Panasonic Network Camera Bl C10a Operating Instructions

Operating Instructions
[For assistance, please call: 1-800-272-7033]                                 61
7.Set the image buffer frequencies, and click [Next>].
• Clicking [

Operating Instructions
62
8.Select the transfer method, and click [Next>].
• Clicking [

Operating Instructions
[For assistance, please call: 1-800-272-7033]                                 63
When you set [FTP] for Transfer Method
Select [FTP], and click [Next>]. The following page is displayed.
• Clicking [

Operating Instructions
64
When you set [E-mail] for Transfer Method
Select [E-mail], and click [Next>]. The following page is displayed.
• Clicking [

Operating Instructions
[For assistance, please call: 1-800-272-7033]                                 65
9.After you confirm the settings and click [Next>], set E-mail notification and click 
[Next>].
• If you select [Enable], the E-mail Notification When Triggered page is 
displayed. Enter the settings seeing page 64 and page 65. When finished, 
click [Next>] and go to step 10.
10.Click [Save] after confirming the settings.
• New settings are saved.
• When finished, "Success!" is displayed....

Operating Instructions
66
11 .Click [Go to Image Buffer/Transfer page].
• The Image Buffer/Transfer page is displayed.
Notes
• If you set a short interval to transfer image to a mobile phone, many E-
mails may be sent to it leading to a large phone bill. Therefore, we 
recommend you to set a long interval. In an emergency situation, the E-
mail transfer can be stopped by enabling privacy mode using a mobile 
phone (see page 25).
• Sensor transfer stops its operations until the camera finishes all...

Operating Instructions
[For assistance, please call: 1-800-272-7033]                                 67
2.14 Specifying Operation Time
The Operation Time page allows you to limit the operation time. The camera image 
turns to a gray screen outside the operation time.
1.Click [Operation Time] on the Setup page.
2.Click [No.] to set the operation time.
Note
If No. 1—7 are disabled, the camera can always be operated.
3.Check [Enable], set the time, and click [Save] 
• Clicking [Cancel] takes you back to the...

Operating Instructions
68
4.Click [Save] when finished.
• New settings are saved.
• The Operation Time page is displayed.
About Operation Time
In the operation time settings, the enabled settings take priority over the disabled 
settings. Therefore, if Monday or Tuesday is disabled in a setting but enabled in 
other settings, the camera can be operated on both Monday and Tuesday. 

Operating Instructions
[For assistance, please call: 1-800-272-7033]                                 69
2.15 Changing Indicator Display
The Indicator Control page allows you to select Indicator operation. Indicator has 
three options.
•Always on
• Turn the indicator on when the camera is accessed.
•Always off
1.Click [Indicator Control] on the Setup page.
2.Select indicator option.
• Clicking [Cancel] cancels your settings without saving changes.
Notes
• See page 6 in the Installation/Troubleshooting for...

Operating Instructions
70
2.16 Enabling Privacy Mode
Pressing the privacy button turns the camera into privacy mode. You can keep your 
privacy in privacy mode. In this case, the camera operation stops, and the image 
transfer by timer or sensor (see page 51 or page 58) is also stopped. The indicator 
turns red, and viewers see a gray screen. Privacy mode can be controlled from a 
mobile phone (see page 24) or a PC.
1.Click [Privacy Mode] on the Setup page.
2.Click [Save] when finished.
• Selecting...