compaq lte 5000 User Manual

3. Remove the bottom cover as described in Section 7.5.
4. Note the routing of all cables and disconnect the power supply cable
[1], the auxiliary fan cables [2], [3], the power supply fan cable [4],
the IrDA cable [5] , the speaker cables [6], [8], and the power cable
[7] (Figure 7-18). 

5. Remove the screws from the main board and the two screws from the CPU
connector bezel (Figure 7-19). 

6. Lift the main board out of the base. Begin lifting at the front edge of
the board [1]. The CPU connector bezel [2] comes off with the board but
is not attached to the board. Some manipulation is required around the
PC Card door module (Figure 7-20). 

7. To remove the auxiliary fan, release the fan mounting clips and remove
the fan from the bottom cover. (Figure 7-21) 

Reverse the removal procedure described above to install the main board.
Position the CPU connector cover in place but do not secure it with screws
until the main board is properly seated. Then proceed with the rest of the
installation.
Chapter 7.9 CPU Connector Bezel 
The main board must be removed to remove and replace the CPU connector
bezel. See Section 7.8 for details.
Chapter 7.10 MultiBay Assembly 
The main board must be removed before removing a MultiBay assembly.
The MultiBay assembly is spared...

2. Begin lifting at the end of the assembly toward the MultiBay Connector
Board and lift the MultiBay assembly out (Figure 7-23). 

Reverse the above procedure to install a MultiBay assembly, inserting the
end nearest the MultiBay door first (Figure 7-24). Take care not to damage
the tabs on this end of the MultiBay. 

Chapter 7.11 MultiBay Door 
The main board and one of the MultiBays must be removed before removing
the MultiBay door assembly. To remove a MultiBay door assembly, complete
the following steps:
1. Prepare the expansion base for disassembly as described in Section 7.3.
2. Remove the bottom cover assembly as described in Section 7.5.
3. Remove the power supply as described in Section 7.7 if servicing the
door on that side.
4. Remove the main board as described in Section 7.8 if servicing the door
on that...

Chapter 7.12 PC Card Door Assembly 
The main board must be removed before removing the PC Card door assembly.
The PC Card doors are spared as an assembly, mounted in a common frame. To
remove and replace the PC Card doors, complete the following steps:
1. Prepare the expansion base for disassembly as described in Section 7.3.
2. Remove the bottom cover assembly as described in Section 7.5.
3. Remove the main board as described in Section 7.8.
4. Remove the three screws and lift the PC Card door module...

Reverse the above procedure to install the PC Card door assembly.
Chapter 7.13 Power Switch Board 
The bottom cover assembly must be removed before removing the power switch
board. The power switch board is installed as a unit with its cable
permanently attached.
To remove the power switch board, complete the following steps:
1. Prepare the expansion base for disassembly as described in Section 7.3.
2. Remove the bottom cover as described in Section 7.5.
3. Disconnect the power switch board cable and...