
Power connection
When mains power is first applied, the projector will perform a self-test, then go into 
Standby mode.
The Power indicator on the...

Rev C August 2009  Page 3.1
3. Getting Started
Contents
Switching the projector on ...............................................................................................................3.2
Selecting an input or test pattern ...................................................................................................3.2
Input ................................................................................................................................................3.2
Test pattern...

Page 3.2  Rev C August 2009
3. Getting Started Digital Projection TITAN 1080p-600/700, Reference, Ultra Contrast User Manual

Selecting an input or test pattern
Input
Press  or   to change to the next input up or down the following list:
1. RGB1
2. RGB2
3. DVI
4. SDI
5. Composite Video
6. S-Video
7. Component
Or press the numbered keys 1–7 to change directly to the input:
Test pattern
 If you have no video source connected to the projector, then you can display a test 
pattern as follows:
Press  on the...

Rev C August 2009 Page 3.3
Digital Projection TITAN 1080p-600/700, Reference, Ultra Contrast User Manual  3. Getting Started

Notes
 Each time a new lens is 
fitted	to	the	projector,	
the calibration procedure 
must be carried out. See 
Setup menu, in Section 4. 
Controlling the projector.
  For more detailed information 
about:
  - using the control keys on the 
remote control or keypad,
  - using the menus,
  see the next section: 
Controlling the projector.
 When any of the three Lens 
adjustment...

Page 3.4  Rev C August 2009
3. Getting Started Digital Projection TITAN 1080p-600/700, Reference, Ultra Contrast User Manual
Adjusting the projected image
Picture settings
Press a  key, followed by  and   to adjust these picture settings:
  Brightness   
 BRI 
Contrast   
 CON 
Saturation   
 SAT 
Phase   
 PHASE 
Aspect ratio   
 ASPECT
Geometry settings
Press Keystone  KEYST
followed by  and  to adjust the keystone correction.
Press Position  
 POS   (for all inputs except DVI)
followed by , ,  and...

Rev C August 2009  Page 4.1
4. Controlling the projector
Contents
Overview ...............................................................................................................................................4.4
Controlling the projector.....................................................................................................................4.4
Input modes and settings...

Page 4.2  Rev C August 2009
4. Controlling the projector Digital Projection TITAN 1080p-600/700, Reference, Ultra Contrast User Manual

Input menu .........................................................................................................................................4.18
Input Source ...................................................................................................................................4.18
Presets...

Rev C August 2009 Page 4.3
Digital Projection TITAN 1080p-600/700, Reference, Ultra Contrast User Manual  4. Controlling the projector

Control Panel Backlight ..................................................................................................................4.33
Component Video Sync ..................................................................................................................4.33
Keystone...

Page 4.4  Rev C August 2009
4. Controlling the projector Digital Projection TITAN 1080p-600/700, Reference, Ultra Contrast User Manual

Overview
Controlling the projector
The projector can be controlled from:
the remote control
the keypad
the RS232 input
the Ethernet input
For more information about controlling the projector using the RS232 and 
Ethernet inputs, see Remote communications protocol in  section 7. 
Appendix.
For information about how to connect the projector, see Connecting the 
projector...