Canon Pixma Mp630 User Guide

							(A) To load four photos on the Platen Glass
(B) To load two photos on the Platen Glass
 Note
 Place the photo(s) at least 0.4 inches / 10 mm away from and in square with the edges ofthe Platen Glass.
 When loading two or more photos at the same time, place them at least 0.4 inches / 10 mm
apart from each other. If photos are placed closer, they may be scanned as a singleimage.
 The Skew Correction function automatically compensates for photos placed at an angle of
up to approximately 10 degrees.
 Slanted photos with a long edge of 7.1 inches / 180 mm or more cannot be corrected.
 If  appears on the preview screen, check the followings and reset the photos properly
to scan them again.
- The slant is not too large.
- The photos are not placed too close to the edge of the Platen Glass.
 Photos smaller than approximately 1 inch / 25 mm square will not be scanned properly.
 The types of photos listed below may not be scanned properly.
- Photos that are non-rectangular or irregular shaped (such as cut out photos)
- Photos that are entirely white
- Photos that have white surrounds
 The borders of bordered photos may not be scanned properly. Crop photos if necessary.
Refer to the on-screen manual: Advanced Guide.
(3) Close the Document Cover gently, and press the OK button.
The machine starts scanning.
 Important
 The photos are rescanned before printing starts. Do not open the Document Cover or move the
loaded photos until printing is completed.
3.Specify the number of copies.
(1)  Make sure that Select and print  is selected, and press the OK button.
 Note
 You can also select useful printing functions other than Select and print.
See Using Various Functions.
(2) Use the Easy-Scroll Wheel or the  (Left) or  (Right) button to display a
photo to print.
(3) Press the [+] or [-] button to specify the number of copies.
 Note
Page 31 of 805 pages Reprinting Printed Photos
 
						

							 If  appears next to the photo on the screen, it may not have been scanned properly.
Press the 
Back button, and press the left Function button to select Rescan. Confirm the
message, and repeat the procedures from step 2 to scan the photo again.
Other options
 To change the display of photos, see Changing the Display.
(You can also select Full-screen display and Enlarged display besides Normal screen
display.)
 To crop a part of photo (Trimming), see Cropping a Part of Photo / Searching Photos by a
Specified Date.
(4) Repeat the procedures of (2) and (3) to specify the number of copies for each
photo.
(5) Press the OK button.
4.Start printing.
(1) Confirm the page size, media type, print quality, etc.
Here we confirm that 4x6 (10x15cm) is selected for Page size and the type of loaded photo paper forMedia type.
 Note
 To change the settings, select each item, and press the OK button. See Setting Items.
 The settings of the page size, media type, print quality, borderless print, image correction,
etc. are retained, and these settings will appear next time when the Easy photo reprint
menu is selected even if the power is turned off and on.
(2) Confirm the number of sheets to be used for printing the selected photos.
 Note
 You can correct photos automatically or manually, if you press the left Function button to
select Advanced. 
See Using Various Functions.
(3) Press the Color button to print in color, or the Black button to print in black &
white.
The machine starts printing.
Remove the photos on the Platen Glass after printing is completed.
 Note
 Press the Stop button to cancel printing.
 You can exit the Easy photo reprint menu and select another menu, if you press the HOME
button after printing is completed. Confirm the message and select Yes to delete the scannedimage data.
      
Page top
Page 32 of 805 pages Reprinting Printed Photos
 
						

							Advanced Guide  Troubleshooting
Contents > Printing Photos from Printed Photos > Using Various Functions
Using Various Functions 
This section describes a few of the useful functions in the Easy photo reprint menu.
For details, refer to the on-screen manual: 
Advanced Guide.
 Printing Photos in Various Layouts 
You can select a layout and print photos other than Select and print.
Sticker printPrint all photos
 Correcting Images 
You can correct images by pressing the left Function button when Advanced appears at the bottom of the
screen. You can correct images automatically or manually, such as adjusting brightness, contrast, and
color hue, or apply the fade restoration.
BrightnessContrast
      
Page top
Page 33 of 805 pages Using Various Functions
 
						

