compaq lte 5000 User Manual

side of the MultiBay and push the drive into the bay until it is
seated.
6.3.5 PC Card
All PC cards should be removed from the expansion base before performing
any internal maintenance on the computer.
Removing a PC Card
To remove a PC Card, complete the following steps:
1. Push the PC Card release button [1]. The card [2] ejects out of the
card slot (Figure 6-7).
2. The PC Card door automatically closes after removing the card.
Installing a PC Card
To install a PC Card, complete the following steps:
1....

2. Place the PC Card in the tracks with the card connector to the inside
and label up.
3. Slide the card in until it seats. The door remains open while the card
device is connected.
Chapter 6.4 External Components 
This section describes the removal and replacement procedures that do not
require access to the internal components of the expansion base. This
includes:
o Feet
o MPEG Connector Door
6.4.1 Expansion Base Feet
The feet [1] for the expansion base are rectangular, adhesive-backed
rubber pads....

6.4.2 MPEG Connector Door
The MPEG connector door [2] provides visual access to the MPEG connector
for guiding the connector into place when installing the bottom cover
assembly with the connector attached to the bottom cover (Figure 6-8).
Procedures presented later in this manual prescribe separating the MPEG
connector from the bottom cover at disassembly and not removing the MPEG
connector door.
If you choose to leave the MPEG connector attached to the bottom cover,
you should remove the MPEG connector...

3. Lift the bottom cover from the expansion base (Figure 6-10). 

To install the bottom cover assembly, reverse the procedure presented
above.
Chapter 6.6 MPEG Connector 
The MPEG connector plugs into the main board and is accessed by removing
the bottom cover assembly. Remove the bottom cover assembly as described
in Section 6.5 and disconnect the MPEG connector from the main board as
shown in Figure 6-11. 

Reverse this procedure to install the MPEG connector.
Chapter 6.7 Power Supply 
The power supply is mounted in the right rear corner of the expansion base
when viewed with the base placed top side down on the work surface. It is
replaced as an assembly with its fan.
To remove the power supply, complete the following steps:
1. Prepare the expansion base for disassembly as described in Section 6.3.
2. Remove the bottom cover assembly as described in Section 6.5.1.
3. Disconnect the power supply from the...

5. Note the routing of the ground wires attached to the rear power supply
screws. Remove the four screws and lift the power supply out
(Figure 6-13). 

To install the power supply, reverse the procedure presented above. Be
sure to reconnect the ground wire.
Chapter 6.8 Main Board 
To remove the main board, complete the following steps:
1. Prepare the expansion base for disassembly as described in Section 6.3.
2. Remove the two shoulder screws from the computer connector as shown in
Figure 6-14. 

3. Remove the bottom cover as described in Section 6.5.
4. Note the routing of all cables and disconnect the power cable [1],
speaker cables [2], IrDA cable [3], power supply cable [4], and cable
[5] (Figure 6-15). 

5. Disconnect the fan [1] and fan power [2] at the Fan Control Board
(Figure 6-16).