Xerox DocuColor 12 User Manual

DOCUCOLOR 12 USER GUIDE5–15 ADDED FEATURES
1
2
3
4
5
6
7
3Perform one of the following:
•To scan and copy both pages, touch the Both 
Pages icon.
•To scan and copy the top page without the 
bottom page, touch the Top Page Only icon. 
•To scan and copy the bottom page without the 
top page, touch the Bottom Page Only icon.
4If necessary, use the arrows under the Binding 
Erase icon to delete the centre shadow from the 
output. Touch the right arrow to increase the 
amount of erasure in the centre of the...

ADDED FEATURES5–16 DOCUCOLOR 12 USER GUIDE
1
2
3
4
5
6
7
Margin Shift
The Margin Shift feature (Figure 14) allows you to 
change the placement of an image on the output 
page.
You can move images to the centre of the output 
or move them to a specific corner or edge. In 
addition, you can specify variable incremental 
shifts toward any margin.
This section describes the following options 
illustrated in Figure 15:
•No Shift
•Auto Centre
•Corner Shift
•Variable Shift
NOTE:You can select only one shift...

DOCUCOLOR 12 USER GUIDE5–17 ADDED FEATURES
1
2
3
4
5
6
7 No Shift
If No Shift is selected, the copier/printer assumes 
that the original document is registered in the 
upper left corner of the Document Glass. If the 
document is offset from this registration point, the 
image on the output copy will be offset by the 
same amount.
1Touch the Margin Shift icon on the Added 
Features tab to display the Margin Shift screen, 
Figure 16.
2Touch either the Side 1 or Side 2 icon to display 
the Margin Shift...

ADDED FEATURES5–18 DOCUCOLOR 12 USER GUIDE
1
2
3
4
5
6
7 Auto Centre
Selecting the Auto Centre option centres the 
original image on the output page, as illustrated in 
Figure 18.
KEY POINT:The Auto Centre option is not 
available for 12 x 18 inch or SRA3 originals that 
are being copied without reduction.
The Auto Centre option is intended for copying 
original documents that are smaller than the copy 
paper. You can also use this feature when you 
select a reduction value for original documents 
that...

DOCUCOLOR 12 USER GUIDE5–19 ADDED FEATURES
1
2
3
4
5
6
7
1Touch the Margin Shift icon on the Added 
Features tab to display the Margin Shift screen, as 
illustrated in Figure 19.
2Touch either the Side 1 or Side 2 icon to display 
the Margin Shift screen for the desired side.
3Touch the Auto Centre icon to display the Auto 
Centre detail screen, as illustrated in Figure 20.
4Touch Save to return to the Margin Shift screen.
5If desired, repeat steps 2-4 for the other side.
6Touch the icon that most...

ADDED FEATURES5–20 DOCUCOLOR 12 USER GUIDE
1
2
3
4
5
6
7 Corner Shift
Select the Corner Shift feature to move the image 
to a specified edge or corner on the output copy 
for Side 1 or 2, as illustrated in Figure 21.
This feature works in three ways:
•To shift an image on small documents to a 
specified corner on the output
•To be used with the Reduction feature to 
designate a position where the reduced image 
is to appear on the output
•To be used with the Enlarge feature to 
designate a position where...

DOCUCOLOR 12 USER GUIDE5–21 ADDED FEATURES
1
2
3
4
5
6
7
1Touch the Margin Shift icon on the Added 
Features tab to display the Margin Shift screen as 
illustrated in Figure 22.
2Touch either the Side 1 or Side 2 icon to display 
the Margin Shift screen for the desired side.
3Touch the Corner Shift icon to display the Corner 
Shift detail screen, as illustrated in Figure 23.
4Touch the arrow icon that illustrates the desired 
location of the image on the output copy.
5Touch Save to return to the Margin...

ADDED FEATURES5–22 DOCUCOLOR 12 USER GUIDE
1
2
3
4
5
6
7 Variable Shift
The Variable Shift option enables you to adjust the 
horizontal or vertical orientation of the output 
image, as illustrated in Figure 24. You can shift the 
image up, down, right, or left by means of the 
variable arrow buttons.
You can designate the variable shift in 1 mm 
increments, from 0 to 432 mm.
NOTE:Do not use Variable Shift if you want 
100% of your original document to be copied.
The orientation of the image on the copies...

DOCUCOLOR 12 USER GUIDE5–23 ADDED FEATURES
1
2
3
4
5
6
7
1Touch the Margin Shift icon on the Added 
Features tab to display the Margin Shift screen, as 
illustrated in Figure 25.
2Touch either the Side 1 or Side 2 icon to display 
the Margin Shift screen for the desired side.
3Touch the Variable Shift icon to display the 
Variable Shift detail screen, as illustrated in
Figure 26.
4Perform one or both of the following:
•Under the Left & Right icon, touch the right 
arrow to shift the image toward the...

ADDED FEATURES5–24 DOCUCOLOR 12 USER GUIDE
1
2
3
4
5
6
7
5Touch Save to return to the Margin Shift screen.
6If desired, repeat steps 2-5 for the other side.
7Touch the icon that most closely resembles the 
Original Orientation for the document on the 
Document Glass.
8Touch Save to return to the Added Features tab.
Downloaded From ManualsPrinter.com Manuals