Toshiba Stratagy 4/6/24 Installation And Maintenance Manual

STRATAGY 4/6/24 INSTALLATION AND MAINTENANCE MANUAL SEPTEMBER 1994 
CHAPTER 3 
INSTALLING THE HARDWARE 
1 INTRODUCTION 
This chapter describes the Stratagy hardware and 
provides step-by-step instructions on installing the 
Stratagy 4, 6, and 24 systems. 
2 THE HARDWARE 
Stratagy 4 and 6 - This system consists of a PC tower. 
It contains 2 or 4 ports, and 6 hours of disk storage. 
It may be expanded to a maximum of 6 ports. A lap- 
top PC with Stratagy Remote software installed and 
a null modem cable is...

STRATAGY 4/6/24 INSTALLATION AND MAINTENANCE MANUAL 
SEPTEMBER 1994 
Figure 3-l 
Stratagy 4 and 6 Hardware Components 
Tower Hardware 
CPU 
Hard Disk Drive 
Floppy Drive 
RAM 
Other Hardware 
External Modem 
Capacities 
Ports 
Software 
486SX CPU @ 25 MHz 
6 hours net storage 
3.5” diskette drive (1.44MB) 
2MB 
2400 baud modem (optionally equipped, but required for remote access) 
2,4 or 6 ports 
DOS 
Stratagy voice processing software, host, and necessary utilities 
Table 3-1 
Stratagy 4 and 6 Hardware...

STRATAGY 4/6/24 INSTALLATION AND MAINTENANCE MANUAL 
SEPTEMBER 1994 
I 
Figure 3-2 
Stratagy 24 Hardware Components 
Desktop Hardware 
CPU 
Hard Disk Drive 
Floppy Drive 
RAM 
Other Hardware 
Monitor 
Keyboard 
External Modem 
Capacities 
Ports 
Software 
486SX CPU @ 25 MHz 
6, 20, or 33 hours of net storage 
3.5” diskette drive (1.44MB) 
4MB 
VGA 
101 -key keyboard 
2400 baud modem (optionally equipped, but required for remote access) 
4, 6, . . . 
24 ports 
DOS 
Stratagy voice processing software,...

STRATAGY 4/6/24 INSTALLATION AND MAINTENANCE MANUAL SEPTEMBER 1994 
‘ 
Environmental 
Conditions 
Electrical 
Requirements 
(AC Input) Operating Temperature 39.2”F to 104°F (4°C to 40°C) 
Storage Temperature 104°F to 140°F (-40°C to 60°C) 
Operating Humidity 
20% to 80% (non-condensing) 
Stratagy 4, 6 or 24 115 VAC, at 6 amps (50/60 Hz) 
230 VAC at 3.5 amps (50/60 Hz) 
Monitor 
115 or 230 VAC at 0.5 amps (50/60 Hz) 
(Provide host system with 15 A circuit breaker and dedicated circuit) 
Heat Dissipation...

STRATAGY 4/6/24 INSTALLATION AND MAINTENANCE MANUAL 
SEPTEMBER 1994 
SHOWN:ADDRESS300 
(SETTING FOR BOARD 
Figure 3-3 
The Stratagy Voice Board 1) 
Voice board 1 is factory installed and normally shipped 
with address 300 (setting for board 1). Additional boards 
are packaged separately. Set the jumper pins for each 
voice board as follows. Note the following: 
0: both pins are not covered/connected by a black 
jumper pin (open) 
7: both pins are covered/connected by a black jumper 
pin (closed) 
Board 1...

STRATAGY 4/6/24 INSTALLATION AND MAINTENANCE MANUAL SEPTEMBER 1994 
Figure 3-4 
Stratagy 4 and 6 Voice Board Installation Shown: Installing Voice Board 1. 
3-6  

STRATAGY 4/6/24 INSTALLATION AND MAINTENANCE MANUAL 
SEPTEMBER 1994 
Shown: Installing Voice Board 1. 
Other boards not shown. 
I I 
Figure 3-5 
Stratagy 24 Voice Board Installation 
3-7  

STRATAGY 4/6/24 INSTALLATION AND MAINTENANCE MANUAL SEPTEMBER 1994 
- POWER 
(ON/OFF) 
- KEY 
LOCK COM2 
(default 
local access) - 
LPTl ~ 
PARALLEL 
PRINTER 
PORT 
not used AUXILIARY 
POWER 
OUTLET 
110122ov 
POWER SWITCH 
AIC POWER 
CORD 
CONNECTOR 
not used 
COM1 
(default 
remote access) 
not used 
PORTS 516 
PORTS l/2 
PORTS 314 
- 
Figure 3-6 
Stratagy 4 and 6 Front and Back Panels (Sample Stratagy 6 with 6 Voice Board and 2 COM Ports) 
1 
VOICE 
BOARD 
PORTS 
6.2 SETTING UP THE STRATACY 24 I If...

STRATAGY 4/6/24 INSTALLATION AND MAINTENANCE MANUAL 
SEPTEMBER 1994 
POWER (ON/OFF) 
VOICE BOARD PORTS 
PORTS13114 7 7 PORTS 9110 
COM2 (default: fax 2) 
COMl (default: fax 1) PORTS 15/16 7 1 
I 
PORTS 17/18 - 
PORTS 19120 
PORTS 21122 
1 1 PORTS 23124 PORTS 1 l/l 2 
COM4 (default: remote access) ~ - PORTS 5/6 
PORTS 718 
COM3 (default: SMDI) 
- PORTS l/2 
“ORTS 314 
KEY LOCK @ 
0 
0 
0 
0 
0 
  POWER OUTLET 
-- 
KEYBOARD 1 I 
I 
MONITOR 
CONNECTOR 
CONNECTOR  
I A/C POWER A 
CORD CONNECTOR 
110/22OV...

STRATAGY 4/6/24 INSTALLATION AND MAINTENANCE MANUAL SEPTEMBER 1994 
Physically connect Stratagy to your telephone system. To 
do this you need to know: 
n Customer-Supplied Parts - All modular cords, 
connectors, cables, and connection blocks are 
customer-supplied. 
n Location of the Ports on the Voice Board - On a 
voice board with two connectors, the top connector 
represents the first two ports, and the bottom 
connector represents the second two ports, for a total 
of four ports. See Figure 3-8. 
n...