Sanyo LNS-M01, LNS-S01 Installation Manual
Here you can view all the pages of manual Sanyo LNS-M01, LNS-S01 Installation Manual. The Sanyo manuals for Projector are available online for free. You can easily download all the documents as PDF.
Page 1
PARTS LIST Following parts are contained in the packing. · LENS · LENS MOUNTING SCREWS · DRIVER · LIGHT-BLOCK SHEET NOTES ON LENS INSTALLATION LCD PROJECTOR LENS MODEL NO. LNS-M01 LNS-S01 Lens installation should be performed by the qualified service personnel. It should be followed by this procedure precisely. Before attempt to install the lens, confirm the model number (both the LCD projector and the lens) and use the proper...
Page 2
LENS REPLACEMENT AND INSTALLATION PROCEDURE Remove screws A (2 screws). Pull down the lower lens cover while pushing the part D, then remove it. Remove screws B (2 screws). Remove screws C (2 screws) and remove upper lens cover.1 4Perform the steps to for lens replacement and installation. 1 1. 2. A Fig-1 Fig-2 lIN CASE OF MODEL WITHOUT LENS Remove 2 screws and pull down the plate. 2 3. 4. UPPER LENS COVER LOWER LENS COVER C B D D COVER PLATE REMOVE THE LENS COVER. (See figure-1) (At the step , insert...
Page 3
INSTALL THE LENS. (See figure-4,5.)3 1. Mount the lens at the lens mounting bracket with screws (4 screws) included with the lens. Use the driver included with the lens to fasten the screws . (After using, save it for latter use.) 2. Connect the lens motor lead to the connector “K16B” of the cir- cuit board. 3. Fasten the lens motor lead at the A, B points with wire holder. LENS MOTOR LEAD CONNECTOR “ K16B “ (D) (D)(D) (D) B LENS MOTOR Fig-5 This part wiring should not be tightened. kFigure shown inside...