Panasonic KX FLB853 User Manual

1. Introduction and Installation
9
For assistance, please visit http://www.panasonic.com/consumersupport
1.2 Accessory information
Accessories for this unit can be ordered online, 
by fax, or by telephone.
–Replacement toner cartridge
*1 (KX-FA85)
–Replacement drum unit*1 (KX-FA86)
–Optional lower input tray (KX-FA101)
–Optional LAN board (KX-FA102)
–Optional handset unit (KX-FA103)
*1 To ensure that the unit operates properly, 
we recommend the use of Panasonic 
toner cartridge and drum unit.
To place...

1. Introduction and Installation
10
For assistance, please visit http://www.panasonic.com/consumersupport
P{COPY}
LTo switch to a copy mode (page 21, 43).
Q{SET}
LTo store a setting during programming.
R{SCAN}
LTo switch to a scan mode (page 21, 52).
SNavigator key
LTo adjust volume (page 22).
LTo search for a stored item (page 31).
LTo select features or feature settings 
during programming (page 57).
LTo navigate to the next operation.
T{TONE}
LTo change from pulse to tone temporarily 
during dialing...

1. Introduction and Installation
11
For assistance, please visit http://www.panasonic.com/consumersupport
1.4.2 Rear view
Removing the shipping tape
Pull open the paper input tray (1), then remove 
the shipping tape (2), pad (3) and paper (4). 1Power switch
2USB interface connector
3Recording paper guides
4Multi-purpose input tray
5Power inlet
6LAN board (Optional) connector / LAN 
connection jack (10Base-T/100Base-TX 
cable)
7Telephone line jack
8External telephone jack
9Speaker
jHandset unit (Optional)...

1. Introduction and Installation
12
For assistance, please visit http://www.panasonic.com/consumersupport
Installation
1.5 Toner cartridge and 
drum unit
The included toner cartridge is a starter toner 
cartridge. It will print about 800 letter-sized 
pages with a 5 % image area (page 93).
LTo replace the toner cartridge and the drum 
unit, see page 79.
Caution:
LRead the following instructions before 
you begin installation. After you have read 
them, open the drum unit protection bag. 
The drum unit...

1. Introduction and Installation
13
For assistance, please visit http://www.panasonic.com/consumersupport
7Lift the cover release lever (1) and open the 
top cover (2).
Important:
LClose the multi-purpose input tray (3) 
before opening the top cover.
LIf the lower glass (4) is dirty, clean it with 
a soft and dry cloth.
8Install the drum and toner unit (1) by holding 
the tabs.LMake sure that the triangles (2) match to 
install the drum and toner unit correctly.
9Close the top cover, holding the cover...

1. Introduction and Installation
14
For assistance, please visit http://www.panasonic.com/consumersupport
1.6 Document tray
Insert the document tray (1) into the slot (2) on 
the unit.
1.7 Output tray
This unit has 3 pieces of output tray. As a default 
setting, printed paper is stacked on the output 
tray as follows.
– Upper output tray (“#1”): Printed document 
by using the computer and copied document.
– Lower output tray (“#3”): Received fax 
document.
LYou can change the output tray setting for...

1. Introduction and Installation
15
For assistance, please visit http://www.panasonic.com/consumersupport
1.7.2 Installing the output tray
Insert the output tray (1) into the slots (2), then 
push the tray down until it latches into place.
LRepeat this step to install other output trays.
LMake sure that the number on the label and 
the tray position match.
Note:
LDo not place the unit in an area where the 
output tray may be easily bumped into.
LThe upper output tray can hold up to 
approximately 100...

1. Introduction and Installation
16
For assistance, please visit http://www.panasonic.com/consumersupport
3Before loading a stack of paper, fan the 
paper to prevent paper jams.
4Load the paper, print-side up (1).
Important:
LPush and lock the plate (2) in the 
paper input tray, if it is lifted.
5Adjust the width to the size of the recording 
paper by sliding the front side of the guide 
(1).
LMake sure that the recording paper is 
under the paper limit mark (2), and the 
paper should not be over the...

1. Introduction and Installation
17
For assistance, please visit http://www.panasonic.com/consumersupport
Using the optional input tray
You can add the optional input tray (Model No. 
KX-FA101). See page 9 for accessory 
information.
A4, letter or legal size recording paper can be 
used.
The optional input tray can hold:
– Up to 500 sheets of 60 g/m
2 to 75 g/m2 (16 lb. 
to 20 lb.) paper.
– Up to 460 sheets of 80 g/m
2 (21 lb.) paper.
– Up to 400 sheets of 90 g/m2 (24 lb.) paper.
LThe unit is set for...

1. Introduction and Installation
18
For assistance, please visit http://www.panasonic.com/consumersupport
2Before inserting a stack of paper, fan the 
paper to prevent paper jams.
3Insert the paper, print-side down (1).
4Adjust the width of the guides (1) to the size 
of the recording paper.
LThe paper should not be over the tabs 
(2).
LIf the paper is not inserted correctly, re-
adjust the paper, or the paper may jam.
1.8.3 Checking the amount of 
remaining recording paper
The paper level indicator...