Xerox Phaser 6120 User Manual

Understanding the Media Path 104
Understanding the Media Path
Understanding the printer’s media path will help you locate media misfeeds.
1Output tray
2Transfer belt
3Toner cartridge carousel
4Imaging unit
5Tray 1
6Tray 2 (optional)
7Duplex unit (optional)
8Fuser
1
2
4
5
67 8
3
Downloaded From ManualsPrinter.com Manuals 

Clearing Paper Jams 105
Clearing Paper Jams 
To avoid damage, always remove misfed media gently, without tearing it. 
Any
 piece of media left in the printer, whether large or small, can obstruct the 
media path and cause further misfeeds. Do not reload media that has misfed.
Note:
The image is not fixed on the media before the fusing process. If you 
touch the printed surface, the toner may stick to your hands, so be 
careful not to touch the printed face when removing the misfed media. 
Make sure not...

Clearing Paper Jams 106
Paper Jam Messages and Clearing Procedures
The first column in the following table identifies the jam messages that are 
displayed on the front panel. The second column in the following table 
identifies which jam procedure can be used to clear each jam.
Paper Jam MessagePage Reference
PAPER JAM TRAY 1Page 107
PAPER JAM FUSERPage 107
PAPER JAM EXITPage 107
PAPER JAM TRANSFERPage 107
PAPER JAM TRAY 2Page 111
PAPER JAM DUPLEXPage 114
Downloaded From ManualsPrinter.com Manuals 

Clearing Paper Jams 107
Clearing a Paper Jam in the Printer
1Pull the lever, and then open the top cover.
If there is paper in the output tray, remove it. Fold up the output 
tray before opening the top cover.
Do not touch the transfer belt.
2Carefully pull out the imaging unit.
Downloaded From ManualsPrinter.com Manuals 

Clearing Paper Jams 108
CAUTION
Position the removed imaging unit as shown in the illustration below. Be sure 
to keep the imaging unit horizontal and place it where it will not become dirty. 
Do not leave the imaging unit removed for more than 15
 minutes, and do not 
place the removed imaging unit in a location where it would be exposed to 
direct light (such as sunlight).
3Remove any jammed paper.
Downloaded From ManualsPrinter.com Manuals 

Clearing Paper Jams 109
Always remove the jammed paper in the feed direction as shown 
only. If it is difficult to remove the paper from the fuser, raise both 
green fuser separator levers to the position for envelope printing, 
and then remove the paper. After removing the paper, set both 
green fuser separator levers to their original positions.
4Reinstall the imaging unit.
Downloaded From ManualsPrinter.com Manuals 

Clearing Paper Jams 110
5Carefully close the top cover.
Downloaded From ManualsPrinter.com Manuals 

Clearing Paper Jams 111
Clearing a Paper Jam From Tray 2
1Pull out Tray 2 as far as possible.
2Lift up Tray 2 to remove it.
Downloaded From ManualsPrinter.com Manuals 

Clearing Paper Jams 112
3Remove any jammed paper.
4Remove the lid from Tray 2, and then remove all paper from the tray.
5Fan the paper, and align its edges.
Downloaded From ManualsPrinter.com Manuals 

Clearing Paper Jams 113
6Load the media in Tray 2, and attach the lid.
7Reinsert Tray 2.
Downloaded From ManualsPrinter.com Manuals