compaq lte 5000 User Manual

4. Remove the screw holding the power switch board in place and lift the
board out (Figure 7-28). 

Reverse the above procedure to install a power switch board.
Chapter 7.14 IrDA Board 
The bottom cover assembly must be removed before removing the IrDA board.
The IrDA board is installed as a unit with its cable permanently attached.
To remove the IrDA board, complete the following steps:
1. Prepare the expansion base for disassembly as described in Section 7.3.
2. Remove the bottom cover assembly as described in Section 7.5.
3. Disconnect the IrDA board cable and ground wire from the main board
(Figure...

4. Remove the screw holding the IrDA board in place and lift the board out
(Figure 7-30). 

Reverse the above procedure to install the IrDA board.
Chapter 7.15 Speaker Assemblies 
The bottom cover assembly must be removed before removing the speaker
assemblies. The speaker assemblies are installed as a unit with their
cables permanently attached.
To remove the speaker assemblies, complete the following steps:
1. Prepare the expansion base for disassembly as described in Section 7.3.
2. Remove the bottom cover assembly as described in Section 7.5.
3. Note the cable routing and disconnect the...

Reverse the above procedure to install a speaker assembly, paying
particular attention to the cable routing.
Chapter 7.16 Alignment Guides 
The bottom cover assembly must be removed before removing the alignment
guides. The alignment guide assembly consists of the guide, spring, and
bracket.
IMPORTANT: The left alignment guide and right alignment guide are keyed
for proper installation.
The assembly is mounted to the expansion base with one screw. To remove
the CPU guide assembly, complete the following...

4. Remove the CPU guide while guiding the spring out of its seat in the
side panel of the expansion base (Figure 7-32).
Reverse the above procedure to install the CPU guide. Install the spring
in its seat first and make certain it is seated completely. Do not over
tighten the screw; the guide must be free to slide under the screw head.
Chapter 7.17 Monitor Support Cover Cap 
The bottom cover must be removed before removing the monitor support cover
cap. The monitor support cover cap and spring snap into...

Reverse the above procedure to install the monitor support cover cap.
Chapter 7.18 Docking Mechanism 
The bottom cover assembly must be removed before removing the docking
mechanism. The docking mechanism consists of the:
o Docking lever
o Docking lever cover
o Docking lever shield
o Slide block
o Docking bar
o Docking bar bushing
o Puller plate assembly
o Spring
To remove the docking mechanism, complete the following steps: 

1. Prepare the expansion base for disassembly as described in Section 7.3.
2. Remove the bottom cover assembly as described in Section 7.5.
3. Remove the main board as described in Section 7.8.
4. Remove the screw and washer [1] that connects the docking bar [2] to
the puller plate assembly [3] (Figure 7-34)
5. Lift the docking bar [1] and its bushing [2] out of the assembly
(Figure 7-35). 

6. Remove the screw from the spring and lift the spring out (Figure 7-36). 

7. To remove the puller plate assembly [1], see Figure 7-37 and complete
the following steps:
a. Slide the puller plate all the way back [2].