Sharp SF 2530 User Manual

69
OPTIONAL EQUIPMENT
Max. No. Max. No.
Mode Paper sizeof of copies
originals to be set
Min.:
NON- 5-1/2 x 8-1/2
Ð99
SORT Max.:
11 x 17
SORT/5-1/2 x 8-1/2,
STAPLE8-1/2 x 11, 30
SORT8-1/2 x 11R10
8-1/2 x 14, 11 x 17 15
5-1/2 x 8-1/2,
GROUP8-1/2 x 11,
1020
8-1/2 x 11R
8-1/2 x 14, 11 x 1715
Max. No. Max. No.
Mode Paper sizeof of copies
originals to be set
NON- Min.: 5-1/2 x 8-1/2
99
SORT Max.: 11 x 17Ð
SORT 5-1/2 x 8-1/2,
8-1/2 x 11, 50
8-1/2 x 11R 20
8-1/2 x 14, 11 x 17 25
8-1/2 x 11,
STAPLE 8-1/2 x 11R50...

70
OPTIONAL EQUIPMENT
Stapling location
10-bin staple sorter (SF-S54N)
20-bin staple sorter (SF-S56)
Staple sort
The STAPLE SORT mode staples copies of 5-1/2 x 8-1/2, 8-1/2 x
11, 8-1/2 x 11R, 8-1/2 x 14, and 11 x 17 sizes (SF-S54N) or
copies of 8-1/2 x 11, 8-1/2 x 11R, 8-1/2 x 14, and 11 x 17 sizes
(SF-S56).
Using the document glass
1
Set the original on the document glass with the corner
to be stapled to the upper right.
lCopy from the last page to the first page.
SF-S54N
lIf the number of copies to be...

71
OPTIONAL EQUIPMENT
(ORIGINALS)EVEN NUMBE
ODD NUMBER
PRE-COUNT
ORIGINALS SORT
STAPLE
SORT
GROUP
9
START
Using the ADF or RADF
1
Set the originals in the document feeder tray face up
with the stapling position in the upper left corner.
SF-S54N
lIf the number of copies to be delivered into each bin is more than
30 for 5-1/2 x 8-1/2, 8-1/2 x 11 or 8-1/2 x 11R paper or 15
for 8-1/2 x 14 or 11 x 17 paper, the copies will not be stapled.
SF-S56
lIf the number of copies to be delivered into each bin is more...

72
OPTIONAL EQUIPMENT
1
Align the edges of the copies to be stapled.
2
Place the set of copies into the top bin, making sure the
edges are flush with the inner right corner, as shown in
the figure.
lMake sure that there is no paper in the other sort bins. If there
is, the manual staple key will not light up.
lUp to 50 sheets of paper can be stapled together. Exceeding this
maximum may result in damage to the stapler.
3
Press the manual staple key when it lights up.
lThe set of copies will be stapled....

73
OPTIONAL EQUIPMENT
STAPLE TEAR line
Staple cartridge replacement
The CHECK STAPLER indicator will blink when the staple cartridge
is empty and the copier is in the STAPLE SORT mode. Replace the
staple cartridge as follows.
lIf there are still many staples left, then staples have jammed in the
stapler. See page 76.
SF-S54N 10-bin staple sorter
1
Open the stapler cover.
2
Lifting the green release lever, remove the staple
cartridge from the stapler.
lA few staples will be left in the cartridge. Remove...

74
OPTIONAL EQUIPMENT
SF-S56 20-bin staple sorter
1
Open the stapler cover.
2
Lift the release lever and pull out the staple box.
lLift the release lever to unlock the staple box. Then pull out the
box.
3
Remove the empty staple cartridge from inside the
staple box.
4
Insert the new staple cartridge into the box until it clicks
in place.
lInsert the new cartridge by aligning the arrows on the cartridge
with those on the box. Check that the cartridge locks in place
by pulling it slightly.
lA cartridge...

75
OPTIONAL EQUIPMENT
5
Remove the rear paper and tape from the cartridge.
lPull them straight. If they are pulled obliquely, the tape may be
torn.
6
Insert the staple box into the stapler until it clicks in
place.
7
Close the stapler cover.
8
Place a sheet of paper into the top bin. Press the manual
staple (
) key on the staple sorter when it lights up.
lCheck to see whether the sheet is stapled.
If it is not stapled, press the manual staple key again.
lIf the stapler does not operate properly even...

76
OPTIONAL EQUIPMENT
Staple jam removal
If staples become jammed in the stapler, the CHECK STAPLER
indicator and the STAPLE SORT mode indicator will blink. Remove
the jammed staples in the manner described below.
SF-S54N 10-bin staple sorter
1
Open the stapler cover.
2
Close the stapler cover.
lJammed staples will be removed automatically.
3
Remove all copies from the bins of the staple sorter.
lTo check that the stapler works properly, copy an original and
staple it.
10-bin staple sorter (SF-S54N)...

77
OPTIONAL EQUIPMENT
SF-S56 20-bin staple sorter
1
Open the stapler cover.
2
Lift the release lever and pull out the staple box.
lLift the release lever to unlock the staple box. Then pull out the
box.
3
Lower the lever at the end of the staple box and remove
the jammed staples.
4
Return the lever to its original position.
20-BIN STAPLE SORTER (SF-S56)
20-bin staple sorter (SF-S56)
Downloaded From ManualsPrinter.com Manuals 

78
OPTIONAL EQUIPMENT
5
Insert the staple box into the stapler unit until it clicks in
place.
6
Close the stapler cover.
7
Following the stapling procedure on page 72, staple a
copy to check that the stapler works properly.
lIf it does not, repeat this procedure until it does.
20-bin staple sorter (SF-S56)
20-BIN STAPLE SORTER (SF-S56)
Downloaded From ManualsPrinter.com Manuals