Panasonic AY-RP500 Installation Manual

39
To use the system, the application program on the CD-
ROM supplied with the software package must be
installed on the hard disk.  This requires a keyboard,
mouse, and personal computer monitor.
nSetting Up the Virtual Memory
This procedure sets up the virtual memory to operate the
application program.
DVEdit Setting
Drive C: Initial Size 300MB
Maximum Size 400MB
Do not expand the virtual memory in a wrong drive.
Otherwise it is not assured that the DVEdit works
properly.
1. Open the Control Panel.2....

40
4. Click C: .
5. Enter 300 in the box for initial size and 400 in the box
for maximum size. 6. Click the  button.
Confirm that the top window shows 300-400.  Then,
click  on this panel.
7. Click and restart.
Yes
OK
Set 

41
nInstall an Application Program
1. Connect the keyboard, mouse, and personal com-
puter monitor to the personal computer, and turn on
the power switches on the peripheral equipment and
then on the personal computer.  Windows NT starts
up.
2. Insert the CD-ROM supplied with the software pack-
age into the CD-ROM drive.
3. Click .
Click Run on the start menu.  The Run window
now opens.
4. Input CD-ROM drive name:\dvedit\disk1\setup.exe
in Open: and click  .  If, for instance, the CD-
ROM drive is drive...

42
12. The Black Level Information  window appears.
Select the setup level to be used and click  .
(When the setup level is selected,     is displayed.)
13. The DVEdit JOGPAD board Information window
appears.
Set the I/O address of the JOG board to be used.
Select the value of the jumper setting of the JOG
board, and click   . (When the value is selected,
is displayed.) (The default is 230H)
14. The DVEdit JOGPAD board Information window is
still displayed.
Set the IRQ No. of the JOG board to be used....

43
This manual describes the procedures for upgrading
DVEdit to the newest software.  
Observe the following procedures to correctly replace
the existing software.
After replacing the Targa driver, be sure to replace, or
write over, the existing software.  
Otherwise, normal operation cannot be expected.
nPrecautions for Version-up
lTarga Driver
The new Targa driver cannot be written over the old
driver to upgrade the version.  First, remove the old
driver from DVEdit by uninstalling, then install the...

44
(b) DVEdit software version
The DVEdit version panel appears when the About
menu on the Special panel is clicked.
3. Confirming the CD-ROM Version
The version of the newest software written on the CD-
ROM is written in d:¥version.txt in the CD-ROM drive.
(The case where the CD-ROM drive is d:¥ is described
below.) 
Compare the version of the Targa driver and that of the
DVEdit software.  If they are the same, neither needs to
be replaced.  If the Targa driver version is the same, skip
items 3 and 4...

45
(d) If the following message appears during uninstall,
click .
( e ) Check disk scheduling
Enter chkdsk /f c: on the command prompt panel.
After that, You will be asked Checkdisk
scheduling(Y/N)?
So enter y on the command prompt panel. 
This executes the check-disk in restarting. 
( f ) Restart. (The check- disk automatically runs at restart.)
Select Shutdown from Start.
Add a check mark to Restart Computer and click
.
(g ) Directory delete
If c:¥TARGA2KDV and subsequent directories remain
in Explorer...

46
( d ) Click  in Display Type. 
( e ) Click  in Display Modification.
( f ) The directory of the display driver is to be opened,
so enter
C:¥TARGA2KDV¥WINNT¥Display and click  .
( g ) Confirm that Truevision DVR Display is displayed
on the screen and click  .
( h ) The message The drivers were successfully
installed appears.  Click  .
( i ) Click  in Display Types
( j ) Click  in Screen Properties
( k ) The message You must restart your computer
888
appears.  Click  .
( l ) Windows NT starts up.  When...

47
(b) Restart
Select Shutdown from Start.
Add a check mark to Restart Computer and click
.
( c ) Directory Delete
If c:¥DVEdit and subsequent directories remain in
Explorer after restart, delete all the files together with
the directories.  If e:¥audio, e:¥Title and subsequent
directories remain, similarly delete all the files
together with the directories. (The audio-storing drive
characters may be different and there may be two or
more audio/title storing drives depending on the
case.  In such a case,...

48
(b) DVEdit software version
The DVEdit version panel appears when the About
menu on the Special panel is clicked.
3. Confirming the CD-ROM version
The version of the newest software written on the CD-
ROM is written in d:¥version.txt in the CD-ROM drive.
(The case where the CD-ROM drive is d:¥ is described
below.) 
Compare the version of the Targa driver and that of the
DVEdit software.  If they are the same, neither needs to
be replaced.  If the Targa driver version is the same, skip
items 4 and 5...