compaq lte 5000 User Manual

1. Remove the CPU cover as described in Section 5.5.1.
2. Remove the keyboard screws (Figure 5-37).
3. Remove the screws [1] from the rear corners of the keyboard
(Figure 5-38). Note that ground lugs are attached by these screws. 

4. Remove the microphone [2] (Figure 5-38). You can leave it attached to
its extension cable.
5. Separate the keyboard from the base and shift it slightly to gain
better access to the keyboard ZIF connector [1] (Figure 5-39), then
disconnect the ZIF connector. 

6. Disconnect the EasyPoint II controller cable [2] from the system board
(Figure 5-39).
7. Lift the keyboard out.
Reverse this procedure to install the keyboard.
NOTE: Be sure to connect the ground lugs at the rear of the keyboard.
5.9.2 Removing and Installing the EasyPoint II Controller
To remove the EasyPoint II controller, complete the following steps:
1. Remove the keyboard as described in Section 5.9.1.
2. Remove the two screws from the EasyPoint II controller
(Figure 5-40). 

3. Disconnect the cable from the ZIF connector on the EasyPoint II
Controller (Figure 5-41). The ZIF connector is located on the back side
of the controller board. 

NOTE: Observe the dressing of the EasyPoint II controller cables. It may
be necessary to use adhesive tape to maintain the cables in their
proper orientations.
Reverse the above procedure to install the EasyPoint II controller.
5.9.3 Removing and Installing the Battery Release Assembly
To remove the battery release assembly, complete the following steps:
1. Remove the keyboard as described in Section 5.9.1.
2. Remove the two screws [1] from the release holder [3] (Figure 5-42). 

3. The release holder, spring, and latch are installed as an assembly.
Lift out the release holder [3] (Figure 5-42). The battery release [2]
is attached to the release holder with its spring [4].
Reverse the above procedure to install the battery release assembly. Use
the locating pins adjacent to each mounting hole to locate the release
holder properly.
NOTE: At reassembly, make certain that the spring on the battery release
is not trapped between the release holder and side plastic. The
spring should...

5.9.4 Removing and Installing the MultiBay Release Assembly
To remove the MultiBay release assembly, complete the following steps:
1. Remove the keyboard as described in Section 5.9.1.
2. Remove the standoff [1] from the CD-ROM eject bar [2] and lift out the
eject bar (Figure 5-44). 

3. Remove the standoff and screw from the release holder (Figure 5-45). 

4. Lift out the release holder (Figure 5-45). The release is attached to
the holder with its spring.
The release holder, spring and latch are installed as an assembly.
Reverse the above procedure to install the MultiBay release assembly. Use
the locating pins adjacent to each mounting hole to locate the release
holder properly.
NOTE: At reassembly, make certain that the spring on the MultiBay release
is not trapped between the release holder and side plastic. The
spring should be below the holder....

5.9.5 Removing and Installing the Hard Drive Latch
The hard drive latch assembly consists of the hard drive release, latch,
and spring. It is held in place with one screw. To remove and replace the
hard drive latch, complete the following steps:
1. Remove the keyboard as described in Section 5.9.1.
2. Remove the hard drive security screw (Figure 5-47)