Panasonic Cpc+AII/B Digital Business System Release Notes Manual

Section 300~InstallationChapter 5. Peripheral Equipment
Figure S-13. Extension cord connection to the VAVBK R G Y
CNl on
ZfetiYE,+++J,
Rxt2
6.Install the cover on the VAU.
A nnnrmreIJnif WA 11)insta&tion
in.DBS-70-300
DBS Manual - Issued 8/l/955-25 

Chapter 5. Peripheral EquipmentSection 3004nstallation
Recording and Playing Messages
You can record the VAU messages from either an extension or a trunk.
Notes: You must use a DTMF telephone to record and play VAU
messages. To change existing messages, record over them.
To record and play messages, complete the following steps.
1.Do one of the following:
If...Then. . .
You are recording or piay-Take your phone off hook.
ing from an extension
Dial the VAU extension number. 
(If the intercom is set for...

Section 300~InstallationChapter 5. Peripheral Equipment
Door Box Adaptor (Trunk Port)
Guidelines
There are two types of door phone adaptors available for the DBS. The first
type (VB-43701) utilizes a trunk connection to connect to the door box and is
described below. The second type (VB-437 11) utilizes a digital port extension
to connect to the door box and door opener. See“Door Box Adaptor
(Extension Port)” on page 5-31 for more information.
Each Door Box Adaptor (VB-43701) can be used to connect one...

Chapter 5. Peripheral Equipment
Section 300~Installation
Requirements
lTrunks used for Door Boxes and openers must be set up as dial pulse
trunks.
lEquipment combinations used with the Door Box Adaptor require the
number of trunks in the following table:Ifyouuse...
The adaptor usesI
1 sensor and 1 Door Box/opener1 2 trunks
1 sensor and 2 Door Boxes/open-2 trunks
ers
1 sensor
1 Door Box/opener
ltrunkltrunk
lThe following tools are required to install the Door Box Adaptor:
- Phillips screwdriver
-...

Section 300~installationChapter 5. Peripheral Equipment
Figure S-15. Cable punch-out plate
.
boor Box Adaptor
4.Mount the Door Box Adaptor on the wall using the three screws provided
with the unit.
5.Connect the trunk line(s) to the Door Box Adaptor, as shown in Figure 5-
16.
The “COD’ connector is used for the Door Box and opener. The “C0.S”
connector is used for the sensor.
6.Connect the Door Box, door opener, and sensor to the Door Box Adaptor.DBS-70-300DBS Manual 
- Issued 8/l/955-29 

Chapter 5. Peripheral EquipmentSection 300~Installation
Dip SW
345
ONOFF OFF
ON
OFFOff
ONOFF ! OFFDoor OpenerDip SW
Operation Time 
6 , / 8 ’1 
SetONOFF OFF
3 
SetONOFF /OFF5 
setIi ON
OFF 1 Off 1I
i
Figure 5-16. Installation of the door box, door opener, and door sensorDoor Box Aaaptor W-43701)
Contact Ratings for
Opener 1 and 2:
120V AC: 0.3 amps30V DC: 1 amp
tiensor ul-A
looodSensor
Door Opener 1
Door Box 1DBS 40DBS 
72iDBS 96
5-300% Manual - Issued 8/l/95DBS-70-300 

Section 300~InstallationChapter 5. Peripheral Equipment
Door Box Adaptor (Extension Port)
Note: There are two types of door phone adaptors available for the DBS. The
first type (VB-43701) utilizes a trunk connection to connect 
to the door box.
See “Door Box Adaptor (Trunk Port)” on page 5-27 for more information.
The second type (VB-43711) utilizes a digital port extension to connect to the
door box and door opener and is described below.
Guidelines
lThe Door Box Adaptor (VB-43711) requires a door...

Chapter 5. Peripheral EquipmentSection 300~Installation
Figure 5-18. Installan’on of the door box, door openerTo Door Box
Hand OOOr Opener
Door Box Adaptor(‘B-4277 1)
Contact Ratings for
Opener
120V AC: 0.3 amps
30V DC: 1 amp
4.Connect the extension line to the Door Box Adaptor, as shown in Figure
5-19.
5-32DBS Manual - Issued 8/l/95DBS-70-300 

Section 300~InstallationChapter 5. Peripheral Equipment
Figure j-19. Cordons to the Door Box A&ptor
1
DoorDoor
60x Opener
To
Ext Port
Door BoxDoor Opener
5.Connect the Door Box and door opener to the Door Box Adaptor.
DBS-70-300DBS Manual - Issued 8/l/955-33 

Chapter 5. Peripheral EquipmentSection 3004nstallatlon
Single Line Telephone Adaptor
Guidelinesl
The Single Line Telephone Adaptor (SLTA. VB-43709) provides an
alternative way of connecting analog DTMF telephones (2500 sets). One
SLTA supports up to 4 Single Line Telephones.
.Each SLT extension requires a digital extension port connection to the
SLTA.
1.Remove the cover from the SLTA.
2.Remove the cable punch-out plate (Figure 5-20) to make an opening for
the cables coming into the SLTA.
To remove the...