Panasonic Kx-Td308 Digital Super Hybrid System Installation Maintenence Manual

3FeaturesL” b
LED Indication, Outside Line
DescriptionThe LED (Light Emitting Diode) indicators of the buttons
associated with outside lines show the line conditions with a variety
of lighting patterns. This allows the user to see which lines are idle
and which lines are in use. The table below shows the lighting
pattern for different line conditions.
Flashing light patterns
Slow flashing
Moderate flashing
Rapid flashing
Conditions
LED IndicatorOutside Line StatusOff
Idle---
Green On
Green slow flashing...

LFeatures
Feature ReferencesSection 3, Features
Button, Loop-CO (L-CO)
Operation References Not applicable.
Button, Single-CO (S-CO)
Limited Call Duration
DescriptionLimited Call Duration is a system programmable feature that
disconnects an outside call when a specified timer expires. A
warning tone is sent to the extension user 15 seconds, 10 seconds,
and 5 seconds before the time-limit. Limiting the call duration can
be activated or deactivated by Class of Service (COS) for each
extension.Conditions
l...

3FeaturesL. .
Line Access, Automatic
DescriptionAllows the extension user to dial the automatic line access number
and access an idle line from the outside line assigned for the
extension. The proprietary telephone user can use the Loop-CO
button in place of the access number.
Conditionsl This feature functions with Automatic Route Selection (ARS), if ARS
is activated If so, the least expensive route is automatically selected.
l Each extension is subject to System Programming items for outside
lines...

LFeatures
Line Access, Direct
DescriptionAllows the proprietary telephone user to select an outside line by
pressing an idle CO button, which automatically establishes the
handsfree operation mode and allows the user to perform On-Hook
Dialing. The user need not press the SP-PHONE button,
MONITOR button nor 
lift the handset.
Conditionsl There are two types of CO buttons which can be programmed on an
extension: Single-CO button and Loop-CO button.
l Each extension is subject to System Programming items...

FeaturesL
Line Access, Individual
DescriptionAllows the proprietary telephone user one-button access to an
outside line without having to dial a line access code.
Conditionsl Each extension is subject to System Programming items for outside
lines available to access.
l This feature requires a Single-CO (S-CO) button assignment on a
proprietary telephone.
l The system waits for a programmed time before dialing after an outside
line is seized.
Programming References
Feature References
Operation...

LFeatures
Lint! Preference - Incoming (No Line / Prime Line / Ringing Line)
DescriptionA proprietary telephone user can select the method used to answer
incoming calls from the following three line preferences:
(1) No Line Preference
No line is selected when you go off-hook. You must select
a line to answer an incoming call.
(2) Prime Line Preference
You can assign a prime line beforehand and answer a call
on 
that line, when multiple calls are received
simultaneously.(3) Ringing Line Preference...

3FeaturesL
Line Preference - Outgoing (Idle Line / No Line / Prime Line)
DescriptionA proprietary telephone user can select a desired outgoing line
preference to originate calls from the following three line
preferences:
(1) Idle Line Preference:
When you go off-hook, you are connected to an idle line.
An idle line is automatically selected from the pre-assigned
lines.(2) No Line Preference:
No line is selected when you go off-hook. You must select
a line to make a call.
(3) Prime Line Preference:
When...

LFeatures
Live Call Screening (LCS)?
DescriptionAllows a digital proprietary telephone user to monitor their voice
mailbox while an incoming caller is leaving a message and, if
desired, intercept the call. The voice mailbox can be monitored in
one of two ways 
-Hands-free Mode or Private Mode.
Hands-free ModeThe voice mailbox is monitored through the built-in speaker
of the proprietary telephone.
Private Mode
The proprietary telephone emits an alert tone when callers are
connected to the voice mailbox....

FeaturesL
Programming References
Section 4, System Programming
[005] Flexible CO Button Assignment
[6 lo] Live Call Screening Recording Mode Assignment
StationProgramming . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . YserManual
Flexible CO Button Assignment 
-Live Call Screening (LCS) Button
Live Call Screening (LCS) Cancel
Button
Live Call Screening Mode Set
Feature ReferencesNone
Operation References DPT Features-User Manual
Live Call...

LFeatures
Log-In / Log-Out
DescriptionAssigns an extension to join (log-in) or leave (log-out) a hunting,
ring or UCD group. Extensions in log-out status will not receive
calls by Station Hunting but will receive other calls, unlike the
DND feature.
Conditionsl There should be at least one extension that is in log-in status.
l The lighting patterns and status of the Log-In/Log-Out button are
shown below.
lightingOutside Line Status
patternUCDStation Hunting
Red onLog-OutLog-Out
Red flashingLog-In...