							Advanced Guide  Troubleshooting
Contents > Scanning
Scanning 
You can send scanned data to your computer, edit or process them with the supplied software
application, then save them. You can also save scanned data on a USB flash drive or memory card
inserted into the machine.
Saving Scanned Data
Saving the Scanned Data on the USB Flash Drive
Inserting the USB Flash Drive
Removing the USB Flash Drive
      
Page top
Page 34 of 805 pages Scanning
 
						

							Advanced Guide  Troubleshooting
Contents > Scanning > Saving Scanned Data
Saving Scanned Data 
You can save the scanned documents or photos on a USB flash drive, a memory card, or a computer
using the Operation Panel on the machine. You can also scan originals using your computer.
This section describes the operation to scan documents and save them on the USB flash drive in PDF
data.
For other operations, refer to the on-screen manual: Advanced Guide. You can find the detailed
procedures to correct scanned images or print them with various settings.
 Important
 We recommend that you make a backup of the data on the memory card or USB flash drive
regularly and save it on other storage media, in case of accidental loss.
 Please note that Canon shall not be liable for any damage or loss of the data for any reason
whatsoever, even within the warranty period of the machine.
 Saving the Scanned Data on the USB Flash Drive 
1.Prepare for using a USB flash drive.
(1) Turn on the power.
See Operation Panel.
(2) Insert a USB flash drive into the Direct Print Port.
See Inserting the USB Flash Drive.
2.Select the scan operation.
(1) Select Scan  on the HOME screen, and press the OK button.
(2) Use the Easy-Scroll Wheel or the  (Left) or  (Right) button to select USB
flash drive , and press the OK button.
The operation selection screen appears.
(3) Use the Easy-Scroll Wheel or the  (Left) or  (Right) button to select Save to
USB flash , and press the OK button.
The scan settings screen appears.
3.Specify the scan settings.
(1) Confirm the document type, scan size, scan resolution, etc.
Here we confirm that Document is selected for Document type, A4 for Scan size, and PDF for Data format.
To change the settings, use the 
Easy-Scroll Wheel or the  (Up) or  (Down) button to select the item to
change, and press the OK button.
 Note
 For details on the settings and Advanced of the Function button, refer to the on-screenmanual: Advanced Guide.
 When PDF is selected, up to 100 pages can be saved in one file.
Page 35 of 805 pages Saving Scanned Data
 
						

							(2) Select Next, and press the OK button.
4.Start scanning.
(1) Confirm the message, press the OK button, then load an original on the Platen
Glass.See Loading Originals to Copy or Scan.
 Note
 The sizes of originals that can be scanned are A4, 8.5x11 (LTR), 4x6 (10x15cm), and
5x7 (13x18cm).
(2) Press the Color button for color scanning, or the Black button for black & white
scanning.
The machine starts scanning.
(3) Check the preview of the scanned data on the screen.
 Note
 The preview screen will not appear if Preview OFF is selected in Advanced in the
procedure of (1) in step 3. 
 To rescan the original, press the left Function button to select Rescan. Confirm the
message and scan the original again.
 To rotate the scanned data 90 degrees clockwise, press the right Function button to
select Rotate.
(4) Press the OK button to save the scanned data.
The message End scanning? appears when scanning is completed.
(5) Select End, and press the OK button.
Remove the original on the Platen Glass after scanning is completed.
 Note
 To scan the multi-page document into one file, select Continue, and press the OK button.
Then load the next page on the Platen Glass, and repeat the procedures from (2) in step 4.
Repeat the same procedure until you finish scanning all the pages.
 Important
 Do not remove the USB flash drive or turn off the power while the machine is operating.
 Do not open the Document Cover or move the loaded original until scanning is completed.
 The scanned data will be saved in the folder CANON_SC on the USB flash drive. You cannot
print the saved data using the Operation Panel on the machine.
 Note
 To remove the USB flash drive after scanning is completed, see Removing the USB Flash Drive
.
 You can exit the Scan menu and select another menu, if you press the HOME button after
scanning is completed.
 Deleting the Scanned Data 
1.Prepare for using a USB flash drive.
Page 36 of 805 pages Saving Scanned Data
 
						

