compaq lte 5000 User Manual

side of the MultiBay and push the drive into the bay until it is
seated.
7.3.5 PC Card
All PC cards should be removed from the expansion base before performing
any internal maintenance on the computer.
Removing a PC Card
To remove a PC Card, complete the following steps:
1. Push the PC Card release button [1]. The card [2] ejects out of the
card slot (Figure 7-7).
2. The PC Card door automatically closes after removing the card.
Installing a PC Card
To install a PC Card, complete the following steps:
1....

2. Place the PC Card in the tracks with the card connector to the inside
and label up.
3. Slide the card in until it seats. The door remains open while the card
device is connected.
Chapter 7.4 Expansion Base Feet 
The feet for the expansion base are rectangular, adhesive-backed rubber
pads. Install the feet by removing the protective covering from the
adhesive back and placing the feet in their positions on the bottom of the
expansion base (Figure 7-8).
Chapter 7.5 Bottom Cover Assembly 
The bottom...

o Labels
The feet are also spared separately. Feet installation is described in
Section 7.4. The feet, labels, and ISA expansion cover are preinstalled.
To remove the bottom cover assembly, complete the following steps:
1. Prepare the expansion base for disassembly as described in
Section 7.3.
2. Place the expansion base face down on the work surface and remove the
two screws that secure the ISA expansion cover to the bottom cover
(Figure 7-9).
3. Remove the ISA expansion cover (Figure 7-10) 

4. Remove the one screw in the center of the shield on the bottom cover,
remove the shield by sliding it forward and lifting it off the
retaining clips, and then remove the remaining ten screws that secure
the bottom cover to the expansion base (Figure 7-11). 

5. Lift the bottom cover off the expansion base (Figure 7-12). 

6. To remove the ISA connector board, remove the two screws, and remove
the board (Figure 7-13). 

To install the bottom cover assembly, reverse the procedure presented
above.
Chapter 7.6 MPEG Connector 
The MPEG connector plugs into the main board and is accessed by removing
the bottom cover assembly. Remove the bottom cover assembly as described
in Section 7.5 and disconnect the MPEG connector from the main board as
shown in Figure 7-14. 

Reverse this procedure to install the MPEG connector.
Chapter 7.7 Power Supply 
The power supply is mounted in the right rear corner of the expansion base
when viewed with the base placed top side down on the work surface. It is
replaced as an assembly with its fan.
To remove the power supply, complete the following steps:
1. Prepare the expansion base for disassembly as described in Section 7.3.
2. Remove the bottom cover assembly as described in Section 7.5.1.
3. Disconnect the power supply from the...

5. Note the routing of the ground wires attached to the rear power supply
screws. Remove the three screws and lift the power supply out
(Figure 7-16). 

To install the power supply, reverse the procedure presented above. Be
sure to reconnect the ground wire.
Chapter 7.8 Main Board 
To remove the main board, complete the following steps:
1. Prepare the expansion base for disassembly as described in Section 7.3.
2. Remove the two shoulder screws from the computer connector as shown in
Figure 7-17.