Canon scanner imageFORMULA DRX10C User Manual

3-21
Chapter 3   Basic Operation
7.Clearing a Paper Jam or Double Feed Error
If a paper jam or double feed occurs during scanning, a paper jam message appears on the PC and on the scanner’s display panel. 
Use the following procedure to clear the paper jam.
CAUTION
 When removing jammed paper, take care not to cut your hands on the edges of the paper
 Make sure to remove all of the jammed paper. Torn paper remaining in the scanner may cause future jams or damage to the scanner.
 When opening and closing...

3-22
Chapter 3   Basic Operation
IMPORTANT
The Rapid Recovery System setting in the ISIS/TWAIN driver 
causes the following process to occur after a paper jam. (See 
“[Rapid Recovery System] Check Box” on p. 8-17.)
 When the Rapid Recovery System is disabled, images 
scanned before the paper jam occurs are saved as files, 
scanning finishes, finished and an error message is displayed. 
In this case, restart scanning from the document page where 
the paper jam occurred, or from the beginning.
 When the...

3-23
Chapter 3   Basic Operation
 When the Rapid Recovery System is enabled, scanning pauses 
when a double feed is detected, and the following error message 
is displayed.
■When the Rapid Recovery System is Disabled
Return the document pages ejected as a result of double-
feed detection to the top of the document stack yet to be 
scanned, and resume scanning.
■When the Rapid Recovery System is Enabled
1.Check the rejected document page(s).
Hint
 If attached paper, such as a label on the document page,...

Chapter 4   Other Functions
1. Other Functions and Settings .......................... 4-2
2. Function Description ........................................ 4-4
3. User Mode ....................................................... 4-9
User Mode Operating Procedure ..........................4-9
4. User Mode Functions..................................... 4-11 

4-2
Chapter 4   Other Functions
1.Other Functions and Settings
The following DR-X10C functions are grouped together as Other Functions. For details, refer to the indicated pages.
Operation/Setting Method
Applicable Page
Panel Operation User Mode ISIS/TWAIN
SCSI Speed –✔– p. 4-12
USB Short Packet –✔– p. 4-12
Auto USB Power Switch –✔– p. 3-2,  p. 4-13
Imprinter (Optional) – –✔ p. 4-8,  p. 8-25
Imprinter Test –✔– p. 4-14,  p. 5-20
Counter (Total Counter) –✔– p. 4-13
Count (Roller Counter) –✔– p. 4-13...

4-3
Chapter 4   Other Functions
Hint
 The Operation/Setting Methods are as follows:
Panel Operation: The operation or setting is performed using the control panel keys.
User Mode: The scanner function setting is made as a User Mode selection.
ISIS/TWAIN: The function is an ISIS/TWAIN driver scanning setting.
CapturePerfect: The function can be set by the CapturePerfect 3.0 or other compatible application program. 
 The page count for the Verify Scan operation is entered using the control panel keys, and...

4-4
Chapter 4   Other Functions
2.Function Description
The Other Functions are described below. See “User Mode” on p. 4-9, for descriptions of the functions set from the User Mode.
■Count-Only Mode
Counts the number of loaded document sheets by simply 
feeding them through the scanner.
Hint
The Count-Only mode is executed by the Count Only key on the 
control panel, and can be used to count document sheets even 
when no computer is connected.
1.Place the documents into the tray.
2.Press the Count Only...

4-5
Chapter 4   Other Functions
3.Press the Start Key to start scanning.
“Verifying…” is displayed.
Hint
If the specified count is exceeded while scanning, or if the 
scanned count does not reach the specified count when 
scanning is finished, an error is displayed.
The specified count is exceeded while scanning
Scanning finishes without reaching the specified count
■Double-Feed Detection Function
The scanner can detect double feeds. Two detection 
methods are used: comparison of document lengths, and...

4-6
Chapter 4   Other Functions
IMPORTANT
 Ultrasonic double-feed detection works only when the 
document pages overlap by at least two inches (50 mm).
 If documents stick together due to static electricity, Ultrasonic 
Double-Feed Detection may not function correctly.
 If the presence of adhesive notes or labels on pages is 
detected as a double feed and you do not want to remove 
them for scanning, a non-detection zone can be specified in 
the ISIS/TWAIN driver settings. (See “Double Feed Detection”...

4-7
Chapter 4   Other Functions
■Selectable Background
You can specify whether the background behind the 
scanned image is black or white. 
The background is changed by rotating the platen rollers to 
expose either the black or white part of the rollers, 
according to the selection specified in the ISIS/TWAIN 
driver. 
IMPORTANT
Image processing performance depends on the selected 
background (black or white). (See “Background Color” on 
p. 8-18.)
■Folio Scan
Use Folio Scan to scan very large documents...