Home > NEC > Communications System > NEC Neax 2400 Imx Circuit Card Manual

NEC Neax 2400 Imx Circuit Card Manual

Here you can view all the pages of manual NEC Neax 2400 Imx Circuit Card Manual. The NEC manuals for Communications System are available online for free. You can easily download all the documents as PDF.

Page 261

CHAPTER 3 ND-70182 (E)
Page 246
Revision 4.0
PA-16LCBY
Line Circuit
SWITCH SETTING SHEET
MODULE SLOT No. SWITCH NAME SWITCH SHAPE REMARKS
PIMSW00
(MB)Note:Normal operating mode is down.
SW10
(BNW0-7)
SW11
(BNW8-15)
SW14
SW15
SW16
SW17
SW19
ON
1   2   3   4   5   6    7  8ON
1   2   3   4   5   6    7  8ON
 1   2   3   4ON
 1   2   3   4ON
 1   2   3   4ON
 1   2   3   4ON
 1   2   3   4ON 

Page 262

ND-70182 (E) CHAPTER 3
Page 247
Revision 4.0
PA-16LCBY
Line Circuit
6. External Interface
Accommodation of the LT connector leads for this circuit card is shown below.
When this circuit card is mounted in PIM, necessary leads appear on the LT connectors as follows.
Figure 3-52   LT Connector Lead Accommodation (PIM) (1/2)
26272829303132333435363738394041
1234567891011121314151642434445464748
1718192021222349502425
232221201918171615141312111009080706050403020100
LT6 LT7 LT8 LT9 LT10 LT11LT0 LT1 LT2 LT3...

Page 263

CHAPTER 3 ND-70182 (E)
Page 248
Revision 4.0
PA-16LCBY
Line Circuit
 
Figure 3-52   LT Connector Lead Accommodation (PIM) (2/2)
26272829303132333435363738394041
1234567891011121314151642434445464748
1718192021222349502425
232221201918171615141312111009080706050403020100
LT6 LT7 LT8 LT9 LT10 LT11LT0 LT1 LT2 LT3 LT4 LT5
23 19 15
22 18 14
21 17 13
20 16 1223 19 15
22 18 14
21 17 13
20 16 12 11 09 07 05 03 01
10 08 06 04 02 00 11 09 07 05 03 01
10 08 06 04 02 00
HW11 HW10 HW9 HW8 HW7 HW6 HW5 HW4 HW3 HW2 HW1...

Page 264

ND-70182 (E) CHAPTER 3
Page 249
Revision 4.0
PA-16LCBY
7. Connecting Route Diagram
Figure 3-53   Connecting Route Diagram
A
BL1
L2
PBXMDF
Jack Analog Terminal
LC
Maximum 1200 [W] (inclusive of terminal resistance)
Installation Cable
LT Connector
Connecting Route Diagram for the PA-16 LCBY (LC) is as follows. 

Page 265

CHAPTER 3 ND-70182 (E)
Page 250
Revision 4.0
PA - 1 6 E L C J
Electric Line Current
PA - 1 6 E L C J
Electric Line Current
1. General Function
The PA-16ELCJ (ELC) circuit card provides an interface between the D
term and the IMX. Depending on
the switch settings, this card works in the following two modes.
16 ELC mode: A maximum of 16 sets of D
terms can be connected to this card (voice communications
only).
8 DLC mode: A maximum of 8 sets of D
terms can be connected to this card (simultaneous voice...

Page 266

ND-70182 (E) CHAPTER 3
Page 251
Revision 4.0
PA - 1 6 E L C J
Electric Line Current
2. Mounting Location/Condition
The PA-16ELCJ (ELC) card can be mounted in any universal slot as shown below.
3. Face Layout of Lamps, Switches, and Connectors
The face layout of lamps, switches, and connectors on this circuit card is shown in Figure 3-55.
Figure 3-55   Face Layout of PA-16ELCJ (ELC) Card 00 01 02 03 04 05 06 07 08 09 10 11 12 13 14 15 16 17 18 19 20 21 22 23
Mounting ModulePIM
PALM SW00 (MB)
BL15
OPE
BL0...

Page 267

CHAPTER 3 ND-70182 (E)
Page 252
Revision 4.0
PA - 1 6 E L C J
Electric Line Current
4. Lamp Indications
Lamp indications for this circuit card are shown in the table below.
Note:When the PALM lamp lights red, observe the following instructions. 
i) Identify the location where any in-house wires have a short circuit in all lines which belong to the PA-
16ELCJ card whose PALM is on. 
ii) Repair the short-circuited wires of the associated D
term.
iii) Disconnect the D
term from the rosette, then leave it...

Page 268

ND-70182 (E) CHAPTER 3
Page 253
Revision 4.0
PA - 1 6 E L C J
Electric Line Current
5. Switch Settings
Switches on the PA-16ELCJ card have the following meanings. 
SWITCH FUNCTION SWITCH SETTING MEANING
SW00 (MB)
Circuit Card 
Make-busy keyCircuit card Make-busy Cancel.
Circuit card Make-busy.
SW011
 
See Ta b l e  3 - 2 below.
—Always ON (fixed).
7ELC/DLC 
mode 
Designation16ELC mode.
8DLC mode.
Table 3-2 Relationship between SW01-1 and SW01-7
ON OFF
ON16 sets of D
terms per card.
Voice Communication...

Page 269

CHAPTER 3 ND-70182 (E)
Page 254
Revision 4.0
PA - 1 6 E L C J
Electric Line Current
6. External Interface
Depending on the applied mode (16ELC/8 DLC mode), external interface leads appear on the LT
connectors as follows.
6ELC mode
Figure 3-56   LT Connector Lead Location (16ELC Mode)
Mounting ModulePIM
26272829303132333435363738394041
1234567891011121314151642434445464748
1718192021222349502425
232221201918171615141312111009080706050403020100
LT6 LT7 LT8 LT9 LT10 LT11LT0 LT1 LT2 LT3 LT4 LT5
23 19 15
22...

Page 270

ND-70182 (E) CHAPTER 3
Page 255
Revision 4.0
PA - 1 6 E L C J
Electric Line Current
16ELC mode
Figure 3-57   LT Connector Lead Location (16ELC Mode)
Mounting ModulePIM
26272829303132333435363738394041
1234567891011121314151642434445464748
1718192021222349502425
232221201918171615141312111009080706050403020100
LT6 LT7 LT8 LT9 LT10 LT11LT0 LT1 LT2 LT3 LT4 LT5
23 19 15
22 18 14
21 17 13
20 16 1223 19 15
22 18 14
21 17 13
20 16 12 11 09 07 05 03 01
10 08 06 04 02 00 11 09 07 05 03 01
10 08 06 04 02 00
Group...
Start reading NEC Neax 2400 Imx Circuit Card Manual

Related Manuals for NEC Neax 2400 Imx Circuit Card Manual

All NEC manuals