compaq lte elite User Manual

2478 - xx Advanced VGA BitBLT
test.
2480 - xx Advanced VGA Linedraw
test.
===========================================================================
Table 2-12. Audio Computer Checkup Error Codes
===========================================================================
Error Code Description Recommended Action
===========================================================================
3206 - xx Audio system internal Replace the system board.
error....

6002 - xx Network card transmit
failed. 1. Check interrupt type and
number setting.
2. Check media connection at
controller and MAU *.
3. Check media speed (4/16) and
type (UTP/STP **) settings.
4. Check MAU, cabling, or other
network components.
5. Replace controller.
===========================================================================
Error Code Description Recommended Action
===========================================================================
6014 - xx Ethernet configuration The...

locate the defective board by
completing the following steps:
a. Remove all network
controller boards.
b. Install one network
controller board.
c. Retest with Computer
Checkup.
d. Keep adding boards and
retesting (repeating steps
b and c) until the defective
board is located.
===========================================================================
Error Code Description Recommended Action
===========================================================================
6054 - xx Token Ring The following...

For example, with error code 6523-05, the first two-digit number of the
error code (65) indicates a disk problem (Table 2-14A). The second
two-digit number (23) indicates a random read (Table 2-14B). The last
two-digit number (05) indicates a seek failure (Table 2-14C). Thus, in this
example, the diagnostics program tested the random read functioning of the
hard drive and received a seek failure. The drive is faulty and must be
replaced.
NOTE: Refer to Chapter 7 for SCSI troubleshooting information....

tape cartridge.
2. Replace tape drive.
---------------------------------------------------------------------------
xxxx - 18 No data detected. Replace the indicated device.
---------------------------------------------------------------------------
xxxx - 21 Drive command aborted. Replace the indicated device.
---------------------------------------------------------------------------
65xx - 24 Media hard error. 1. Back up data and perform
Surface Analysis to
reallocate defect.
2. Replace drive....

---------------------------------------------------------------------------
xxxx - 54 BSY stayed busy. Replace the indicated device.
---------------------------------------------------------------------------
xxxx - 60 Controller CONFIG-1 Replace the indicated device.
register bad.
---------------------------------------------------------------------------
xxxx - 61 Controller CONFIG-2 Replace the indicated device.
register bad.
===========================================================================...

the computer malfunction against the problem description in the
troubleshooting tables to avoid a misdiagnosis.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> WARNING >>>>>

battery gauge.
-------------------------------------------------------
Battery pack was exposed Allow time for the battery
to temperature extremes. pack to return to room
temperature.
-------------------------------------------------------
Battery pack is at end Install another battery
of its life. pack. If this fixes the
problem, original battery
is no longer functional.
-------------------------------------------------------
Battery contacts not Remove the keyboard cover
making good contact with and...

Battery charge Power conservation is Set a power conservation
does not last as disabled or set to level. (Section 1.10).
long as expected. None.
-------------------------------------------------------
An external device or Turn off or remove the
PCMCIA card is draining external device when not
the battery. using it.
---------------------------------------------------------------------------
Battery pack is Normal warming has No action is required.
warm to the touch occurred due to
after charging....

Table 2-18. Diskette/Diskette Drive Problems
===========================================================================
Problem Probable Cause Solution(s)
===========================================================================
Diskette drive Diskette is damaged. Run CHKDSK on the diskette.
LED stays on. At the system prompt, type:
CHKDSK A:
-------------------------------------------------------
Software program is Check the program diskettes.
damaged....