							(1) Turn on the power.
See Operation Panel.
(2) Insert a USB flash drive into the Direct Print Port.
See Inserting the USB Flash Drive.
2.Delete the scanned data.
(1) Select Scan  on the HOME screen, and press the OK button.
(2) Use the Easy-Scroll Wheel or the  (Left) or  (Right) button to select USB
flash drive , and press the OK button.
The operation selection screen appears.
(3) Use the Easy-Scroll Wheel or the  (Left) or  (Right) button to select Delete
scanned data 
, and press the OK button.
The data list screen appears.
(4) Use the Easy-Scroll Wheel or the  (Up) or  (Down) button to select the image
data you want to delete, and press the OK button.
 Note
 Select the image data and press the left Function button to view the selected data on the
screen.
 Press the right Function button to change the data list between PDF data and JPEG data.
 You can only delete the image data that have been scanned and saved using the machine.
(5) When the message Delete? appears, select Yes and press the OK button.
(6) When the message Are you sure you want to delete? appears, select Yes and
press the OK button.
The selected image data will be deleted from the USB flash drive.
 Inserting the USB Flash Drive 
 Important
Before inserting the USB flash drive
 If your USB flash drive cannot be inserted into the Direct Print Port of the machine, you may be
required to use an extension cable for the USB flash drive. Purchase it at electronics retail stores.
 For some USB flash drives, proper operation may not be guaranteed on the machine.
 You may not be able to use USB flash drives with security function.
1.Insert the USB flash drive into the Direct Print Port.
Make sure that the USB flash drive is correctly oriented before inserting it straightforward into the Direct PrintPort.
Page 37 of 805 pages Saving Scanned Data
 
						

							 Removing the USB Flash Drive 
1.Make sure that the machine is not reading or writing data from/to the USB flash
drive.
Check if the reading or writing operation is completed on the LCD.
 Important
 Do not remove the USB flash drive or turn off the power while the machine is operating.
 Note
 If you use the USB flash drive with the access lamp, refer to the instruction manual supplied
with the USB flash drive to check if the reading or writing operation is completed on the USB
flash drive.
2.Remove the USB flash drive.
Hold the USB flash drive and remove it from the machine straightforward.
      
Page top
Page 38 of 805 pages Saving Scanned Data
 
						

							Advanced Guide  Troubleshooting
Contents > Printing from Your Computer
Printing from Your Computer 
This section describes how to print documents or photos with a computer.
You can easily print photos taken with your digital camera by using Easy-PhotoPrint EX supplied with
your machine.
Printing Photos (Easy-PhotoPrint EX)
Using Various Functions of Easy-PhotoPrint EX
Printing Documents (Windows)
Printing Documents (Macintosh)
For Mac OS X v.10.5.x
For Mac OS X v.10.4.x or Mac OS X v.10.3.9
      
Page top
Page 39 of 805 pages Printing from Your Computer
 
						

							Advanced Guide  Troubleshooting
Contents > Printing from Your Computer > Printing Photos (Easy-PhotoPrint EX)
Printing Photos (Easy-PhotoPrint EX) 
Print image data saved on your computer by using Easy-PhotoPrint EX supplied with your machine.
This section describes the procedure, using print setting for borderless photo print on 4 x 6 / 10 x 15 cm
photo paper as a sample.
For details on Easy-PhotoPrint EX, refer to the on-screen manual: Advanced Guide.
 Note
 The screens used in this section are for printing with Windows. The operations are also the same
for printing with Macintosh.
 Install Easy-PhotoPrint EX from the Setup CD-ROM when it has not been installed or has beenuninstalled. To install Easy-PhotoPrint EX, select Easy-PhotoPrint EX in Custom Install.
1.Prepare for printing.
(1) Make sure that the machine is turned on.
See Operation Panel.
(2) Load paper.
See Loading Paper.
Here we load 4 x 6 / 10 x 15 cm photo paper in the Rear Tray.
 Note
 Load A4 or Letter-sized plain paper in the Cassette and other sizes or types of paper
such as photo paper in the Rear Tray.
(3) Open the Paper Output Tray gently, and open the Output Tray Extension.
2.Start Easy-PhotoPrint EX, and select Photo Print.
Page 40 of 805 pages Printing Photos (Easy-PhotoPrint EX)