compaq lte elite User Manual

Screws
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>>

- Display cable
- Display latches
- Display clutches
- Display enclosure
4.10 Keyboard
4.11 Diskette drive and cable
4.12 Hard drive
- Hard drive security clips
4.13 Processor board
4.14 Power interface board (PIB)
4.15 PCMCIA ejector rails
4.16 Internal AC power supply
4.17 System board and I/O bracket
4.18 LED cable assembly
4.19 Computer base enclosure
4.20 PCMCIA compartment door
4.21 Battery pack/hard drive release latch assemblies
4.4 Preparation Procedures For Removal And Replacement 
Before...

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

Replacing the Battery Pack
To replace the battery pack, complete the following steps:
1. Insert the battery pack with the large label facing up and the battery
contacts facing the inside of the battery compartment.
2. Push firmly on the battery pack.
When released, it locks into place.
4.6 Memory Expansion Board 
Random access memory (RAM) can be added to the computer by installing a
memory expansion board. Refer to Section 1.6 and Table 3-2 for more
information on RAM expansion....

Removing the Memory Expansion Board
Before removing the memory expansion board, refer to Section 4.4,
Preparation Procedures for Removal and Replacement.
To remove the memory expansion board, complete the following steps:
1. Turn the unit display-side down.
2. Release the latch on the memory access cover (Figure 4-3).
3. Slide the cover in the direction indicated by the embossed arrow on the
cover and remove it.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

Installing the Memory Expansion Board
To install the memory expansion board, complete the following steps:
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>>

4.7 Keyboard Cover 
Before removing the keyboard cover, refer to Section 4.4, Preparation
Procedures for Removal and Replacement.
To remove the keyboard cover, complete the following steps:
1. Turn the unit display-side down.
2. Remove the five screws located on the bottom and the one screw (shorter
than the other five) located near the external options connector on the
rear panel (Figure 4-5). 

3. Carefully holding the unit together, turn it right-side up.
4. Open the display to its fully open position.
5. Tilt up the back edge of the keyboard cover [1] and lift while rotating
the cover toward you to release the front edge [2] (Figure 4-6). 

IMPORTANT: When replacing the keyboard cover, angle the front edge of the
keyboard cover into place at the front of the computer, ensuring
that the tabs on the keyboard cover correctly align with the
corresponding recesses on the computer. Gently press the rear
edge of the keyboard cover into place at the back of the
computer, and verify that the front edge is aligned. If the seam
between the computer and the keyboard cover is uneven, remove
the keyboard cover and realign the tabs and recesses.
4.8...

remove the auxiliary battery connector.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>