ATT DEFINITY Communications System Generic 3 Instructions Manual

Code Calling Access
Issue  3   March 1996
3-557
Hardware and Software Requirements
Requires loudspeaker paging equipment and one port on a TN763 Auxiliary 
Trunk circuit pack (TN763D supports A-law and Mu-law) for each individual 
zone. (These hard ware requirements can be shared with the Loudspeaker 
Paging Access feature. Ac tivation of each feature is by the assigned trunk 
access code.)
No a d ditional software is required. 

Feature Descriptions
3-558Issue  3   March 1996 
Conference — Attendant
Feature Availability
This feature is available with all Generic 3 releases.
Description
Allows the attendant to set u p a conference call for as many as six conferees, 
including the attendant.  Conferees from inside and outside the system can be 
added to a conference call. To set u p a conference, the attendant dials a number 
and uses the split key to a d d each party to the rest of the conference.
Considerations
Whenever an...

Conference — Attendant
Issue  3   March 1996
3-559
nWhen a multi-function station (BRI/Digital/Hybrid) dials sufficient digits to 
route a call, b ut could route differently if a d ditional digits were dialed, the 
station will not recognize the Conference or Transfer buttons. The user 
must delay dialing for ten seconds or dial a # to indicate the call can be 
routed based on the digits already dialed. The Conference or Transfer 
buttons are then recognized and the o peration is c ompleted by the...

Feature Descriptions
3-560Issue  3   March 1996 
Conference — Terminal
Feature Availability
Conference — Terminal is available with all Generic 3 releases.
Description
Allows multi-appearance voice terminal users to set up six-p arty conference calls 
without attendant assistance. 
Considerations
With the Conference — Terminal  feature,  voice terminal users can set up their 
own conference calls without assistance from an attendant.
With assistance from other users, a single-line voice terminal c an...

Conference — Terminal
Issue  3   March 1996
3-561
nClass of Restriction (COR)
The COR of the party being added is always checked against the COR of 
the party controlling the add-on, but the new party’s COR is not checked 
against any other conferee’s CORs if Restriction Override is set to ‘‘all.’’  It 
is checked against ‘‘attendants’’ or ‘‘none.’’
nInternal Automatic Answer (IAA)
Internal conference calls are eligible to be automatically answered via the 
IAA feature. If more than one conference party...

Feature Descriptions
3-562Issue  3   March 1996 
Constellation Voice/Data Terminal 
Support
Feature Availability
This feature is available with the Generic 3 Version 3 and later release.
Description
Provides support for integrating voice terminals with the Constellation Voice/Data 
Terminal. The Constellation is a voice/data workstation that provides an 
integrated environment for applications using DCP-based (digital 
communications protocol) signaling.
The Constellation o perates in conjunction with an...

Constellation Voice/Data Terminal Support
Issue  3   March 1996
3-563
Configuration
The following diagram illustrates the hardware/signaling arrangement for the 
Constellation.
Figure 3-3. Constellation Hardware/Signaling Arrangement
PRI (D) Signaling Channel
(SID/ANIPRI (B) Voice Channel
(Incoming call)
TDM Bus
TDM Bus DCP (11) Voice Channel
SPEDCP (S)
Signaling Channel
6538/9DCP (11)
Voice Channel
7401D, 7406D, 602A1,
603A1, 603D1
DCP (12) Data Channel
PRI (B) Data Channel
(PRI Trunk Group)
HostEIA
Por...

Feature Descriptions
3-564Issue  3   March 1996 
Considerations
G3V3 and later releases provide native support for the Constellation. ‘‘Native 
support’’ means the switch stores a predefined terminal type and fully supports 
the terminal operation. The constellation terminal is a Memorex/Telex product. 
Memorex/Telex is responsible for manufacturing and installing this terminal. 
automatically downloads the terminal typ e information to the terminal.
Administration
The Constellation is administered on...

Consult
Issue  3   March 1996
3-565
Consult
Feature Availability
Consult is available with all Generic 3 releases.
Description
Allows a covering user, after answering a coverage call, to call the principal 
(called party) for p rivate consultation.
Consult is activated by first pressing the Conference or Transfer button followed 
by the Consult button to call the principal. This places the calling party on hold 
and establishes a connection between the principal and the covering user. The 
covering user...

Feature Descriptions
3-566Issue  3   March 1996 
Hardware and Software Requirements
No a d ditional hardware or software is required.