Panasonic Digital Imaging System For Facsimile And Internet Fax Email Dp 190 Operating Instructions

171
Problem Solving
436/490Received data has too many errors.Check with the other party.--
456• Unit received a confidential document or was 
requested to be polled of a confidential document 
under any of following conditions.
1.  Not enough space in memory to receive the 
confidential document.
2. Confidential Mailbox is full.
3. While printing received document.
• Unit was requested to relay a document.
1.  Print a File List and check the contents.
2.  Wait until unit finishes printing.98
492/493/...

172
715TCP/IP connection timed out.Check the Internet Fax Parameter settings. 
Verify the IP Address, Default Gateway IP 
Address, SMTP Server IP Address.--
716Cannot logon to the designated SMTP Server.Check the SMTP Server IP Address setting. 
Contact the Network Administrator.--
717Incomplete SMTP Protocol transmission. SMTP 
Server’s hard disk may be full.SMTP Server is defective. 
Contact the Network Administrator.
--
718Page Memory Overflow occurred while receiving 
printing data. The paper size...

173
Problem SolvingNOTE1. After identifying the problem and verifying the recommended action, if the Information Codes 
keep reoccuring or for help on Information Codes that appear on your machine but are not 
listed above, please contact your local Panasonic Authorized Dealer.
 
For mechanical failures, see the Troubleshooting section in the Operating Instructions (For 
Copy & Network Scan Functions).
800/814/
816/825Unit was requested to relay a document or 
Confidential Communication but has no...

174
Problem Solving
Email ABBR Programming Errors
QError Message Sent to the Sender
Error messages that are emailed from your machine to the original sender during remote programming of 
the Auto Dialer via email.
Error MessagePossible Cause / Action
1554 Data transfer error (broken header)The header or sub header decoding is being processed while the 
message finished, try again.
2554 Data transfer error (broken data)Multiple contents are present and being processed while the 
message finished, try...

175
Problem Solving
QInternet Fax Return Receipt Error Messages
Error messages that are printed on the Internet Fax Return Receipt when remote programming of the Auto 
Dialer via email fails.
Error MessagePossible Cause
1Format Error : The block termination command “@end” is missing in the 
“@command” block, add the “@end” command and try again.
2Format Error: The block start command “@begin” is missing in the “@begin” block, 
add the “@begin” command and try again.
3Format Error :  The block termination...

176
Problem Solving
Verification Stamp and Flash Memory Card
QVerification Stamp
The Verification Stamp contains ink. When the stamp mark appears faded or hard to see, the stamp should be replaced or 
refilled with ink.
To remove the stamp
QInstalling the Flash Memory Card
Before installing, make sure that there is no document file(s) stored in the memory. You may confirm by printing out a File 
List (see page 
98). When the memory card is installed, the machine will initialize the document memory, all...

177
Problem Solving
NOTE3. The document(s) stored in memory will be lost if the memory card is removed.
Open the Stamp Holder.
3
4
5
Close the 
ADF.
6
Close the Stamp Holder and 
reattach the Scanning Pad.
Note:When closing the 
Stamp Holder, close 
gently by pressing 
both latches.1
2
3
Plug in the Power Cord and turn the 
Power Switch ON. Print out the Fax 
Parameter List (see page 166) and 
confirm that the memory size on Fax 
Parameter No. 99. (See page 142) 

178
Appendix
Specifications
[For G3 Facsimile]
CompatibilityITU-T Group 3
Coding SchemeJBIG, MH, MR, MMR (Conforms to ITU-T Recommendations)
Modem TypeITU-T V.34, V.17, V.29, V.27 ter and V.21 
Modem Speed33600 - 2400 bps
Document SizeA5 - Letter/A4
Max : Platen Glass :   Letter/A4
  ADF :   8.5 x 78.7 (216 x 2000 mm)
       (with operators assistance)
Min : Platen Glass :   No Minimum
  ADF  :   5.5 x 8.5 (Invoice)
Scanning MethodSheet Feeding with CCD type image sensor
Effective Scanning Width8.3 (212...

179Appendix
[For Email (Internet Fax)]
[Options and Supplies]
Standard Compliance10Base-T Ethernet (IEEE 802.3), 100Base-TX Fast Ethernet (IEEE802.3u)
Connector Interfaces10/100 Base-TX port: RJ-45
Compatibility IETF RFC 2305, ITU-T T.37
Communication ProtocolTCP/IP, SMTP, POP3, MIME
File FormatTIFF [IETF RFC 2301 Profile S, F, J]
PDF (Transmission only)
JPEG (Transmission only)
Email Receiving WidthMaximum Letter/A4 size
Part NamePart No.Remarks
Handset KitUE-403171Telephone Handset Kit 
Verification...

180
Appendix
FCC Notice for Users in USA
WARNING!
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to 
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful 
interference in a residential installation. This equipment generates, uses and can radiate radio frequency 
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to 
radio communications....