Panasonic Uf 885 Users Guide
Here you can view all the pages of manual Panasonic Uf 885 Users Guide. The Panasonic manuals for Fax Machine are available online for free. You can easily download all the documents as PDF.
Page 161
159 (see Note 1) 540/541 542 543/544Communication error occurred while transmitting. 1. Reload the document and send again. 2. Check with the other par ty.-- 550 Telephone line disconnected. Check with the other party. -- 552/553 554/555Communication error occurred while receiving. Check with the other party. -- 580 Sub-address transmission to a unit that has no Sub- address function.Check the remote station. 140 581 Sub-address Password transmission to a unit that has no Password Sub-address...
Page 162
160 Clearing a Recording Paper Jam If the recording paper becomes jammed in the machine, the display will show an Information Code 001, 002, 003, 007 or 008. (see Note 1)To clear the jam, Info. Code 001, 002, 003, 008 (1) Open the Printer Cover. (2) Remove the jammed paper. (3) Slide out the Paper Cassette. (4) Remove the jammed or wrinkled paper and reload the recording paper into the paper cassette. Caution:Make sure that the paper is set under the clips of the Paper Cassette. You can load about 500...
Page 163
161 Clearing a Document Jam If a document becomes jammed in the machine, the display will show the Information Code 030 or 031. To clear the jam 1(1) Open the ADF Door. (2) Remove the jammed document. 2 1 Troubleshooting 8
Page 164
162 Cleaning the Document Scanning Area If the receiving party reports that the received documents were black, or contained black lines, try making a copy on your unit to verify. If the copy is black or has black lines, the document Scanning Area is probably dir ty and must be cleaned. To clean the Scanning Area 1Open the ADF Door. 2Wipe the Scanning Area gently with a soft cloth gauze wet with ethyl alcohol. Be sure to use a clean cloth, the scanning area can be easily scratched. ADF Door Scanning...
Page 165
163 Cleaning the Printer Roller If you find toner on the back of the recording paper, the printer roller in the fuser unit is probably dirty. To clean the printer roller (see Note 1) 1 2 The machine will print out 3 Cleaning Char ts. Then, return to standby. 3 Load the Cleaning Char ts into the cassette face up. (See Note 1) 4 5 The Machine will feed out the charts and clean the printer roller. 1. If you have installed the optional cassette(s), load the Cleaning Charts into the...
Page 166
164 Adjusting the Automatic Document Feeder (ADF) If document misfeeding occurs frequently, we suggest you adjust the ADF. To adjust the ADF, Pull the blue Pressure Adjusting Lever upward and slide it to the desired position depending on the condition. Position Condition 1 To prevent no feed trouble 2 Standard position 3 To prevent multiple feed trouble Troubleshooting
Page 167
165 Verification Stamp The Verification Stamp contains ink. When the stamp mark appears faded or hard to see, the stamp should be replaced or refilled with ink. To remove the stamp (see Note 1) (see Note 2) 1Open the ADF Door. 2(1) Remove by pulling the Stamp Assembly upward. (2) Remove the Stamp. Replace the stamp with a new one or refill the stamp with a few drops of the specified ink into the back of the stamp. 1. Please contact your local Panasonic dealer to purchase a new stamp. See page 174 for...
Page 168
166 Replacing the Lithium Battery During the initial self test, when the power is turn “On”, the machine will evaluate the condition of the back up battery. If the battery is weak or fully discharged, the following message will be shown on the display. To replace the battery, follow the procedure below: (see Note 1) 1(1) Turn the Power Switch to the “O” (OFF) position. (2) Open the ADF Door. (3) Remove the Battery together with the Battery Holder. CAUTION! Dispose the Lithium battery properly and keep...
Page 169
167 Checking the Telephone Line When you do not hear a dial tone through the telephone connected to the machine or when the telephone does not ring (No automatic receive). 1Unplug the Telephone Line Cable from the telephone jack that was supplied by the telephone company. 2Plug a different regular telephone into the same telephone jack. 3Check for dial tone through the handset. If there is still no dial tone, report it to your local telephone company. or Call from another telephone to this number. If...