compaq lte elite User Manual

NOTE: To replace the inverter board on the 9.5-inch color TFT model,replace the entire display assembly (refer to Removing the Display 
Assembly in this section).
It is not necessary to remove the display assembly from the system unit to
remove the display inverter board. To remove the display inverter board, 
complete the following steps: 
1. Remove the display bezel (refer to Display Bezel in this section). 
2. Remove the backlight cable from the inverter board (Figure 4-13). 
3. Remove the display...

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

Display Cable
NOTE: To replace the display cable on the 9.5-inch color TFT model, replace
the entire display assembly (refer to Removing the Display Assembly
in this section).
It is not necessary to remove the display assembly to remove the display
cable. To remove the display cable, complete the following steps:
1. Remove the keyboard cover (Section 4.7).
2. Remove the display cable and the display ground cable from the system
unit by completing steps 2 and 3 as listed in Removing the Display
Assembly...

7. Remove the display cable.
NOTE: Figure 4-19 shows an exploded view of the display cable connections.
Display Latches
IMPORTANT: The display latches and latch buttons used on the display
enclosure are labeled L (left) and R (right) and are not
interchangeable. Check to make sure that you are installing the
display latches and latch buttons on the correct sides. When
removing the display latches and buttons, keep the left and
right parts separated to ease replacement.
It is not necessary to remove the...

3. Remove the display latches and springs from the latch compartments.
Display Clutches
To remove the display clutches, complete the following steps:
1. Remove the keyboard cover (Section 4.7).
2. Remove the display assembly (refer to Removing the Display Assembly in
this section).
3. Remove the display bezel (refer to Display Bezel in this section).
NOTE: Two screws that attach the bezel to the display enclosure also
attach the clutches to the display enclosure.
IMPORTANT: Before removing the two...

the factory. To prevent interference with the trackball when
the original trackball shield is reused, the tab for the
trackball shield must go back in its original position (above
or beneath the clutch). When replacing the trackball shield
with a new spare trackball shield (Table 3-11), the mounting
tab always goes beneath the clutch.
4. Remove the two remaining clutch screws (Figure 4-21).
5. Remove the display clutches [1] from the display assembly. (Figure 4-21)
Display Enclosure
NOTE: To replace the...

3. Remove the display bezel (refer to Display Bezel in this section).
4. Remove the display panel (refer to Display Panel in this section).
5. Remove the display inverter board (refer to Inverter Board in this
section).
6. Remove the trackball board (refer to Trackball Board in this
section).
7. Remove the display cable (refer to Display Cable in this section).
8. Remove the display latches (refer to Display Latches in this
section).
IMPORTANT: Before removing the screws for the clutches (step 9), note...

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>

Replacing the Keyboard
To replace the keyboard, complete the following steps:
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

front edge of the computer (Figure 4-24).
IMPORTANT: To ensure that the keyboard is reinstalled correctly, be sure
that the metal tabs on the keyboards front edge are properly
aligned (Figure 4-24). The two tabs on the outside [1] go in
the notches on top of the plastic edge at the front of the
computer. The three tabs in the middle [2] tuck underneath
the plastic edge.
4. Replace the two keyboard screws (Figure 4-24).
4.11 Diskette Drive And Cable 
The diskette drive cable connects to a LIF connector on...