Xerox Phaser 6120 User Manual

Cleaning the Printer 94
4Clean the laser lens by wiping them with a soft, dry cloth.
5Reinstall the imaging unit.
Downloaded From ManualsPrinter.com Manuals 

Cleaning the Printer 95
6Carefully close the top cover.
Downloaded From ManualsPrinter.com Manuals 

Cleaning the Printer 96
Cleaning the Duplex Unit Feed Rollers
1Turn off the printer and disconnect the power cord and interface cables.
2Open the duplex cover.
3Clean the feed rollers by wiping them with a soft, dry cloth.
Downloaded From ManualsPrinter.com Manuals 

Cleaning the Printer 97
4Carefully close the duplex cover.
Downloaded From ManualsPrinter.com Manuals 

Cleaning the Printer 98
Cleaning the Media Feed Rollers for Tray 2
1Turn off the printer and disconnect the power cord and interface cables.
2Lift the printer off of Tray 2 and temporarily place it on a sturdy 
flat
 surface.
Downloaded From ManualsPrinter.com Manuals 

Cleaning the Printer 99
3Clean the media feed rollers by wiping them with a soft, dry cloth.
4Lift the printer and reinstall it on top of Tray 2.
Downloaded From ManualsPrinter.com Manuals 

Storing the Printer 100
Storing the Printer
Note:
If this printer is not to be used for an extended period of time, store the 
printer with both green fuser separator levers raised (set to the 
envelope position).
Downloaded From ManualsPrinter.com Manuals 

Troubleshooting
Downloaded From ManualsPrinter.com Manuals 

Introduction 102
Introduction
This chapter provides information to aid you in resolving printer problems you 
may encounter, or at least guide you to the proper sources for help. 
Printing a Configuration Page
Print a configuration page to verify the printer is configured correctly.
Printing the configuration pagePage 102
Preventing media misfeedsPage 103
Understanding the media pathPage 104
Clearing media misfeedsPage 105
Solving problems with media misfeedsPage 115
Solving other problemsPage 117...

Preventing Paper Jams 103
Preventing Paper Jams
Make sure that...
Media matches the printer specifications.
Media is flat, especially on the leading edge.
The printer is on a hard, flat, level surface.
You store media in a dry location away from moisture and humidity.
You remove transparencies from the output tray immediately after printing to 
avoid static buildup.
You always adjust the media guides in Tray 1 after inserting the media (a 
guide that is not properly adjusted can cause poor print quality,...