compaq lte elite User Manual

-------------------------------------------------------
The PCMCIA slot is From non-Windows
disabled. environment: Select Security
Management from the
Configuration and
Diagnostics menu to enable
the PCMCIA slot.
From Windows environment:
Select Security Management
from the Compaq Control
Center to enable the PCMCIA
slot.
-------------------------------------------------------
Card or card driver is Contact Compaq Reseller
not PCMCIA compliant. Support for a list of PCMCIA
cards tested successfully in...

PCMCIA network Network driver is not Select Computer Setup from
card does not set up properly. the Compaq Control Center
work. and select the PCMCIA
option; then view the online
help for detailed
instructions on setting up
PCMCIA network cards.
===========================================================================
Problem Probable Cause Solution(s)
===========================================================================
Storage card does SRAM and flash memory Select Computer Setup from
not work....

===========================================================================
Computer is Computer has entered a Immediately save any open
beeping and low battery condition. file(s). Then do any one of
battery LED is the following:
flashing.
o Connect the computer to an
external power source,
then charge the battery
pack.
o Replace the battery pack
with a fully charged
battery pack.
o Initiate Hibernation
(press the Fn key and
standby button
simultaneously) to
completely halt the power
consumption on the...

of contacts.
-------------------------------------------------------
Defective system board. Replace system board.
---------------------------------------------------------------------------
Unit powers up Faulty AC power cord. Try another power cord.
from the battery
pack, but not
from AC power.
-------------------------------------------------------
Faulty cable connection Check the cable connection
from internal power from the internal AC power
supply. supply to the system board....

seconds.) part.
In addition, note that
the first three parts can
be checked by the user.
a. PCMCIA card
b. Battery pack
c. Hard drive
d. Diskette drive
e. Internal AC power
supply
2. Disconnect the display
cable from the system
board and power the unit
up. If the unit powers
up, the display cable or
display assembly has
failed. Plug the display
cable back into the
system board and attempt
to find the defective
part in the display
assembly by completing
the following steps one
at a time until the short...

===========================================================================
Problem Probable Cause Solution(s)
===========================================================================
Printer does not The device drivers for Install the correct printer
print. the application are not drivers for the application
installed. in the CONFIG.SYS file.
-------------------------------------------------------
Printer that is set up Connect the printer to the
for a network is not network.
connected to the...

Memory configuration is Reconfigure the memory using
not set up correctly. MS-DOS MEMMAKER.
-------------------------------------------------------
System ran out of memory 1. Check the application
for the application. documentation for memory
requirements.
2. Install additional
memory.
---------------------------------------------------------------------------
* TSRs (Terminate Stay Resident) are software routines that stay in RAM
memory even when not actively in use....

Table 2-32. Trackball/Mouse Problems
===========================================================================
Problem Cause Solution(s)
===========================================================================
Trackball or Incorrect or no device Install the device driver
mouse does not driver is installed. and add to the AUTOEXEC.BAT
work. file or CONFIG.SYS file.
-------------------------------------------------------
The device driver is not Install the Compaq mouse
installed in Windows. driver in...

-------------------------------------------------------
Bottom of trackball Place capton tape on bottom
board is shorting to of trackball board.
display shield.
-------------------------------------------------------
Display cable not Reseat cable.
properly seated in
trackball board.
-------------------------------------------------------
Display cable is torn, Replace display cable.
causing intermittent
open circuit.
-------------------------------------------------------
Defective trackball Replace...

IMPORTANT: Ensure that there is no diskette in the diskette drive and
that there are no PCMCIA cards in the PCMCIA slot.
4. Close the display and all exterior doors (external options, PCMCIA
compartment, memory, and hard drive).
5. Pack the computer with sufficient packing material to protect it. Use
the original packing box or similar packaging.