Xerox Phaser 6120 User Manual

							Cleaning the Printer 94
4Clean the laser lens by wiping them with a soft, dry cloth.
5Reinstall the imaging unit.
Downloaded From ManualsPrinter.com Manuals 
						

							Cleaning the Printer 95
6Carefully close the top cover.
Downloaded From ManualsPrinter.com Manuals 
						

							Cleaning the Printer 96
Cleaning the Duplex Unit Feed Rollers
1Turn off the printer and disconnect the power cord and interface cables.
2Open the duplex cover.
3Clean the feed rollers by wiping them with a soft, dry cloth.
Downloaded From ManualsPrinter.com Manuals 
						

							Cleaning the Printer 97
4Carefully close the duplex cover.
Downloaded From ManualsPrinter.com Manuals 
						

							Cleaning the Printer 98
Cleaning the Media Feed Rollers for Tray 2
1Turn off the printer and disconnect the power cord and interface cables.
2Lift the printer off of Tray 2 and temporarily place it on a sturdy 
flat
 surface.
Downloaded From ManualsPrinter.com Manuals 
						

							Cleaning the Printer 99
3Clean the media feed rollers by wiping them with a soft, dry cloth.
4Lift the printer and reinstall it on top of Tray 2.
Downloaded From ManualsPrinter.com Manuals 
						

							Storing the Printer 100
Storing the Printer
Note:
If this printer is not to be used for an extended period of time, store the 
printer with both green fuser separator levers raised (set to the 
envelope position).
Downloaded From ManualsPrinter.com Manuals 
						

							Troubleshooting
Downloaded From ManualsPrinter.com Manuals 
						

							Introduction 102
Introduction
This chapter provides information to aid you in resolving printer problems you 
may encounter, or at least guide you to the proper sources for help. 
Printing a Configuration Page
Print a configuration page to verify the printer is configured correctly.
Printing the configuration pagePage 102
Preventing media misfeedsPage 103
Understanding the media pathPage 104
Clearing media misfeedsPage 105
Solving problems with media misfeedsPage 115
Solving other problemsPage 117
Solving problems with printing qualityPage 121
Status, error, and service messagesPage 127
Press KeyUntil Display Reads
READY
PRINTABLE PAGES MENU
 CONFIGURATION
YES
The configuration page prints and the printer goes back 
to
 READY.
Downloaded From ManualsPrinter.com Manuals 
						

							Preventing Paper Jams 103
Preventing Paper Jams
Make sure that...
Media matches the printer specifications.
Media is flat, especially on the leading edge.
The printer is on a hard, flat, level surface.
You store media in a dry location away from moisture and humidity.
You remove transparencies from the output tray immediately after printing to 
avoid static buildup.
You always adjust the media guides in Tray 1 after inserting the media (a 
guide that is not properly adjusted can cause poor print quality, paper jams, 
and printer damage).
You load the media printing-side up in the tray (many manufacturers place an 
arrow on the end of the wrapper to indicate the printing side).
Avoid...
Media that is folded, wrinkled, or excessively curled.
Double feeding (remove the media and fan the sheets—they may be sticking 
together). 
Fanning transparencies since this causes static.
Loading more than one type/size/weight of media in a tray at the same time.
Overfilling the trays. 
Allowing the output tray to overfill (the output tray has a 200-sheet capacity—
misfeeding may occur if you allow more than 200 sheets of media to 
accumulate at one time).
Allowing the output tray to fill with more than a few transparencies. 
Downloaded From ManualsPrinter.com Manuals