compaq lte 5000 User Manual

5. Remove the screws [1] and lift out the docking lever cover [2]
(Figure 6-37). 

6. Remove the docking lever cover insert [3] as shown in Figure 6-37.
Reverse the above procedures to install the docking lever, docking lever
slider, or docking lever cover.
Chapter 6.20 Security Lock Bracket 
The security lock bracket simply slides into its mounting seat on the side
of the expansion base. To remove and install the security lock bracket,
complete the following steps:
1. Prepare the expansion base for disassembly as described in Section 6.3.
2. Remove the bottom cover assembly as...

Chapter 7. MultiBay ISA Expansion Base: Removal and 
Replacement Procedures 
 
Chapter 7.0 Introduction 
This chapter presents the removal and replacement procedures for the
MultiBay ISA Expansion Base.
Chapter 7.1 Serial Number 
The expansion base serial number should be reported to Compaq when
requesting information or ordering spare parts. The serial number is
displayed on the rear of the expansion base to the right of the auxiliary
fan.
Chapter 7.2 Disassembly Sequence Chart 
Use the chart in Figure...

Chapter 7.3 Preparing the MultiBay ISA Expansion Base For Disassembly 
NOTE: It is important that these instructions be followed when installing
a new expansion base top cover (Service Spare Part Number
213711-003).
1. Remove the plastic hole cover from the left corner of the top cover.
2. Insert the fan (which is included with the new top cover) in the open
space.
3. Plug the fan electrical connector to the I/O board, adjacent to the
power supply.
Before beginning removal and replacement procedures,...

5. Remove any PC Cards (section 7.3.4).
7.3.1 Undocking the Computer
See Section 5.3.1 for instructions on how to undock the computer from the
expansion base.
7.3.2 Disconnecting the Expansion Base
1. Turn off the expansion base and undock the computer if it is docked in
the expansion base. See Section 5.3.1 for detailed instructions.
2. Disconnect the power cord from the AC source and from the expansion
base.
3. Disconnect all peripheral devices from the expansion base.
4. Complete the preparation for...

All battery packs should be removed from the expansion base before
performing any internal maintenance.
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>> WARNING >>>>>>

2. Move the sliding panel on the front of the battery to the left.
Installing a Battery Pack
To install a battery pack into a MultiBay, complete the following steps:
1. With the label facing up and the connectors facing in, align the left
side of the battery pack with the left side of the MultiBay, and push
the battery pack into the MultiBay until it is seated.
2. Move the sliding panel on the front of the battery pack to the right to
cover the MultiBay opening.
7.3.4 Mass Storage Devices
Removing a Mass...

2. If the mass storage device is a diskette drive or CD-ROM drive, remove
the diskette or CD from the drive.
3. Push the MultiBay device release button [1] and remove the device
[2] from the bay (Figure 7-5).
Installing a Hard Drive
Only hard drives that are configured for use as a secondary drive can be
used in MultiBay II of the expansion base. Drives without secondary drive
capability can be used only in MultiBay I of the expansion base. These
drives are labeled appropriately. See Appendix C of this...

1. Turn off the expansion base.
2. Make sure the latch inside the carrier is pushed to the right, and
place the hard drive in the carrier with the label facing up and the
contacts facing the rear of the carrier.
3. Slide the drive toward the rear of the carrier until it is seated
(Figure 7-6).
4. Push the latch inside the carrier to the left to secure the hard drive
in place.
5. Align the left side of the carrier with the left side of the MultiBay,
and push the carrier into the bay until it is seated....