Panasonic Color Cctv Camera Wv Cw864 Operating Instructions

52
Unit Number
Switch 1, an 8-bit DIP switch, specifies the unit number or
restores the factory default settings when using the Panasonic
protocol.
When the switch position corresponding to the unit number 1-
96* is selected, setting should be made on the RS485 SET UP
menu (see page 47).
1234 ON5678
SW1
8-bit DIP SW
For Panasonic’s Protocol
1234 ON5678
Switch positionUnit
number
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234...

53
1234 ON5678
Switch positionUnit
number
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
Switch positionUnit
numberSwitch positionUnit
number
69
70
71
72
73
74
75
76
7778
79
80
81
82
83
84
85
8687
88
89
90
91
92
93
94
951234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678
1234 ON5678 

54
(2) Be sure to hook the fall prevention wire
into the bracket.
(3) Fix the camera to the upper base.
•Move the camera up so that its
guide pins fit into the guide holes of
the upper base.
•Turn the camera counter-clockwise
to the end, viewed from the bottom.
•Fasten 3 screws. Full duplex (4 line) 
*
BP 2
BP 1 Function
Switch
position
Function
Switch
position
RS485 Setting
The 4-bit DIP switch is used for
RS485 termination.
ON
OFFTermination ON
Termination OFF *
1234 ON
SW2
4-bit DIP SW
BP 3 BP 4
ON ON...

55
How to Assemble the Cable with the
Accessory Connector
Strip back the cable jacket approx. 3 mm (0.1
inch) and separate the individual conductors.
Recommended wire gauge sizes for 24 V AC line
#24
(0.22mm2) Copper wire size
(AWG)
Length
of cable
(approx.)(m)
(ft)#22
(0.33mm2)#20
(0.52mm2)#18
(0.83mm2)
20 30 45 75
65 100 160 260
Accessory Connector Information
Pin no. Power source
1
2
3
424 V AC LIVE
24 V AC NEUTRAL
Ground
Not use
ContactUp
Wire
Prepare the individual conductors for clamping.
Use MOLEX...

56
Gray
White
Pink
Yellow green or light blue Black
Brown
Red
Orange
Yellow
Light blue or green
Blue
PurpleWire color
Wire color
•RS485 Connection
Note:
Use the cable that is described below for RS485 site communication.
•Shielded, twisted pair cable
•Low impedance
•Wire gauge size is thicker than AWG #22 (0.33 mm
2).
•ALARM IN Connections
An 8-pin and a 4-pin harness are supplied with the camera as standard accessories. Connect exter-
nal sensors to this connector. Input specifications are low-active,...

57
Note:When any peripheral is turned off and turned on again, the camera is also turned off and turned
back on.
SYSTEM CONNECTIONS
123456789MO NCAM
ESC SET0ACK
RESETBACK
SEQFORWARD
SEQ ALTDEC
–1CAMINC
+1CAM STOP12AUXCLOSE OPENIRISPRESETFOCUS
NEAR ZOOM
TELE
FAR WIDESystem Controller WV-CU550550BLEFT RIGHTUP
DOWN
ALARMBUSYF3F4F2F1AF123456789MO NCAM
ESC SET0ACK
RESETBACK
SEQFORWARD
SEQ ALTDEC
–1CAMINC
+1CAM STOP12AUXCLOSE OPENIRISPRESETFOCUS
NEAR ZOOM
TELE
FAR WIDESystem Controller WV-CU550550BLEFT...

58
Zoom ratio
 




Bright object
SmearWhen the camera is aimed at a bright light, such
as a spotlight, or a surface that reflects bright
light, smear or blooming may appear. Therefore,
the camera should be operated carefully in the
vicinity of extremely bright objects to avoid
smear or blooming.
SPECIFICATIONS
PREVENTION OF BLOOMING AND SMEAR
Power source3.65 mm (H) x 2.74 mm (V), 1/4” 768 (H) x 494 (V)
Dimensions Focus speed  Effective pixels
15.734 kHz
F1.6 to 22, CLOSE Focal length
BLC
24 V AC, 60...

59
Controls Panning range
Weights and dimensions indicated are approximate.
Specifications are subject to change without notice.360° endless
possible (in auto-pan mode)
manual/sequential position/sort position/auto pan
manual : approx. 0.1 °/s to 120 °/s 8-steps/64-steps
sequence position : maximum approx. 300 °/s
0° to 180°
manual/sequential position/sort position
manual : approx. 0.1 °/s to 120 °/s. 8-steps/64-steps
sequential position : maximum approx. 300 °/s
pan/tilt, lens, 64 preset positions, home...

60
Selecting a PRESET position From #1 to #64
#1 [1] + [CAM FUNC]
#10 [1] + [0] + [CAM FUNC]
#64 [6] + [4] + [CAM FUNC]
AUTO PAN
ON [6] + [5] + [CAM FUNC]
OFF [6] + [6] + [CAM FUNC]
Speed Up [6] + [7] + [CAM FUNC]
Speed Down [6] + [8] + [CAM FUNC]
Setting Start Point [6] + [9] + [CAM FUNC]
Setting End Point [7] + [0] + [CAM FUNC]
Setting PAN Reverse [7] + [4] + [CAM FUNC]
AUTO MODE
MODE Off [7] + [1] + [CAM FUNC]
SEQ On [7] + [2] + [CAM FUNC]
SORT On [7] + [3] + [CAM FUNC]
ENDLESS PAN
On [7] + [6] + [CAM...

N0202-1032 V8QA5996BN Printed in Japan
Imprimé au Japon 2002 © Matsushita Communication Industrial Co., Ltd.  All rights reserved.
Panasonic Canada Inc.5770 Ambler Drive, Mississauga,
Ontario, L4W 2T3 Canada (905)624-5010
Panasonic Sales Company
Division of Matsushita Electricof Puerto Rico Inc.
Ave. 65 de Infanteria. Km. 9.5
San Gabriel Industrial Park, Carolina,
Puerto Rico 00985 (809)750-4300
Panasonic Security and Digital Imaging Company
A Division of Matsushita Electric Corporation of America...