compaq lte elite User Manual

parts compatibility, the spare display panel, inverter board, display
cable, and display enclosure for the 9.5-inch color TFT model come
preinstalled in the display assembly. To replace these parts, replace the
entire display assembly (color TFT model only).
If required, the trackball board may be replaced separately on the color
TFT model.
Removing the Display Assembly
To remove the display assembly, complete the following steps:
1. Remove the keyboard cover (Section 4.7)....

IMPORTANT: When replacing the cable into the ZIF connector, fully seat the
cable before closing the ZIF connector slide. Close the
connector slide by simultaneously pressing on both corners. When
closed, the insertion line on the cable should be even with the
top edge of the connector slide. If it is not, release the
connector and fully seat the cable.
4. Remove the display ground cable [1] from the ground clip [2] on the
input/output (I/0) bracket (Figure 4-9).
IMPORTANT: When replacing the display...

IMPORTANT: When replacing the display ground cable, ensure that it is fully
seated to prevent it from disconnecting from the ground clip.
5. Remove the four screws that attach the display clutches to the computer
(Figure 4-10).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

IMPORTANT: When replacing the display assembly, close the display and check
to ensure that the display latches align properly. If the
latches require a realignment, loosen (do not remove) the four
display clutch screws, align the latches, then reseat the
screws.
Display Bezel
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> WARNING >>>>>

1. Remove the display control slide(s) by lifting up on one of its ends
(Figure 4-11).
NOTE: The color STN display has two control slides (brightness and
contrast), while all other displays have only one control slide
(brightness).
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

(Figure 4-12) and continue unsnapping towards the bottom edge until the
bezel and enclosure are completely separated.
NOTE: A display bezel removal tool (Table 3-13) may be used to assist in
removing the display bezel.
Display Panel
NOTE: To replace the display panel on the 9.5-inch color TFT model, replace
the entire display assembly (refer to Removing the Display Assembly
in this section).
It is not necessary to remove the display assembly from the system unit to
remove the display panel. To remove the...

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

IMPORTANT: When replacing the display panel, replace (but do not tighten)
the display panel screws and position the panel as far to the
right of the display enclosure as the screws allow before
tightening them. This allows the light feedback circuit to
function properly to ensure proper display brightness. In
addition, ensure that one of the mounting tabs of the display
ground cable is connected beneath the display panel and is
attached by the lower-left display panel screw.
4. Carefully lift the display...

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> CAUTION >>>>>

IMPORTANT: When replacing the cable into the ZIF connector on the
black-and-white TFT display panel, fully seat the cable before
closing the ZIF connector slide. Close the connector slide by
simultaneously pressing on both corners. When closed, the
insertion line on the cable should be even with the top edge of
the connector slide. If it is not, release the connector and
fully seat the cable.
6. Lift the display panel out of the display enclosure.
Inverter Board
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> WARNING...